| lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
|
Open Source and information security mailing list archives
| ||
|
Message-Id: <20190119204252.18370-8-masneyb@onstation.org>
Date: Sat, 19 Jan 2019 15:42:44 -0500
From: Brian Masney <masneyb@...tation.org>
To: linus.walleij@...aro.org, sboyd@...nel.org,
bjorn.andersson@...aro.org, andy.gross@...aro.org,
marc.zyngier@....com
Cc: shawnguo@...nel.org, dianders@...omium.org,
linux-gpio@...r.kernel.org, nicolas.dechesne@...aro.org,
niklas.cassel@...aro.org, david.brown@...aro.org,
robh+dt@...nel.org, mark.rutland@....com, thierry.reding@...il.com,
linux-arm-msm@...r.kernel.org, linux-kernel@...r.kernel.org,
devicetree@...r.kernel.org
Subject: [PATCH v6 07/15] qcom: spmi-gpio: add support for hierarchical IRQ chip
spmi-gpio did not have any irqchip support so consumers of this in
device tree would need to call gpio[d]_to_irq() in order to get the
proper IRQ on the underlying PMIC. IRQ chips in device tree should
be usable from the start without the consumer having to make an
additional call to get the proper IRQ on the parent. This patch adds
hierarchical IRQ chip support to the spmi-gpio code to correct this
issue.
Driver was tested using the volume buttons (via gpio-keys) on the LG
Nexus 5 (hammerhead) phone with the following two configurations.
volume-up {
interrupts-extended = <&pm8941_gpios 2 IRQ_TYPE_EDGE_BOTH>;
...
};
volume-up {
gpios = <&pm8941_gpios 2 GPIO_ACTIVE_LOW>;
...
};
Both configurations now show that spmi-gpio is the IRQ domain and that
the IRQ is setup in a hierarchy.
$ grep volume_up /proc/interrupts
72: 6 0 spmi-gpio 1 Edge volume_up
$ cat /sys/kernel/debug/irq/irqs/72
handler: handle_edge_irq
device: (null)
status: 0x00000403
_IRQ_NOPROBE
istate: 0x00000000
ddepth: 0
wdepth: 0
dstate: 0x02400203
IRQ_TYPE_EDGE_RISING
IRQ_TYPE_EDGE_FALLING
IRQD_ACTIVATED
IRQD_IRQ_STARTED
node: 0
affinity: 0-3
effectiv:
domain: :soc:spmi@...cf000:pm8941@0:gpios@...0
hwirq: 0x1
chip: spmi-gpio
flags: 0x4
IRQCHIP_MASK_ON_SUSPEND
parent:
domain: :soc:spmi@...cf000
hwirq: 0xc100057
chip: pmic_arb
flags: 0x4
IRQCHIP_MASK_ON_SUSPEND
Signed-off-by: Brian Masney <masneyb@...tation.org>
Reviewed-by: Stephen Boyd <sboyd@...nel.org>
---
Changes since v5:
- Change IRQ_TYPE_NONE to IRQ_TYPE_EDGE_RISING
Changes since v4:
- None
Changes since v3:
- None
Changes since v2:
- Use PMIC_GPIO_PHYSICAL_OFFSET instead of the 1 constant
- Use gpiochip_irq_domain_{activate,deactivate}
- Changed 'fwspec->param[0] + 0xc0 - 1' to 'hwirq + c0' in call to
irq_domain_alloc_irqs_parent
Changes since v1:
- Use two cells for interrupts instead of four.
- Pin numbers in interrupts-extended are now one based instead of zero
based so that they match the GPIO pin number.
