[<prev] [next>] [<thread-prev] [day] [month] [year] [list]
Message-ID: <5CD95314.4060307@mutluit.com>
Date: Mon, 13 May 2019 13:20:52 +0200
From: "U.Mutlu" <um@...luit.com>
To: Maxime Ripard <maxime.ripard@...tlin.com>
Cc: Jens Axboe <axboe@...nel.dk>, Chen-Yu Tsai <wens@...e.org>,
linux-ide@...r.kernel.org, linux-arm-kernel@...ts.infradead.org,
linux-kernel@...r.kernel.org, linux-sunxi@...glegroups.com,
linux-amarula@...rulasolutions.com,
Jagan Teki <jagan@...rulasolutions.com>,
Pablo Greco <pgreco@...tosproject.org>,
Mark Rutland <mark.rutland@....com>,
Oliver Schinagl <oliver@...inagl.nl>,
Linus Walleij <linus.walleij@...aro.org>,
Hans de Goede <hdegoede@...hat.com>,
FUKAUMI Naoki <naobsd@...il.com>,
Andre Przywara <andre.przywara@....com>,
Stefan Monnier <monnier@....umontreal.ca>
Subject: Re: [RFC PATCH v2 RESEND] drivers: ata: ahci_sunxi: Increased
SATA/AHCI DMA TX/RX FIFOs
Maxime Ripard wrote on 05/13/2019 11:59 AM:
> On Sun, May 12, 2019 at 10:59:54PM +0200, Uenal Mutlu wrote:
>> Increasing the SATA/AHCI DMA TX/RX FIFOs (P0DMACR.TXTS and .RXTS, ie.
>> TX_TRANSACTION_SIZE and RX_TRANSACTION_SIZE) from default 0x0 each
>> to 0x3 each, gives a write performance boost of 120 MiB/s to 132 MiB/s
>> from lame 36 MiB/s to 45 MiB/s previously.
>> Read performance is about 200 MiB/s.
>> [tested on SSD using dd bs=2K/4K/8K/12K/16K/24K/32K: peak-perf at 12K].
>>
>> Tested on the Banana Pi R1 (aka Lamobo R1) and Banana Pi M1 SBCs
>> with Allwinner A20 32bit-SoCs (ARMv7-a / arm-linux-gnueabihf).
>> These devices are RaspberryPi-like small devices.
>>
>> This problem of slow SATA write-speed with these small devices lasts now
>> for more than 5 years. Many commentators throughout the years wrongly
>> assumed the slow write speed was a hardware limitation. This patch finally
>> solves the problem, which in fact was just a hard-to-fix software problem
>> (b/c of lack of documentation by the SoC-maker Allwinner Technology).
>>
>> RFC: Since more than about 25 similar SBC/SoC models do use the
>> ahci_sunxi driver, users are encouraged to test it on all the
>> affected boards and give feedback.
>>
>> Lists of the affected sunxi and other boards and SoCs with SATA using
>> the ahci_sunxi driver:
>> $ grep -i -e "^&ahci" arch/arm/boot/dts/sun*dts
>> and http://linux-sunxi.org/SATA#Devices_with_SATA_ports
>> See also http://linux-sunxi.org/Category:Devices_with_SATA_port
>>
>> Patch v2:
>> - Commented the patch in-place in ahci_sunxi.c
>> - With bs=12K and no conv=... passed to dd, the write performance
>> rises further to 132 MiB/s
>> - Changed MB/s to MiB/s
>> - Posted the story behind the patch:
>> http://lkml.iu.edu/hypermail/linux/kernel/1905.1/03506.html
>> - Posted a dd test script to find optimal bs, and some results:
>> https://bit.ly/2YoOzEM
>>
>> Patch v1:
>> - States bs=4K for dd and a write performance of 120 MiB/s
>>
>> Signed-off-by: Uenal Mutlu <um@...luit.com>
>
> Acked-by: Maxime Ripard <maxime.ripard@...tlin.com>
Thx!
> Just a minor nitpick though, the part starting with RFC: and with the
> version changelog should be after the --- below so that it doesn't get
> applied as part of the commit log.
Ok, I'll do it better in the future.
Thx again.
> Maxime
>
> --
> Maxime Ripard, Bootlin
> Embedded Linux and Kernel engineering
> https://bootlin.com
Powered by blists - more mailing lists