linux-kernel - [PATCH 5.1 110/138] Revert "serial: 8250: Dont service RX FIFO if interrupts are disabled"

lists.openwall.net		lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC
Open Source and information security mailing list archives

Hash Suite: Windows password security audit tool. GUI, reports in PDF.

[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]

Message-Id: <20190712121632.977789469@linuxfoundation.org>
Date:   Fri, 12 Jul 2019 14:19:34 +0200
From:   Greg Kroah-Hartman <gregkh@...uxfoundation.org>
To:     linux-kernel@...r.kernel.org
Cc:     Greg Kroah-Hartman <gregkh@...uxfoundation.org>,
        stable@...r.kernel.org, Oliver Barta <o.barta89@...il.com>,
        Andy Shevchenko <andriy.shevchenko@...ux.intel.com>
Subject: [PATCH 5.1 110/138] Revert "serial: 8250: Dont service RX FIFO if interrupts are disabled"

From: Oliver Barta <o.barta89@...il.com>

commit 3f2640ed7be838c3f05c0d2b0f7c7508e7431e48 upstream.

This reverts commit 2e9fe539108320820016f78ca7704a7342788380.

Reading LSR unconditionally but processing the error flags only if
UART_IIR_RDI bit was set before in IIR may lead to a loss of transmission
error information on UARTs where the transmission error flags are cleared
by a read of LSR. Information are lost in case an error is detected right
before the read of LSR while processing e.g. an UART_IIR_THRI interrupt.

Signed-off-by: Oliver Barta <o.barta89@...il.com>
Reviewed-by: Andy Shevchenko <andriy.shevchenko@...ux.intel.com>
Fixes: 2e9fe5391083 ("serial: 8250: Don't service RX FIFO if interrupts are disabled")
Cc: stable <stable@...r.kernel.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@...uxfoundation.org>

---
 drivers/tty/serial/8250/8250_port.c |    3 +--
 1 file changed, 1 insertion(+), 2 deletions(-)

--- a/drivers/tty/serial/8250/8250_port.c
+++ b/drivers/tty/serial/8250/8250_port.c
@@ -1869,8 +1869,7 @@ int serial8250_handle_irq(struct uart_po
 
 	status = serial_port_in(port, UART_LSR);
 
-	if (status & (UART_LSR_DR | UART_LSR_BI) &&
-	    iir & UART_IIR_RDI) {
+	if (status & (UART_LSR_DR | UART_LSR_BI)) {
 		if (!up->dma || handle_rx_dma(up, iir))
 			status = serial8250_rx_chars(up, status);
 	}