- Drop unnecessary parenthesis in pmic_gpio_domain_translate
- Add missing of_node_put()
- Remove irq field from pmic_gpio_pad struct that is no longer
necessary.
drivers/pinctrl/qcom/pinctrl-spmi-gpio.c | 115 +++++++++++++++++++++--
1 file changed, 105 insertions(+), 10 deletions(-)
diff --git a/drivers/pinctrl/qcom/pinctrl-spmi-gpio.c b/drivers/pinctrl/qcom/pinctrl-spmi-gpio.c
index b6fa2c7dbb26..e01a556ac586 100644
--- a/drivers/pinctrl/qcom/pinctrl-spmi-gpio.c
+++ b/drivers/pinctrl/qcom/pinctrl-spmi-gpio.c
@@ -12,6 +12,7 @@
*/
#include <linux/gpio/driver.h>
+#include <linux/interrupt.h>
#include <linux/module.h>
#include <linux/of.h>
#include <linux/of_irq.h>
@@ -136,7 +137,6 @@ enum pmic_gpio_func_index {
/**
* struct pmic_gpio_pad - keep current GPIO settings
* @base: Address base in SPMI device.
- * @irq: IRQ number which this GPIO generate.
* @is_enabled: Set to false when GPIO should be put in high Z state.
* @out_value: Cached pin output value
* @have_buffer: Set to true if GPIO output could be configured in push-pull,
@@ -156,7 +156,6 @@ enum pmic_gpio_func_index {
*/
struct pmic_gpio_pad {
u16 base;
- int irq;
bool is_enabled;
bool out_value;
bool have_buffer;
@@ -179,6 +178,8 @@ struct pmic_gpio_state {
struct regmap *map;
struct pinctrl_dev *ctrl;
struct gpio_chip chip;
+ struct fwnode_handle *fwnode;
+ struct irq_domain *domain;
};
static const struct pinconf_generic_params pmic_gpio_bindings[] = {
@@ -761,11 +762,18 @@ static int pmic_gpio_of_xlate(struct gpio_chip *chip,
static int pmic_gpio_to_irq(struct gpio_chip *chip, unsigned pin)
{
struct pmic_gpio_state *state = gpiochip_get_data(chip);
- struct pmic_gpio_pad *pad;
+ struct irq_fwspec fwspec;
- pad = state->ctrl->desc->pins[pin].drv_data;
+ fwspec.fwnode = state->fwnode;
+ fwspec.param_count = 2;
+ fwspec.param[0] = pin + PMIC_GPIO_PHYSICAL_OFFSET;
+ /*
+ * Set the type to a safe value temporarily. This will be overwritten
+ * later with the proper value by irq_set_type.
+ */
+ fwspec.param[1] = IRQ_TYPE_EDGE_RISING;
- return pad->irq;
+ return irq_create_fwspec_mapping(&fwspec);
}
static void pmic_gpio_dbg_show(struct seq_file *s, struct gpio_chip *chip)
@@ -935,8 +943,78 @@ static int pmic_gpio_populate(struct pmic_gpio_state *state,
return 0;
}
+static struct irq_chip pmic_gpio_irq_chip = {
+ .name = "spmi-gpio",
+ .irq_ack = irq_chip_ack_parent,
+ .irq_mask = irq_chip_mask_parent,
+ .irq_unmask = irq_chip_unmask_parent,
+ .irq_set_type = irq_chip_set_type_parent,
+ .irq_set_wake = irq_chip_set_wake_parent,
+ .flags = IRQCHIP_MASK_ON_SUSPEND,
+};
+
+static int pmic_gpio_domain_translate(struct irq_domain *domain,
+ struct irq_fwspec *fwspec,
+ unsigned long *hwirq,
+ unsigned int *type)
+{
+ struct pmic_gpio_state *state = container_of(domain->host_data,
+ struct pmic_gpio_state,
+ chip);
+
+ if (fwspec->param_count != 2 || fwspec->param[0] >= state->chip.ngpio)
+ return -EINVAL;
+
+ *hwirq = fwspec->param[0] - PMIC_GPIO_PHYSICAL_OFFSET;
