| lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
|
Open Source and information security mailing list archives
| ||
|
Message-Id: <20190201094736.32057-9-brgl@bgdev.pl>
Date: Fri, 1 Feb 2019 10:47:33 +0100
From: Bartosz Golaszewski <brgl@...ev.pl>
To: Rob Herring <robh+dt@...nel.org>,
Mark Rutland <mark.rutland@....com>,
Linus Walleij <linus.walleij@...aro.org>,
Dmitry Torokhov <dmitry.torokhov@...il.com>,
Jacek Anaszewski <jacek.anaszewski@...il.com>,
Pavel Machek <pavel@....cz>, Lee Jones <lee.jones@...aro.org>,
Sebastian Reichel <sre@...nel.org>,
Liam Girdwood <lgirdwood@...il.com>,
Greg Kroah-Hartman <gregkh@...uxfoundation.org>
Cc: linux-kernel@...r.kernel.org, linux-gpio@...r.kernel.org,
devicetree@...r.kernel.org, linux-input@...r.kernel.org,
linux-leds@...r.kernel.org, linux-pm@...r.kernel.org,
Bartosz Golaszewski <bgolaszewski@...libre.com>
Subject: [PATCH v3 08/11] gpio: max77650: add GPIO support
From: Bartosz Golaszewski <bgolaszewski@...libre.com>
Add GPIO support for max77650 mfd device. This PMIC exposes a single
GPIO line.
Signed-off-by: Bartosz Golaszewski <bgolaszewski@...libre.com>
---
drivers/gpio/Kconfig | 7 ++
drivers/gpio/Makefile | 1 +
drivers/gpio/gpio-max77650.c | 189 +++++++++++++++++++++++++++++++++++
3 files changed, 197 insertions(+)
create mode 100644 drivers/gpio/gpio-max77650.c
diff --git a/drivers/gpio/Kconfig b/drivers/gpio/Kconfig
index b5a2845347ec..fb297fe5bfec 100644
--- a/drivers/gpio/Kconfig
+++ b/drivers/gpio/Kconfig
@@ -1095,6 +1095,13 @@ config GPIO_MAX77620
driver also provides interrupt support for each of the gpios.
Say yes here to enable the max77620 to be used as gpio controller.
+config GPIO_MAX77650
+ tristate "Maxim MAX77650/77651 GPIO support"
+ depends on MFD_MAX77650
+ help
+ GPIO driver for MAX77650/77651 PMIC from Maxim Semiconductor.
+ These chips have a single pin that can be configured as GPIO.
+
config GPIO_MSIC
bool "Intel MSIC mixed signal gpio support"
depends on (X86 || COMPILE_TEST) && MFD_INTEL_MSIC
diff --git a/drivers/gpio/Makefile b/drivers/gpio/Makefile
index 37628f8dbf70..8bdad50db822 100644
--- a/drivers/gpio/Makefile
+++ b/drivers/gpio/Makefile
@@ -78,6 +78,7 @@ obj-$(CONFIG_GPIO_MAX7300) += gpio-max7300.o
obj-$(CONFIG_GPIO_MAX7301) += gpio-max7301.o
obj-$(CONFIG_GPIO_MAX732X) += gpio-max732x.o
obj-$(CONFIG_GPIO_MAX77620) += gpio-max77620.o
+obj-$(CONFIG_GPIO_MAX77650) += gpio-max77650.o
obj-$(CONFIG_GPIO_MB86S7X) += gpio-mb86s7x.o
obj-$(CONFIG_GPIO_MENZ127) += gpio-menz127.o
obj-$(CONFIG_GPIO_MERRIFIELD) += gpio-merrifield.o
diff --git a/drivers/gpio/gpio-max77650.c b/drivers/gpio/gpio-max77650.c
new file mode 100644
index 000000000000..8382dd85c548
--- /dev/null
+++ b/drivers/gpio/gpio-max77650.c
@@ -0,0 +1,189 @@
+// SPDX-License-Identifier: GPL-2.0
+//
+// Copyright (C) 2018 BayLibre SAS
+// Author: Bartosz Golaszewski <bgolaszewski@...libre.com>
+//
+// GPIO driver for MAXIM 77650/77651 charger/power-supply.
