| lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
|
Open Source and information security mailing list archives
| ||
|
Message-Id: <1572242618-18806-2-git-send-email-Anson.Huang@nxp.com>
Date: Mon, 28 Oct 2019 14:03:36 +0800
From: Anson Huang <Anson.Huang@....com>
To: rui.zhang@...el.com, edubezval@...il.com,
daniel.lezcano@...aro.org, amit.kucheria@...durent.com,
robh+dt@...nel.org, mark.rutland@....com, shawnguo@...nel.org,
s.hauer@...gutronix.de, kernel@...gutronix.de, festevam@...il.com,
catalin.marinas@....com, will@...nel.org, leonard.crestez@....com,
abel.vesa@....com, ping.bai@....com, daniel.baluta@....com,
jun.li@....com, bjorn.andersson@...aro.org, olof@...om.net,
mripard@...nel.org, vkoul@...nel.org, jagan@...rulasolutions.com,
dinguyen@...nel.org, marcin.juszkiewicz@...aro.org,
linux-pm@...r.kernel.org, devicetree@...r.kernel.org,
linux-arm-kernel@...ts.infradead.org, linux-kernel@...r.kernel.org
Cc: Linux-imx@....com
Subject: [PATCH RESEND 2/4] thermal: imx8mm: Add support for i.MX8MM thermal monitoring unit
i.MX8MM has a thermal monitoring unit(TMU) inside, it ONLY has one
sensor for CPU, add support for reading immediate temperature of
this sensor.
Signed-off-by: Anson Huang <Anson.Huang@....com>
---
drivers/thermal/Kconfig | 10 +++
drivers/thermal/Makefile | 1 +
drivers/thermal/imx8mm_thermal.c | 134 +++++++++++++++++++++++++++++++++++++++
3 files changed, 145 insertions(+)
create mode 100644 drivers/thermal/imx8mm_thermal.c
diff --git a/drivers/thermal/Kconfig b/drivers/thermal/Kconfig
index 129b9ed..e09ff16 100644
--- a/drivers/thermal/Kconfig
+++ b/drivers/thermal/Kconfig
@@ -233,6 +233,16 @@ config IMX_THERMAL
cpufreq is used as the cooling device to throttle CPUs when the
passive trip is crossed.
+config IMX8MM_THERMAL
+ tristate "Temperature sensor driver for Freescale i.MX8MM SoC"
+ depends on ARCH_MXC
+ depends on OF
+ help
+ Support for Thermal Monitoring Unit (TMU) found on Freescale i.MX8MM SoC.
+ It supports one critical trip point and one passive trip point. The
+ cpufreq is used as the cooling device to throttle CPUs when the passive
+ trip is crossed.
+
config MAX77620_THERMAL
tristate "Temperature sensor driver for Maxim MAX77620 PMIC"
depends on MFD_MAX77620
diff --git a/drivers/thermal/Makefile b/drivers/thermal/Makefile
index baeb70b..f2608f0 100644
--- a/drivers/thermal/Makefile
+++ b/drivers/thermal/Makefile
@@ -41,6 +41,7 @@ obj-$(CONFIG_DB8500_THERMAL) += db8500_thermal.o
obj-$(CONFIG_ARMADA_THERMAL) += armada_thermal.o
obj-$(CONFIG_TANGO_THERMAL) += tango_thermal.o
obj-$(CONFIG_IMX_THERMAL) += imx_thermal.o
+obj-$(CONFIG_IMX8MM_THERMAL) += imx8mm_thermal.o
obj-$(CONFIG_MAX77620_THERMAL) += max77620_thermal.o
obj-$(CONFIG_QORIQ_THERMAL) += qoriq_thermal.o
obj-$(CONFIG_DA9062_THERMAL) += da9062-thermal.o
diff --git a/drivers/thermal/imx8mm_thermal.c b/drivers/thermal/imx8mm_thermal.c
new file mode 100644
index 0000000..04f8a8f
--- /dev/null
+++ b/drivers/thermal/imx8mm_thermal.c
@@ -0,0 +1,134 @@
+// SPDX-License-Identifier: GPL-2.0
+/*
+ * Copyright 2019 NXP.