+ *type = fwspec->param[1];
+
+ return 0;
+}
+
+static int pmic_gpio_domain_alloc(struct irq_domain *domain, unsigned int virq,
+ unsigned int nr_irqs, void *data)
+{
+ struct pmic_gpio_state *state = container_of(domain->host_data,
+ struct pmic_gpio_state,
+ chip);
+ struct irq_fwspec *fwspec = data;
+ struct irq_fwspec parent_fwspec;
+ irq_hw_number_t hwirq;
+ unsigned int type;
+ int ret, i;
+
+ ret = pmic_gpio_domain_translate(domain, fwspec, &hwirq, &type);
+ if (ret)
+ return ret;
+
+ for (i = 0; i < nr_irqs; i++)
+ irq_domain_set_info(domain, virq + i, hwirq + i,
+ &pmic_gpio_irq_chip, state,
+ handle_level_irq, NULL, NULL);
+
+ parent_fwspec.fwnode = domain->parent->fwnode;
+ parent_fwspec.param_count = 4;
+ parent_fwspec.param[0] = 0;
+ parent_fwspec.param[1] = hwirq + 0xc0;
+ parent_fwspec.param[2] = 0;
+ parent_fwspec.param[3] = fwspec->param[1];
+
+ return irq_domain_alloc_irqs_parent(domain, virq, nr_irqs,
+ &parent_fwspec);
+}
+
+static const struct irq_domain_ops pmic_gpio_domain_ops = {
+ .activate = gpiochip_irq_domain_activate,
+ .alloc = pmic_gpio_domain_alloc,
+ .deactivate = gpiochip_irq_domain_deactivate,
+ .free = irq_domain_free_irqs_common,
+ .translate = pmic_gpio_domain_translate,
+};
+
static int pmic_gpio_probe(struct platform_device *pdev)
{
+ struct irq_domain *parent_domain;
+ struct device_node *parent_node;
struct device *dev = &pdev->dev;
struct pinctrl_pin_desc *pindesc;
struct pinctrl_desc *pctrldesc;
@@ -993,10 +1071,6 @@ static int pmic_gpio_probe(struct platform_device *pdev)
pindesc->number = i;
pindesc->name = pmic_gpio_groups[i];
- pad->irq = platform_get_irq(pdev, i);
- if (pad->irq < 0)
- return pad->irq;
-
pad->base = reg + i * PMIC_GPIO_ADDRESS_RANGE;
ret = pmic_gpio_populate(state, pad);
@@ -1016,10 +1090,28 @@ static int pmic_gpio_probe(struct platform_device *pdev)
if (IS_ERR(state->ctrl))
return PTR_ERR(state->ctrl);
+ parent_node = of_irq_find_parent(state->dev->of_node);
+ if (!parent_node)
+ return -ENXIO;
+
+ parent_domain = irq_find_host(parent_node);
+ of_node_put(parent_node);
+ if (!parent_domain)
+ return -ENXIO;
+
+ state->fwnode = of_node_to_fwnode(state->dev->of_node);
+ state->domain = irq_domain_create_hierarchy(parent_domain, 0,
+ state->chip.ngpio,
+ state->fwnode,
+ &pmic_gpio_domain_ops,
+ &state->chip);
+ if (!state->domain)
+ return -ENODEV;
+
ret = gpiochip_add_data(&state->chip, state);
if (ret) {
dev_err(state->dev, "can't add gpio chip\n");
- return ret;
+ goto err_chip_add_data;
}
/*
@@ -1045,6 +1137,8 @@ static int pmic_gpio_probe(struct platform_device *pdev)
err_range:
gpiochip_remove(&state->chip);
+err_chip_add_data:
+ irq_domain_remove(state->domain);
return ret;
}
@@ -1053,6 +1147,7 @@ static int pmic_gpio_remove(struct platform_device *pdev)
struct pmic_gpio_state *state = platform_get_drvdata(pdev);
gpiochip_remove(&state->chip);
+ irq_domain_remove(state->domain);
return 0;
}
--
2.17.2
Powered by blists - more mailing lists