| lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
|
Open Source and information security mailing list archives
| ||
|
Message-ID: <1e2ec69d-e42d-4e1b-7ce9-d1620cfbb4c9@baylibre.com>
Date: Wed, 11 Sep 2019 18:23:59 +0200
From: Neil Armstrong <narmstrong@...libre.com>
To: Cheng-Yi Chiang <cychiang@...omium.org>,
linux-kernel@...r.kernel.org
Cc: alsa-devel@...a-project.org, linux-arm-kernel@...ts.infradead.org,
linux-rockchip@...ts.infradead.org, a.hajda@...sung.com,
Laurent.pinchart@...asonboard.com, airlied@...ux.ie,
daniel@...ll.ch, kuninori.morimoto.gx@...esas.com,
sam@...nborg.org, dianders@...omium.org, dgreid@...omium.org,
tzungbi@...omium.org, zhengxing@...k-chips.com,
cain.cai@...k-chips.com, eddie.cai@...k-chips.com,
jeffy.chen@...k-chips.com, kuankuan.y@...il.com,
enric.balletbo@...labora.com, dri-devel@...ts.freedesktop.org,
Jerome Brunet <jbrunet@...libre.com>,
Jernej Skrabec <jernej.skrabec@...l.net>,
Jonas Karlman <jonas@...boo.se>,
Yakir Yang <ykk@...k-chips.com>
Subject: Re: [PATCH v3] drm: bridge/dw_hdmi: add audio sample channel status
setting
On 11/09/2019 10:26, Cheng-Yi Chiang wrote:
> From: Yakir Yang <ykk@...k-chips.com>
>
> When transmitting IEC60985 linear PCM audio, we configure the
> Aduio Sample Channel Status information in the IEC60958 frame.
> The status bit is already available in iec.status of hdmi_codec_params.
>
> This fix the issue that audio does not come out on some monitors
> (e.g. LG 22CV241)
>
> Note that these registers are only for interfaces:
> I2S audio interface, General Purpose Audio (GPA), or AHB audio DMA
> (AHBAUDDMA).
> For S/PDIF interface this information comes from the stream.
>
> Currently this function dw_hdmi_set_channel_status is only called
> from dw-hdmi-i2s-audio in I2S setup.
>
> Signed-off-by: Yakir Yang <ykk@...k-chips.com>
> Signed-off-by: Cheng-Yi Chiang <cychiang@...omium.org>
> ---
>
> Change from v2 to v3:
> 1. Reuse what is already set in iec.status in hw_param.
> 2. Remove all useless definition of registers and values.
> 3. Note that the original sampling frequency is not written to
> the channel status as we reuse create_iec958_consumer in pcm_iec958.c.
> Without that it can still play audio fine.
>
> .../drm/bridge/synopsys/dw-hdmi-i2s-audio.c | 1 +
> drivers/gpu/drm/bridge/synopsys/dw-hdmi.c | 20 +++++++++++++++++++
> drivers/gpu/drm/bridge/synopsys/dw-hdmi.h | 2 ++
> include/drm/bridge/dw_hdmi.h | 1 +
> 4 files changed, 24 insertions(+)
>
> diff --git a/drivers/gpu/drm/bridge/synopsys/dw-hdmi-i2s-audio.c b/drivers/gpu/drm/bridge/synopsys/dw-hdmi-i2s-audio.c
> index 34d8e837555f..20f4f92dd866 100644
> --- a/drivers/gpu/drm/bridge/synopsys/dw-hdmi-i2s-audio.c
> +++ b/drivers/gpu/drm/bridge/synopsys/dw-hdmi-i2s-audio.c
> @@ -102,6 +102,7 @@ static int dw_hdmi_i2s_hw_params(struct device *dev, void *data,
> }
>
> dw_hdmi_set_sample_rate(hdmi, hparms->sample_rate);
> + dw_hdmi_set_channel_status(hdmi, hparms->iec.status);
> dw_hdmi_set_channel_count(hdmi, hparms->channels);
> dw_hdmi_set_channel_allocation(hdmi, hparms->cea.channel_allocation);
>
> diff --git a/drivers/gpu/drm/bridge/synopsys/dw-hdmi.c b/drivers/gpu/drm/bridge/synopsys/dw-hdmi.c
> index bd65d0479683..aa7efd4da1c8 100644
> --- a/drivers/gpu/drm/bridge/synopsys/dw-hdmi.c
> +++ b/drivers/gpu/drm/bridge/synopsys/dw-hdmi.c
> @@ -582,6 +582,26 @@ static unsigned int hdmi_compute_n(unsigned int freq, unsigned long pixel_clk)
> return n;
> }
>
> +/*
> + * When transmitting IEC60958 linear PCM audio, these registers allow to
> + * configure the channel status information of all the channel status
> + * bits in the IEC60958 frame. For the moment this configuration is only
> + * used when the I2S audio interface, General Purpose Audio (GPA),
> + * or AHB audio DMA (AHBAUDDMA) interface is active
> + * (for S/PDIF interface this information comes from the stream).
