[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]
Message-ID: <60ea494a-9960-b7fc-3afb-8c17feec9fda@nvidia.com>
Date: Fri, 9 Aug 2019 10:24:27 -0700
From: Sowjanya Komatineni <skomatineni@...dia.com>
To: Dmitry Osipenko <digetx@...il.com>, <thierry.reding@...il.com>,
<jonathanh@...dia.com>, <tglx@...utronix.de>,
<jason@...edaemon.net>, <marc.zyngier@....com>,
<linus.walleij@...aro.org>, <stefan@...er.ch>,
<mark.rutland@....com>
CC: <pdeschrijver@...dia.com>, <pgaikwad@...dia.com>,
<sboyd@...nel.org>, <linux-clk@...r.kernel.org>,
<linux-gpio@...r.kernel.org>, <jckuo@...dia.com>,
<josephl@...dia.com>, <talho@...dia.com>,
<linux-tegra@...r.kernel.org>, <linux-kernel@...r.kernel.org>,
<mperttunen@...dia.com>, <spatra@...dia.com>, <robh+dt@...nel.org>,
<devicetree@...r.kernel.org>, <rjw@...ysocki.net>,
<viresh.kumar@...aro.org>, <linux-pm@...r.kernel.org>
Subject: Re: [PATCH v8 19/21] soc/tegra: pmc: Configure deep sleep control
settings
On 8/9/19 9:23 AM, Sowjanya Komatineni wrote:
>
> On 8/9/19 6:23 AM, Dmitry Osipenko wrote:
>> 09.08.2019 2:46, Sowjanya Komatineni пишет:
>>> Tegra210 and prior Tegra chips have deep sleep entry and wakeup related
>>> timings which are platform specific that should be configured before
>>> entering into deep sleep.
>>>
>>> Below are the timing specific configurations for deep sleep entry and
>>> wakeup.
>>> - Core rail power-on stabilization timer
>>> - OSC clock stabilization timer after SOC rail power is stabilized.
>>> - Core power off time is the minimum wake delay to keep the system
>>> in deep sleep state irrespective of any quick wake event.
>>>
>>> These values depends on the discharge time of regulators and turn OFF
>>> time of the PMIC to allow the complete system to finish entering into
>>> deep sleep state.
>>>
>>> These values vary based on the platform design and are specified
>>> through the device tree.
>>>
>>> This patch has implementation to configure these timings which are must
>>> to have for proper deep sleep and wakeup operations.
>>>
>>> Signed-off-by: Sowjanya Komatineni <skomatineni@...dia.com>
>>> ---
>>> drivers/soc/tegra/pmc.c | 13 ++++++++++++-
>>> 1 file changed, 12 insertions(+), 1 deletion(-)
>>>
>>> diff --git a/drivers/soc/tegra/pmc.c b/drivers/soc/tegra/pmc.c
>>> index e013ada7e4e9..9a78d8417367 100644
>>> --- a/drivers/soc/tegra/pmc.c
>>> +++ b/drivers/soc/tegra/pmc.c
>>> @@ -88,6 +88,8 @@
>>> #define PMC_CPUPWRGOOD_TIMER 0xc8
>>> #define PMC_CPUPWROFF_TIMER 0xcc
>>> +#define PMC_COREPWRGOOD_TIMER 0x3c
>>> +#define PMC_COREPWROFF_TIMER 0xe0
>>> #define PMC_PWR_DET_VALUE 0xe4
>>> @@ -2277,7 +2279,7 @@ static const struct tegra_pmc_regs
>>> tegra20_pmc_regs = {
>>> static void tegra20_pmc_init(struct tegra_pmc *pmc)
>>> {
>>> - u32 value;
>>> + u32 value, osc, pmu, off;
>>> /* Always enable CPU power request */
>>> value = tegra_pmc_readl(pmc, PMC_CNTRL);
>>> @@ -2303,6 +2305,15 @@ static void tegra20_pmc_init(struct tegra_pmc
>>> *pmc)
>>> value = tegra_pmc_readl(pmc, PMC_CNTRL);
>>> value |= PMC_CNTRL_SYSCLK_OE;
>>> tegra_pmc_writel(pmc, value, PMC_CNTRL);
>>> +
>>> + osc = DIV_ROUND_UP(pmc->core_osc_time * 8192, 1000000);
>>> + pmu = DIV_ROUND_UP(pmc->core_pmu_time * 32768, 1000000);
>>> + off = DIV_ROUND_UP(pmc->core_off_time * 32768, 1000000);
>>> + if (osc && pmu)
>>> + tegra_pmc_writel(pmc, ((osc << 8) & 0xff00) | (pmu & 0xff),
>>> + PMC_COREPWRGOOD_TIMER);
>>> + if (off)
>>> + tegra_pmc_writel(pmc, off, PMC_COREPWROFF_TIMER);
>> The osc/pmu/off values are undefined if they are not defined in
>> device-tree. I suppose this
>> need to be corrected in tegra_pmc_parse_dt() if the values really
>> matter even if LP0 suspend
>> isn't supported in device-tree.
>>
>> And I'm also not sure what's wrong with setting 0 for the timers.
>>
> These settings are for SC7 only and will not have any impact in normal
> state.
POR value for these timing registers is not 0 and has default timings
based on chip design and on top of that based on platform HW components
charge/discharge timings there's a need to increase these timings so
support for programming these thru DT is needed and these values have
effect only in LP0.
>>> }
>>> static void tegra20_pmc_setup_irq_polarity(struct tegra_pmc *pmc,
>>>
Powered by blists - more mailing lists