linux-kernel - Re: [PATCH] phy: qcom-qmp: Correct READY

lists.openwall.net		lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC
Open Source and information security mailing list archives

Hash Suite: Windows password security audit tool. GUI, reports in PDF.

[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]

Message-ID: <20190612130858.GA11167@centauri>
Date:   Wed, 12 Jun 2019 15:08:58 +0200
From:   Niklas Cassel <niklas.cassel@...aro.org>
To:     Bjorn Andersson <bjorn.andersson@...aro.org>
Cc:     Kishon Vijay Abraham I <kishon@...com>,
        linux-arm-msm@...r.kernel.org, linux-kernel@...r.kernel.org,
        stable@...r.kernel.org, Evan Green <evgreen@...omium.org>,
        Marc Gonzalez <marc.w.gonzalez@...e.fr>,
        Vivek Gautam <vivek.gautam@...eaurora.org>
Subject: Re: [PATCH] phy: qcom-qmp: Correct READY_STATUS poll break condition

On Tue, Jun 04, 2019 at 04:24:43PM -0700, Bjorn Andersson wrote:
> After issuing a PHY_START request to the QMP, the hardware documentation
> states that the software should wait for the PCS_READY_STATUS to become
> 1.
> 
> With the introduction of c9b589791fc1 ("phy: qcom: Utilize UFS reset
> controller") an additional 1ms delay was introduced between the start
> request and the check of the status bit. This greatly increases the
> chances for the hardware to actually becoming ready before the status
> bit is read.
> 
> The result can be seen in that UFS PHY enabling is now reported as a
> failure in 10% of the boots on SDM845, which is a clear regression from
> the previous rare/occasional failure.
> 
> This patch fixes the "break condition" of the poll to check for the
> correct state of the status bit.
> 
> Unfortunately PCIe on 8996 and 8998 does not specify the mask_pcs_ready
> register, which means that the code checks a bit that's always 0. So the
> patch also fixes these, in order to not regress these targets.
> 
> Cc: stable@...r.kernel.org
> Cc: Evan Green <evgreen@...omium.org>
> Cc: Marc Gonzalez <marc.w.gonzalez@...e.fr>
> Cc: Vivek Gautam <vivek.gautam@...eaurora.org>
> Fixes: 73d7ec899bd8 ("phy: qcom-qmp: Add msm8998 PCIe QMP PHY support")
> Fixes: e78f3d15e115 ("phy: qcom-qmp: new qmp phy driver for qcom-chipsets")
> Signed-off-by: Bjorn Andersson <bjorn.andersson@...aro.org>
> ---
> 
> @Kishon, this is a regression spotted in v5.2-rc1, so please consider applying
> this towards v5.2.
> 
>  drivers/phy/qualcomm/phy-qcom-qmp.c | 4 +++-
>  1 file changed, 3 insertions(+), 1 deletion(-)
> 
> diff --git a/drivers/phy/qualcomm/phy-qcom-qmp.c b/drivers/phy/qualcomm/phy-qcom-qmp.c
> index cd91b4179b10..43abdfd0deed 100644
> --- a/drivers/phy/qualcomm/phy-qcom-qmp.c
> +++ b/drivers/phy/qualcomm/phy-qcom-qmp.c
> @@ -1074,6 +1074,7 @@ static const struct qmp_phy_cfg msm8996_pciephy_cfg = {
>  
>  	.start_ctrl		= PCS_START | PLL_READY_GATE_EN,
>  	.pwrdn_ctrl		= SW_PWRDN | REFCLK_DRV_DSBL,
> +	.mask_pcs_ready		= PHYSTATUS,
>  	.mask_com_pcs_ready	= PCS_READY,
>  
>  	.has_phy_com_ctrl	= true,
> @@ -1253,6 +1254,7 @@ static const struct qmp_phy_cfg msm8998_pciephy_cfg = {
>  
>  	.start_ctrl             = SERDES_START | PCS_START,
>  	.pwrdn_ctrl		= SW_PWRDN | REFCLK_DRV_DSBL,
> +	.mask_pcs_ready		= PHYSTATUS,
>  	.mask_com_pcs_ready	= PCS_READY,
>  };
>  
> @@ -1547,7 +1549,7 @@ static int qcom_qmp_phy_enable(struct phy *phy)
>  	status = pcs + cfg->regs[QPHY_PCS_READY_STATUS];
>  	mask = cfg->mask_pcs_ready;
>  
> -	ret = readl_poll_timeout(status, val, !(val & mask), 1,
> +	ret = readl_poll_timeout(status, val, val & mask, 1,
>  				 PHY_INIT_COMPLETE_TIMEOUT);
>  	if (ret) {
>  		dev_err(qmp->dev, "phy initialization timed-out\n");
> -- 
> 2.18.0
> 

msm8996_pciephy_cfg and msm8998_pciephy_cfg not having a bit mask defined
for PCS ready is really a separate bug, so personally I would have created
two patches, one that adds the missing masks, and one patch that fixes the
broken break condition.

Either way:

Reviewed-by: Niklas Cassel <niklas.cassel@...aro.org>