| lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
|
Open Source and information security mailing list archives
| ||
|
Message-ID: <20190816102025.GB14111@e119886-lin.cambridge.arm.com>
Date: Fri, 16 Aug 2019 11:20:25 +0100
From: Andrew Murray <andrew.murray@....com>
To: Xiaowei Bao <xiaowei.bao@....com>
Cc: "jingoohan1@...il.com" <jingoohan1@...il.com>,
"gustavo.pimentel@...opsys.com" <gustavo.pimentel@...opsys.com>,
"bhelgaas@...gle.com" <bhelgaas@...gle.com>,
"robh+dt@...nel.org" <robh+dt@...nel.org>,
"mark.rutland@....com" <mark.rutland@....com>,
"shawnguo@...nel.org" <shawnguo@...nel.org>,
Leo Li <leoyang.li@....com>, "kishon@...com" <kishon@...com>,
"lorenzo.pieralisi@....com" <lorenzo.pieralisi@....com>,
"arnd@...db.de" <arnd@...db.de>,
"gregkh@...uxfoundation.org" <gregkh@...uxfoundation.org>,
"M.h. Lian" <minghuan.lian@....com>,
Mingkai Hu <mingkai.hu@....com>,
"linux-pci@...r.kernel.org" <linux-pci@...r.kernel.org>,
"devicetree@...r.kernel.org" <devicetree@...r.kernel.org>,
"linux-kernel@...r.kernel.org" <linux-kernel@...r.kernel.org>,
"linux-arm-kernel@...ts.infradead.org"
<linux-arm-kernel@...ts.infradead.org>,
"linuxppc-dev@...ts.ozlabs.org" <linuxppc-dev@...ts.ozlabs.org>,
"Z.q. Hou" <zhiqiang.hou@....com>
Subject: Re: [PATCH 02/10] PCI: designware-ep: Add the doorbell mode of MSI-X
in EP mode
On Fri, Aug 16, 2019 at 02:58:31AM +0000, Xiaowei Bao wrote:
>
>
> > -----Original Message-----
> > From: Andrew Murray <andrew.murray@....com>
> > Sent: 2019年8月15日 19:54
> > To: Xiaowei Bao <xiaowei.bao@....com>
> > Cc: jingoohan1@...il.com; gustavo.pimentel@...opsys.com;
> > bhelgaas@...gle.com; robh+dt@...nel.org; mark.rutland@....com;
> > shawnguo@...nel.org; Leo Li <leoyang.li@....com>; kishon@...com;
> > lorenzo.pieralisi@....com; arnd@...db.de; gregkh@...uxfoundation.org;
> > M.h. Lian <minghuan.lian@....com>; Mingkai Hu <mingkai.hu@....com>;
> > Roy Zang <roy.zang@....com>; linux-pci@...r.kernel.org;
> > devicetree@...r.kernel.org; linux-kernel@...r.kernel.org;
> > linux-arm-kernel@...ts.infradead.org; linuxppc-dev@...ts.ozlabs.org
> > Subject: Re: [PATCH 02/10] PCI: designware-ep: Add the doorbell mode of
> > MSI-X in EP mode
> >
> > On Thu, Aug 15, 2019 at 04:37:08PM +0800, Xiaowei Bao wrote:
> > > Add the doorbell mode of MSI-X in EP mode.
> > >
> > > Signed-off-by: Xiaowei Bao <xiaowei.bao@....com>
> > > ---
> > > drivers/pci/controller/dwc/pcie-designware-ep.c | 14 ++++++++++++++
> > > drivers/pci/controller/dwc/pcie-designware.h | 14 ++++++++++++++
> > > 2 files changed, 28 insertions(+)
> > >
> > > diff --git a/drivers/pci/controller/dwc/pcie-designware-ep.c
> > > b/drivers/pci/controller/dwc/pcie-designware-ep.c
> > > index 75e2955..e3a7cdf 100644
> > > --- a/drivers/pci/controller/dwc/pcie-designware-ep.c
> > > +++ b/drivers/pci/controller/dwc/pcie-designware-ep.c
> > > @@ -454,6 +454,20 @@ int dw_pcie_ep_raise_msi_irq(struct dw_pcie_ep
> > *ep, u8 func_no,
> > > return 0;
> > > }
> > >
> > > +int dw_pcie_ep_raise_msix_irq_doorbell(struct dw_pcie_ep *ep, u8
> > func_no,
> > > + u16 interrupt_num)
> > > +{
> > > + struct dw_pcie *pci = to_dw_pcie_from_ep(ep);
> > > + u32 msg_data;
> > > +
> > > + msg_data = (func_no << PCIE_MSIX_DOORBELL_PF_SHIFT) |
> > > + (interrupt_num - 1);
> > > +
> > > + dw_pcie_writel_dbi(pci, PCIE_MSIX_DOORBELL, msg_data);
> > > +
> > > + return 0;
> > > +}
> > > +
> > > int dw_pcie_ep_raise_msix_irq(struct dw_pcie_ep *ep, u8 func_no,
> > > u16 interrupt_num)
> >
> > Have I understood correctly that the hardware provides an alternative
> > mechanism that allows for raising MSI-X interrupts without the bother of
> > reading the capabilities registers?
