| lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
|
Open Source and information security mailing list archives
| ||
|
Message-Id: <20190729043926.32679-3-andrew@aj.id.au>
Date: Mon, 29 Jul 2019 14:09:24 +0930
From: Andrew Jeffery <andrew@...id.au>
To: netdev@...r.kernel.org
Cc: Andrew Jeffery <andrew@...id.au>, davem@...emloft.net,
robh+dt@...nel.org, mark.rutland@....com, joel@....id.au,
andrew@...n.ch, f.fainelli@...il.com, hkallweit1@...il.com,
devicetree@...r.kernel.org, linux-arm-kernel@...ts.infradead.org,
linux-aspeed@...ts.ozlabs.org, linux-kernel@...r.kernel.org
Subject: [PATCH 2/4] net: phy: Add mdio-aspeed
The AST2600 design separates the MDIO controllers from the MAC, which is
where they were placed in the AST2400 and AST2500. Further, the register
interface is reworked again, so now we have three possible different
interface implementations, however this driver only supports the
interface provided by the AST2600. The AST2400 and AST2500 will continue
to be supported by the MDIO support embedded in the FTGMAC100 driver.
Signed-off-by: Andrew Jeffery <andrew@...id.au>
---
drivers/net/phy/Kconfig | 13 +++
drivers/net/phy/Makefile | 1 +
drivers/net/phy/mdio-aspeed.c | 159 ++++++++++++++++++++++++++++++++++
3 files changed, 173 insertions(+)
create mode 100644 drivers/net/phy/mdio-aspeed.c
diff --git a/drivers/net/phy/Kconfig b/drivers/net/phy/Kconfig
index 20f14c5fbb7e..206d8650ee7f 100644
--- a/drivers/net/phy/Kconfig
+++ b/drivers/net/phy/Kconfig
@@ -21,6 +21,19 @@ config MDIO_BUS
if MDIO_BUS
+config MDIO_ASPEED
+ tristate "ASPEED MDIO bus controller"
+ depends on ARCH_ASPEED || COMPILE_TEST
+ depends on OF_MDIO && HAS_IOMEM
+ help
+ This module provides a driver for the independent MDIO bus
+ controllers found in the ASPEED AST2600 SoC. This is a driver for the
+ third revision of the ASPEED MDIO register interface - the first two
+ revisions are the "old" and "new" interfaces found in the AST2400 and
+ AST2500, embedded in the MAC. For legacy reasons, FTGMAC100 driver
+ continues to drive the embedded MDIO controller for the AST2400 and
+ AST2500 SoCs, so say N if AST2600 support is not required.
+
config MDIO_BCM_IPROC
tristate "Broadcom iProc MDIO bus controller"
depends on ARCH_BCM_IPROC || COMPILE_TEST
diff --git a/drivers/net/phy/Makefile b/drivers/net/phy/Makefile
index 839acb292c38..ba07c27e4208 100644
--- a/drivers/net/phy/Makefile
+++ b/drivers/net/phy/Makefile
@@ -22,6 +22,7 @@ libphy-$(CONFIG_LED_TRIGGER_PHY) += phy_led_triggers.o
obj-$(CONFIG_PHYLINK) += phylink.o
obj-$(CONFIG_PHYLIB) += libphy.o
+obj-$(CONFIG_MDIO_ASPEED) += mdio-aspeed.o
obj-$(CONFIG_MDIO_BCM_IPROC) += mdio-bcm-iproc.o
obj-$(CONFIG_MDIO_BCM_UNIMAC) += mdio-bcm-unimac.o
obj-$(CONFIG_MDIO_BITBANG) += mdio-bitbang.o
diff --git a/drivers/net/phy/mdio-aspeed.c b/drivers/net/phy/mdio-aspeed.c
new file mode 100644
index 000000000000..71496a9ff54a
--- /dev/null
+++ b/drivers/net/phy/mdio-aspeed.c
@@ -0,0 +1,159 @@
+// SPDX-License-Identifier: GPL-2.0-or-later
+/* Copyright (C) 2019 IBM Corp. */
+
+#include <linux/bitfield.h>
+#include <linux/delay.h>
+#include <linux/mdio.h>
+#include <linux/module.h>
+#include <linux/of.h>
+#include <linux/of_mdio.h>
+#include <linux/phy.h>
+#include <linux/platform_device.h>
+
+#define DRV_NAME "mdio-aspeed"
+
+#define ASPEED_MDIO_CTRL 0x0
+#define ASPEED_MDIO_CTRL_FIRE BIT(31)
+#define ASPEED_MDIO_CTRL_ST BIT(28)
+#define ASPEED_MDIO_CTRL_ST_C45 0
+#define ASPEED_MDIO_CTRL_ST_C22 1
+#define ASPEED_MDIO_CTRL_OP GENMASK(27, 26)
+#define MDIO_C22_OP_WRITE 0b01