+
+#include <linux/gpio/driver.h>
+#include <linux/i2c.h>
+#include <linux/mfd/max77650.h>
+#include <linux/module.h>
+#include <linux/platform_device.h>
+#include <linux/regmap.h>
+
+#define MAX77650_GPIO_DIR_MASK BIT(0)
+#define MAX77650_GPIO_INVAL_MASK BIT(1)
+#define MAX77650_GPIO_DRV_MASK BIT(2)
+#define MAX77650_GPIO_OUTVAL_MASK BIT(3)
+#define MAX77650_GPIO_DEBOUNCE_MASK BIT(4)
+
+#define MAX77650_GPIO_DIR_OUT 0x00
+#define MAX77650_GPIO_DIR_IN BIT(0)
+#define MAX77650_GPIO_OUT_LOW 0x00
+#define MAX77650_GPIO_OUT_HIGH BIT(3)
+#define MAX77650_GPIO_DRV_OPEN_DRAIN 0x00
+#define MAX77650_GPIO_DRV_PUSH_PULL BIT(2)
+#define MAX77650_GPIO_DEBOUNCE BIT(4)
+
+#define MAX77650_GPIO_DIR_BITS(_reg) \
+ ((_reg) & MAX77650_GPIO_DIR_MASK)
+#define MAX77650_GPIO_INVAL_BITS(_reg) \
+ (((_reg) & MAX77650_GPIO_INVAL_MASK) >> 1)
+
+struct max77650_gpio_chip {
+ struct regmap *map;
+ struct gpio_chip gc;
+};
+
+static int max77650_gpio_direction_input(struct gpio_chip *gc,
+ unsigned int offset)
+{
+ struct max77650_gpio_chip *chip = gpiochip_get_data(gc);
+
+ return regmap_update_bits(chip->map,
+ MAX77650_REG_CNFG_GPIO,
+ MAX77650_GPIO_DIR_MASK,
+ MAX77650_GPIO_DIR_IN);
+}
+
+static int max77650_gpio_direction_output(struct gpio_chip *gc,
+ unsigned int offset, int value)
+{
+ struct max77650_gpio_chip *chip = gpiochip_get_data(gc);
+ int mask, regval;
+
+ mask = MAX77650_GPIO_DIR_MASK | MAX77650_GPIO_OUTVAL_MASK;
+ regval = value ? MAX77650_GPIO_OUT_HIGH : MAX77650_GPIO_OUT_LOW;
+ regval |= MAX77650_GPIO_DIR_OUT;
+
+ return regmap_update_bits(chip->map,
+ MAX77650_REG_CNFG_GPIO, mask, regval);
+}
+
+static void max77650_gpio_set_value(struct gpio_chip *gc,
+ unsigned int offset, int value)
+{
+ struct max77650_gpio_chip *chip = gpiochip_get_data(gc);
+ int rv, regval;
+
+ regval = value ? MAX77650_GPIO_OUT_HIGH : MAX77650_GPIO_OUT_LOW;
+
+ rv = regmap_update_bits(chip->map, MAX77650_REG_CNFG_GPIO,
+ MAX77650_GPIO_OUTVAL_MASK, regval);
+ if (rv)
+ dev_err(gc->parent, "cannot set GPIO value: %d\n", rv);
+}
+
+static int max77650_gpio_get_value(struct gpio_chip *gc,
+ unsigned int offset)
+{
+ struct max77650_gpio_chip *chip = gpiochip_get_data(gc);
+ unsigned int val;
+ int rv;
+
+ rv = regmap_read(chip->map, MAX77650_REG_CNFG_GPIO, &val);
+ if (rv)
+ return rv;
+
+ return MAX77650_GPIO_INVAL_BITS(val);
+}
+
+static int max77650_gpio_get_direction(struct gpio_chip *gc,
+ unsigned int offset)
+{
+ struct max77650_gpio_chip *chip = gpiochip_get_data(gc);