> Yes, the hardware provide two way to MSI-X, please check the page 492 of
> DWC_pcie_dm_registers_4.30 Menu.
> MSIX_DOORBELL_OFF on page 492 0x948 Description: MSI-X Doorbell Register....>
Thanks for the reference.
> >
> > If so is there any good reason to keep dw_pcie_ep_raise_msix_irq? (And thus
> > use it in dw_plat_pcie_ep_raise_irq also)?
> I am not sure, but I think the dw_pcie_ep_raise_msix_irq function is not correct,
> because I think we can't get the MSIX table from the address ep->phys_base + tbl_addr,
> but I also don't know where I can get the correct MSIX table.
Well it looks like this function is used by snps,dw-pcie-ep and snps,dw-pcie,
perhaps the doorbell mode isn't available on that hardware.
> >
> >
> > > {
> > > diff --git a/drivers/pci/controller/dwc/pcie-designware.h
> > > b/drivers/pci/controller/dwc/pcie-designware.h
> > > index 2b291e8..cd903e9 100644
> > > --- a/drivers/pci/controller/dwc/pcie-designware.h
> > > +++ b/drivers/pci/controller/dwc/pcie-designware.h
> > > @@ -88,6 +88,11 @@
> > > #define PCIE_MISC_CONTROL_1_OFF 0x8BC
> > > #define PCIE_DBI_RO_WR_EN BIT(0)
> > >
> > > +#define PCIE_MSIX_DOORBELL 0x948
> > > +#define PCIE_MSIX_DOORBELL_PF_SHIFT 24
> > > +#define PCIE_MSIX_DOORBELL_VF_SHIFT 16
> > > +#define PCIE_MSIX_DOORBELL_VF_ACTIVE BIT(15)
> >
> > The _VF defines are not used, I'd suggest removing them.
> In fact, I will add the SRIOV support in this file, the SRIOV feature have verified
> In my board, but I need wait the EP framework SRIOV patch merge,
> so I defined these two macros.
I'd suggest adding the VF macros along with the SRIOV feature.
Thanks,
Andrew Murray
> >
> > Thanks,
> >
> > Andrew Murray
> >
> > > +
> > > /*
> > > * iATU Unroll-specific register definitions
> > > * From 4.80 core version the address translation will be made by
> > > unroll @@ -399,6 +404,8 @@ int dw_pcie_ep_raise_msi_irq(struct
> > dw_pcie_ep *ep, u8 func_no,
> > > u8 interrupt_num);
> > > int dw_pcie_ep_raise_msix_irq(struct dw_pcie_ep *ep, u8 func_no,
> > > u16 interrupt_num);
> > > +int dw_pcie_ep_raise_msix_irq_doorbell(struct dw_pcie_ep *ep, u8
> > func_no,
> > > + u16 interrupt_num);
> > > void dw_pcie_ep_reset_bar(struct dw_pcie *pci, enum pci_barno bar);
> > > #else static inline void dw_pcie_ep_linkup(struct dw_pcie_ep *ep) @@
> > > -431,6 +438,13 @@ static inline int dw_pcie_ep_raise_msix_irq(struct
> > dw_pcie_ep *ep, u8 func_no,
> > > return 0;
> > > }
> > >
> > > +static inline int dw_pcie_ep_raise_msix_irq_doorbell(struct dw_pcie_ep
> > *ep,
> > > + u8 func_no,
> > > + u16 interrupt_num)
> > > +{
> > > + return 0;
> > > +}
> > > +
> > > static inline void dw_pcie_ep_reset_bar(struct dw_pcie *pci, enum
> > > pci_barno bar) { }
> > > --
> > > 2.9.5
> > >
> > >
> > > _______________________________________________
> > > linux-arm-kernel mailing list
> > > linux-arm-kernel@...ts.infradead.org
> > > https://eur01.safelinks.protection.outlook.com/?url=http%3A%2F%2Flists
> > > .infradead.org%2Fmailman%2Flistinfo%2Flinux-arm-kernel&data=02%
> > 7C0
> > >
> > 1%7Cxiaowei.bao%40nxp.com%7C8489493003bb48a0139d08d721773972%
> > 7C686ea1d
> > >
> > 3bc2b4c6fa92cd99c5c301635%7C0%7C0%7C637014668369499298&sd
> > ata=dyrXB
> > >
> > avljJBFUSNXW7K%2FRoXvwfWTE%2FoU2KMd1bZkJow%3D&reserved=0
Powered by blists - more mailing lists