+#define MDIO_C22_OP_READ 0b10
+#define ASPEED_MDIO_CTRL_PHYAD GENMASK(25, 21)
+#define ASPEED_MDIO_CTRL_REGAD GENMASK(20, 16)
+#define ASPEED_MDIO_CTRL_MIIWDATA GENMASK(15, 0)
+
+#define ASPEED_MDIO_DATA 0x4
+#define ASPEED_MDIO_DATA_MDC_THRES GENMASK(31, 24)
+#define ASPEED_MDIO_DATA_MDIO_EDGE BIT(23)
+#define ASPEED_MDIO_DATA_MDIO_LATCH GENMASK(22, 20)
+#define ASPEED_MDIO_DATA_IDLE BIT(16)
+#define ASPEED_MDIO_DATA_MIIRDATA GENMASK(15, 0)
+
+#define ASPEED_MDIO_RETRIES 10
+
+struct aspeed_mdio {
+ void __iomem *base;
+};
+
+static int aspeed_mdio_read(struct mii_bus *bus, int addr, int regnum)
+{
+ struct aspeed_mdio *ctx = bus->priv;
+ u32 ctrl;
+ int i;
+
+ dev_dbg(&bus->dev, "%s: addr: %d, regnum: %d\n", __func__, addr,
+ regnum);
+
+ /* Just clause 22 for the moment */
+ ctrl = ASPEED_MDIO_CTRL_FIRE
+ | FIELD_PREP(ASPEED_MDIO_CTRL_ST, ASPEED_MDIO_CTRL_ST_C22)
+ | FIELD_PREP(ASPEED_MDIO_CTRL_OP, MDIO_C22_OP_READ)
+ | FIELD_PREP(ASPEED_MDIO_CTRL_PHYAD, addr)
+ | FIELD_PREP(ASPEED_MDIO_CTRL_REGAD, regnum);
+
+ iowrite32(ctrl, ctx->base + ASPEED_MDIO_CTRL);
+
+ for (i = 0; i < ASPEED_MDIO_RETRIES; i++) {
+ u32 data;
+
+ data = ioread32(ctx->base + ASPEED_MDIO_DATA);
+ if (data & ASPEED_MDIO_DATA_IDLE)
+ return FIELD_GET(ASPEED_MDIO_DATA_MIIRDATA, data);
+
+ udelay(100);
+ }
+
+ dev_err(&bus->dev, "MDIO read failed\n");
+ return -EIO;
+}
+
+static int aspeed_mdio_write(struct mii_bus *bus, int addr, int regnum, u16 val)
+{
+ struct aspeed_mdio *ctx = bus->priv;
+ u32 ctrl;
+ int i;
+
+ dev_dbg(&bus->dev, "%s: addr: %d, regnum: %d, val: 0x%x\n",
+ __func__, addr, regnum, val);
+
+ /* Just clause 22 for the moment */
+ ctrl = ASPEED_MDIO_CTRL_FIRE
+ | FIELD_PREP(ASPEED_MDIO_CTRL_ST, ASPEED_MDIO_CTRL_ST_C22)
+ | FIELD_PREP(ASPEED_MDIO_CTRL_OP, MDIO_C22_OP_WRITE)
+ | FIELD_PREP(ASPEED_MDIO_CTRL_PHYAD, addr)
+ | FIELD_PREP(ASPEED_MDIO_CTRL_REGAD, regnum)
+ | FIELD_PREP(ASPEED_MDIO_CTRL_MIIWDATA, val);
+
+ iowrite32(ctrl, ctx->base + ASPEED_MDIO_CTRL);
+
+ for (i = 0; i < ASPEED_MDIO_RETRIES; i++) {
+ ctrl = ioread32(ctx->base + ASPEED_MDIO_CTRL);
+ if (!(ctrl & ASPEED_MDIO_CTRL_FIRE))
+ return 0;
+
+ udelay(100);
+ }
+
+ dev_err(&bus->dev, "MDIO write failed\n");
+ return -EIO;
+}
+
+static int aspeed_mdio_probe(struct platform_device *pdev)
+{
+ struct aspeed_mdio *ctx;
+ struct mii_bus *bus;
+ int rc;
+
+ bus = devm_mdiobus_alloc_size(&pdev->dev, sizeof(*ctx));
+ if (!bus)
+ return -ENOMEM;
+
+ ctx = bus->priv;
+ ctx->base = devm_platform_ioremap_resource(pdev, 0);
+ if (IS_ERR(ctx->base))
+ return PTR_ERR(ctx->base);
+
+ bus->name = DRV_NAME;
+ snprintf(bus->id, MII_BUS_ID_SIZE, "%s%d", pdev->name, pdev->id);
+ bus->parent = &pdev->dev;
+ bus->read = aspeed_mdio_read;
+ bus->write = aspeed_mdio_write;
+
+ rc = of_mdiobus_register(bus, pdev->dev.of_node);
+ if (rc) {
+ dev_err(&pdev->dev, "Cannot register MDIO bus!\n");
+ return rc;
+ }
+
+ platform_set_drvdata(pdev, bus);
+
+ return 0;
+}
+
+static int aspeed_mdio_remove(struct platform_device *pdev)
+{
+ mdiobus_unregister(platform_get_drvdata(pdev));
+
+ return 0;
+}
+
+static const struct of_device_id aspeed_mdio_of_match[] = {
+ { .compatible = "aspeed,ast2600-mdio", },
+ { },
+};
+
+static struct platform_driver aspeed_mdio_driver = {
+ .driver = {
+ .name = DRV_NAME,
+ .of_match_table = aspeed_mdio_of_match,
+ },
+ .probe = aspeed_mdio_probe,
+ .remove = aspeed_mdio_remove,
+};
+
+module_platform_driver(aspeed_mdio_driver);
+
+MODULE_AUTHOR("Andrew Jeffery <andrew@...id.au>");
+MODULE_LICENSE("GPL");
--
2.20.1
Powered by blists - more mailing lists