+ *
+ */
+
+#include <linux/clk.h>
+#include <linux/delay.h>
+#include <linux/err.h>
+#include <linux/io.h>
+#include <linux/module.h>
+#include <linux/of.h>
+#include <linux/of_address.h>
+#include <linux/platform_device.h>
+#include <linux/thermal.h>
+
+#include "thermal_core.h"
+
+#define TER 0x0 /* TMU enable */
+#define TRITSR 0x20 /* TMU immediate temp */
+
+#define TER_EN BIT(31)
+#define TRITSR_VAL_MASK 0xff
+
+#define TEMP_LOW_LIMIT 10
+
+struct imx8mm_tmu {
+ struct thermal_zone_device *tzd;
+ void __iomem *base;
+ struct clk *clk;
+};
+
+static int tmu_get_temp(void *data, int *temp)
+{
+ struct imx8mm_tmu *tmu = data;
+ u32 val;
+
+ /* the temp sensor need about 1ms to finish the measurement */
+ usleep_range(1000, 2000);
+
+ val = readl_relaxed(tmu->base + TRITSR) & TRITSR_VAL_MASK;
+ if (val < TEMP_LOW_LIMIT)
+ return -EAGAIN;
+
+ *temp = val * 1000;
+
+ return 0;
+}
+
+static struct thermal_zone_of_device_ops tmu_tz_ops = {
+ .get_temp = tmu_get_temp,
+};
+
+static int imx8mm_tmu_probe(struct platform_device *pdev)
+{
+ struct imx8mm_tmu *tmu;
+ u32 val;
+ int ret;
+
+ tmu = devm_kzalloc(&pdev->dev, sizeof(struct imx8mm_tmu), GFP_KERNEL);
+ if (!tmu)
+ return -ENOMEM;
+
+ tmu->base = devm_platform_ioremap_resource(pdev, 0);
+ if (IS_ERR(tmu->base))
+ return PTR_ERR(tmu->base);
+
+ tmu->clk = devm_clk_get(&pdev->dev, NULL);
+ if (IS_ERR(tmu->clk)) {
+ ret = PTR_ERR(tmu->clk);
+ if (ret != -EPROBE_DEFER)
+ dev_err(&pdev->dev,
+ "failed to get tmu clock: %d\n", ret);
+ return ret;
+ }
+
+ ret = clk_prepare_enable(tmu->clk);
+ if (ret) {
+ dev_err(&pdev->dev, "failed to enable tmu clock: %d\n", ret);
+ return ret;
+ }
+
+ tmu->tzd = devm_thermal_zone_of_sensor_register(&pdev->dev, 0,
+ tmu, &tmu_tz_ops);
+ if (IS_ERR(tmu->tzd)) {
+ dev_err(&pdev->dev,
+ "failed to register thermal zone sensor: %d\n", ret);
+ return PTR_ERR(tmu->tzd);
+ }
+
+ platform_set_drvdata(pdev, tmu);
+
+ /* enable the monitor */
+ val = readl_relaxed(tmu->base + TER);
+ val |= TER_EN;
+ writel_relaxed(val, tmu->base + TER);
+
+ return 0;
+}
+
+static int imx8mm_tmu_remove(struct platform_device *pdev)
+{
+ struct imx8mm_tmu *tmu = platform_get_drvdata(pdev);
+ u32 val;
+
+ /* disable TMU */
+ val = readl_relaxed(tmu->base + TER);
+ val &= ~TER_EN;
+ writel_relaxed(val, tmu->base + TER);
+
+ clk_disable_unprepare(tmu->clk);
+ platform_set_drvdata(pdev, NULL);
+
+ return 0;
+}
+
+static const struct of_device_id imx8mm_tmu_table[] = {
+ { .compatible = "fsl,imx8mm-tmu", },
+ { },
+};
+
+static struct platform_driver imx8mm_tmu = {
+ .driver = {
+ .name = "i.mx8mm_thermal",
+ .of_match_table = imx8mm_tmu_table,
+ },
+ .probe = imx8mm_tmu_probe,
+ .remove = imx8mm_tmu_remove,
+};
+module_platform_driver(imx8mm_tmu);
+
+MODULE_AUTHOR("Anson Huang <Anson.Huang@....com>");
+MODULE_DESCRIPTION("i.MX8MM Thermal Monitor Unit driver");
+MODULE_LICENSE("GPL v2");
--
2.7.4
Powered by blists - more mailing lists