[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]
Message-ID: <20190220130853.GQ9224@smile.fi.intel.com>
Date: Wed, 20 Feb 2019 15:08:53 +0200
From: Andy Shevchenko <andriy.shevchenko@...ux.intel.com>
To: Yauhen Kharuzhy <jekhor@...il.com>
Cc: linux-kernel@...r.kernel.org,
MyungJoo Ham <myungjoo.ham@...sung.com>,
Chanwoo Choi <cw00.choi@...sung.com>,
Hans de Goede <hdegoede@...hat.com>
Subject: Re: [PATCH v2 2/2] extcon intel-cht-wc: Enable external charger
On Wed, Feb 20, 2019 at 12:24:41AM +0300, Yauhen Kharuzhy wrote:
> In some configuration external charger "#charge enable" signal is
> connected to PMIC. Enable it at device probing to allow charging.
>
> Save CHGRCTRL0 and CHGDISCTR registers at driver probing and restore
> them at driver unbind to re-enable hardware charging control if it was
> enabled before.
>
> Tested at Lenovo Yoga Book (YB1-X91L).
My comments below.
After addressing them,
Reviewed-by: Andy Shevchenko <andriy.shevchenko@...ux.intel.com>
> +#define CHT_WC_CHGDISCTRL_OUTPUT BIT(0)
Simple _OUT as per documentation.
> +/* 0 - open drain, 1 - regular output */
Regular means push-pull.
> +#define CHT_WC_CHGDISCTRL_DRV_OD_DIS BIT(4)
_DRV as per documentation.
> +#define CHT_WC_CHGDISCTRL_MODE_HW BIT(6)
_FN as per documentation.
> +static void cht_wc_extcon_enable_charging(struct cht_wc_extcon_data *ext,
> + bool enable)
> +{
> + unsigned int val;
> + int ret;
> +
> + val = enable ? 0 : CHT_WC_CHGDISCTRL_OUTPUT;
Can be assigned in definition block.
> + ret = regmap_update_bits(ext->regmap, CHT_WC_CHGDISCTRL,
> + CHT_WC_CHGDISCTRL_OUTPUT, val);
> + if (ret)
> + dev_err(ext->dev, "Error updating CHGDISCTRL reg: %d\n", ret);
> +}
> + val = enable ? 0 : CHT_WC_CHGDISCTRL_MODE_HW;
> + ret = regmap_update_bits(ext->regmap, CHT_WC_CHGDISCTRL,
> + CHT_WC_CHGDISCTRL_MODE_HW, val);
Indentation.
> + if (ret)
> + dev_err(ext->dev,
> + "Error setting sw control for charger enable: %d\n",
> + ret);
> +static int cht_wc_save_initial_state(struct cht_wc_extcon_data *ext)
> +{
> + int ret;
> +
> + /*
> + * Save the external charger control output state for restoring it at
> + * driver unbinding
You may move "at" to the next line and add a period at the end.
> + */
> + ret = regmap_read(ext->regmap, CHT_WC_CHGDISCTRL,
> + &ext->chgdisctrl_saved);
> + if (ret) {
> + dev_err(ext->dev, "Error reading CHGDISCTRL: %d\n",
> + ret);
> + return ret;
> + }
> +
> + ret = regmap_read(ext->regmap, CHT_WC_CHGRCTRL0,
> + &ext->chgrctrl0_saved);
> + if (ret) {
> + dev_err(ext->dev, "Error reading CHGRCTRL0: %d\n",
> + ret);
> + return ret;
> + }
> +
> + return 0;
> +}
--
With Best Regards,
Andy Shevchenko
Powered by blists - more mailing lists