+ unsigned int val;
+ int rv;
+
+ rv = regmap_read(chip->map, MAX77650_REG_CNFG_GPIO, &val);
+ if (rv)
+ return rv;
+
+ return MAX77650_GPIO_DIR_BITS(val);
+}
+
+static int max77650_gpio_set_config(struct gpio_chip *gc,
+ unsigned int offset, unsigned long cfg)
+{
+ struct max77650_gpio_chip *chip = gpiochip_get_data(gc);
+
+ switch (pinconf_to_config_param(cfg)) {
+ case PIN_CONFIG_DRIVE_OPEN_DRAIN:
+ return regmap_update_bits(chip->map,
+ MAX77650_REG_CNFG_GPIO,
+ MAX77650_GPIO_DRV_MASK,
+ MAX77650_GPIO_DRV_OPEN_DRAIN);
+ case PIN_CONFIG_DRIVE_PUSH_PULL:
+ return regmap_update_bits(chip->map,
+ MAX77650_REG_CNFG_GPIO,
+ MAX77650_GPIO_DRV_MASK,
+ MAX77650_GPIO_DRV_PUSH_PULL);
+ case PIN_CONFIG_INPUT_DEBOUNCE:
+ return regmap_update_bits(chip->map,
+ MAX77650_REG_CNFG_GPIO,
+ MAX77650_GPIO_DEBOUNCE_MASK,
+ MAX77650_GPIO_DEBOUNCE);
+ default:
+ return -ENOTSUPP;
+ }
+}
+
+static int max77650_gpio_to_irq(struct gpio_chip *gc, unsigned int offset)
+{
+ /*
+ * TODO Add interrupt support.
+ *
+ * We first need to properly support hierarchical irqs in gpiolib
+ * and regmap irq_chip.
+ */
+ return -EOPNOTSUPP;
+}
+
+static int max77650_gpio_probe(struct platform_device *pdev)
+{
+ struct max77650_gpio_chip *chip;
+ struct device *dev, *parent;
+ struct i2c_client *i2c;
+
+ dev = &pdev->dev;
+ parent = dev->parent;
+ i2c = to_i2c_client(parent);
+
+ chip = devm_kzalloc(dev, sizeof(*chip), GFP_KERNEL);
+ if (!chip)
+ return -ENOMEM;
+
+ chip->map = dev_get_regmap(parent, NULL);
+ if (!chip->map)
+ return -ENODEV;
+
+ chip->gc.base = -1;
+ chip->gc.ngpio = 1;
+ chip->gc.label = i2c->name;
+ chip->gc.parent = dev;
+ chip->gc.owner = THIS_MODULE;
+ chip->gc.can_sleep = true;
+
+ chip->gc.direction_input = max77650_gpio_direction_input;
+ chip->gc.direction_output = max77650_gpio_direction_output;
+ chip->gc.set = max77650_gpio_set_value;
+ chip->gc.get = max77650_gpio_get_value;
+ chip->gc.get_direction = max77650_gpio_get_direction;
+ chip->gc.set_config = max77650_gpio_set_config;
+ chip->gc.to_irq = max77650_gpio_to_irq;
+
+ return devm_gpiochip_add_data(dev, &chip->gc, chip);
+}
+
+static struct platform_driver max77650_gpio_driver = {
+ .driver = {
+ .name = "max77650-gpio",
+ },
+ .probe = max77650_gpio_probe,
+};
+module_platform_driver(max77650_gpio_driver);
+
+MODULE_DESCRIPTION("MAXIM 77650/77651 GPIO driver");
+MODULE_AUTHOR("Bartosz Golaszewski <bgolaszewski@...libre.com>");
+MODULE_LICENSE("GPL v2");
--
2.20.1
Powered by blists - more mailing lists