> + */
> +void dw_hdmi_set_channel_status(struct dw_hdmi *hdmi,
> + u8 *channel_status)
> +{
> + /*
> + * Set channel status register for frequency and word length.
> + * Use default values for other registers.
> + */
> + hdmi_writeb(hdmi, channel_status[3], HDMI_FC_AUDSCHNLS7);
> + hdmi_writeb(hdmi, channel_status[4], HDMI_FC_AUDSCHNLS8);
> +}
> +EXPORT_SYMBOL_GPL(dw_hdmi_set_channel_status);
> +
> static void hdmi_set_clk_regenerator(struct dw_hdmi *hdmi,
> unsigned long pixel_clk, unsigned int sample_rate)
> {
> diff --git a/drivers/gpu/drm/bridge/synopsys/dw-hdmi.h b/drivers/gpu/drm/bridge/synopsys/dw-hdmi.h
> index 6988f12d89d9..fcff5059db24 100644
> --- a/drivers/gpu/drm/bridge/synopsys/dw-hdmi.h
> +++ b/drivers/gpu/drm/bridge/synopsys/dw-hdmi.h
> @@ -158,6 +158,8 @@
> #define HDMI_FC_SPDDEVICEINF 0x1062
> #define HDMI_FC_AUDSCONF 0x1063
> #define HDMI_FC_AUDSSTAT 0x1064
> +#define HDMI_FC_AUDSCHNLS7 0x106e
> +#define HDMI_FC_AUDSCHNLS8 0x106f
> #define HDMI_FC_DATACH0FILL 0x1070
> #define HDMI_FC_DATACH1FILL 0x1071
> #define HDMI_FC_DATACH2FILL 0x1072
> diff --git a/include/drm/bridge/dw_hdmi.h b/include/drm/bridge/dw_hdmi.h
> index cf528c289857..4b3e863c4f8a 100644
> --- a/include/drm/bridge/dw_hdmi.h
> +++ b/include/drm/bridge/dw_hdmi.h
> @@ -156,6 +156,7 @@ void dw_hdmi_setup_rx_sense(struct dw_hdmi *hdmi, bool hpd, bool rx_sense);
>
> void dw_hdmi_set_sample_rate(struct dw_hdmi *hdmi, unsigned int rate);
> void dw_hdmi_set_channel_count(struct dw_hdmi *hdmi, unsigned int cnt);
> +void dw_hdmi_set_channel_status(struct dw_hdmi *hdmi, u8 *channel_status);
> void dw_hdmi_set_channel_allocation(struct dw_hdmi *hdmi, unsigned int ca);
> void dw_hdmi_audio_enable(struct dw_hdmi *hdmi);
> void dw_hdmi_audio_disable(struct dw_hdmi *hdmi);
>
Looks fine for me:
Reviewed-by: Neil Armstrong <narmstrong@...libre.com>
Jonas ? Jernej ? Russell ?
If it's ok for you I'll apply it.
Neil
Powered by blists - more mailing lists