[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]
Message-Id: <20190130084005.18649-3-jonas@norrbonn.se>
Date: Wed, 30 Jan 2019 09:40:05 +0100
From: Jonas Bonn <jonas@...rbonn.se>
To: linux-kernel@...r.kernel.org
Cc: Jonas Bonn <jonas@...rbonn.se>,
Nicolas Ferre <nicolas.ferre@...rochip.com>,
Mark Brown <broonie@...nel.org>,
Alexandre Belloni <alexandre.belloni@...tlin.com>,
Ludovic Desroches <ludovic.desroches@...rochip.com>,
linux-spi@...r.kernel.org, linux-arm-kernel@...ts.infradead.org
Subject: [PATCH v6 2/2] spi-atmel: support inter-word delay
If the SPI slave requires an inter-word delay, configure the DLYBCT
register accordingly.
Tested on a SAMA5D2 board (derived from SAMA5D2-Xplained reference
board).
Signed-off-by: Jonas Bonn <jonas@...rbonn.se>
Acked-by: Nicolas Ferre <nicolas.ferre@...rochip.com>
CC: Nicolas Ferre <nicolas.ferre@...rochip.com>
CC: Mark Brown <broonie@...nel.org>
CC: Alexandre Belloni <alexandre.belloni@...tlin.com>
CC: Ludovic Desroches <ludovic.desroches@...rochip.com>
CC: linux-spi@...r.kernel.org
CC: linux-arm-kernel@...ts.infradead.org
---
drivers/spi/spi-atmel.c | 11 ++++++-----
1 file changed, 6 insertions(+), 5 deletions(-)
diff --git a/drivers/spi/spi-atmel.c b/drivers/spi/spi-atmel.c
index f53f0c5e63da..4954f0ab1606 100644
--- a/drivers/spi/spi-atmel.c
+++ b/drivers/spi/spi-atmel.c
@@ -1201,13 +1201,14 @@ static int atmel_spi_setup(struct spi_device *spi)
csr |= SPI_BIT(CSAAT);
/* DLYBS is mostly irrelevant since we manage chipselect using GPIOs.
- *
- * DLYBCT would add delays between words, slowing down transfers.
- * It could potentially be useful to cope with DMA bottlenecks, but
- * in those cases it's probably best to just use a lower bitrate.
*/
csr |= SPI_BF(DLYBS, 0);
- csr |= SPI_BF(DLYBCT, 0);
+
+ /* DLYBCT adds delays between words. This is useful for slow devices
+ * that need a bit of time to setup the next transfer.
+ */
+ csr |= SPI_BF(DLYBCT,
+ (as->spi_clk / 1000000 * spi->word_delay_usecs) >> 5);
asd = spi->controller_state;
if (!asd) {
--
2.19.1
Powered by blists - more mailing lists