| lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
|
Open Source and information security mailing list archives
| ||
|
Date: Thu, 20 Feb 2020 01:36:08 +0000
From: Peng Fan <peng.fan@....com>
To: Mathieu Poirier <mathieu.poirier@...aro.org>
CC: Ohad Ben-Cohen <ohad@...ery.com>,
Bjorn Andersson <bjorn.andersson@...aro.org>,
Rob Herring <robh+dt@...nel.org>,
Shawn Guo <shawnguo@...nel.org>,
Sascha Hauer <s.hauer@...gutronix.de>,
Pengutronix Kernel Team <kernel@...gutronix.de>,
Fabio Estevam <festevam@...il.com>,
dl-linux-imx <linux-imx@....com>,
linux-remoteproc <linux-remoteproc@...r.kernel.org>,
"devicetree@...r.kernel.org" <devicetree@...r.kernel.org>,
linux-arm-kernel <linux-arm-kernel@...ts.infradead.org>,
Linux Kernel Mailing List <linux-kernel@...r.kernel.org>
Subject: RE: [PATCH 0/9] remoteproc: imx_rproc: support i.MX8/8M/7ULP
Hi Mathieu,
> Subject: Re: [PATCH 0/9] remoteproc: imx_rproc: support i.MX8/8M/7ULP
>
> Hi Peng,
>
> On Wed, 19 Feb 2020 at 00:33, <peng.fan@....com> wrote:
> >
> > From: Peng Fan <peng.fan@....com>
> >
> > This patchset aim to replace NXP vendor imx_rpmsg.c driver.
>
> You mean remoteproc/imx_rproc.c ? Upstream rpmsg/imx_rpmsg.c doesn't
> exist.
imx_rpmsg.c only in NXP vendor tree. This pachset is to use imx_rproc.c for
rpmsg/virtio functions for i.MX SoC.
>
> >
> > This patchset is tested with Loic PALLARDY's patch
> > "remoteproc: add support for co-processor loaded and booted before
> kernel"
> > https://eur01.safelinks.protection.outlook.com/?url=https%3A%2F%2Fpatc
> >
> hwork.kernel.org%2Fpatch%2F11265869%2F&data=02%7C01%7Cpeng.f
> an%40n
> >
> xp.com%7Ce1cb19e535a14b63d0da08d7b568fd56%7C686ea1d3bc2b4c6fa9
> 2cd99c5c
> >
> 301635%7C0%7C0%7C637177334839497832&sdata=aKQ%2Bulco63ba
> YT%2BDZDk0
> > VLt1NpkNuhrY3ssxiRCOcrM%3D&reserved=0,
> > and inspried from st's remoteproc early boot support.
> > Since Loic's patch is still under review, just expect your comments :)
>
> Did you base your work on top of Loic's because your MCU firmware is always
> loaded by the bootloader?
I only took Loic's early-boot patch as base and apply my patchset.
The mcu firmware currently only loaded by bootloader or system controller firmware.
NXP released mcu firmware not support being loaded by Linux remoteproc.
If not please send another revision of your work
> without early boot support. When we have a clear view on how to proceed
> with the early boot support you can send another set to enable that.
I'll wait your new patch for early boot in remoteproc-core. Then I'll rebase
and send a new version. Since I introduce big changes to imx_rproc.c, so
I'll see whether any comments there.
Thanks,
Peng.
>
> Thanks,
> Mathieu
>
> >
> > Patch [1,2]/9: dt-bindings convert to json and new SoC support Patch
> > 3/9: skip firmware load when recovery. To i.MX8, firmware is not
> > handled by Linux.
> >
> > Patch [4-9]/9: i.MX specific part to support rpmsg/virtio with mbox.
> > because NXP release image not have resoure table, so add resource
> > table in dts
> >
> > My test dts diff for i.MX8QXP MEK, but I have tested this patchset for
> > i.MX8QXP MEK, i.MX8MM EVK, i.MX7ULP EVK:
> >
> > +
> > + imx8x-cm4 {
> > + compatible = "fsl,imx8qxp-cm4";
> > + rsrc-table = <
> > + 0x1 0x2 0x0 0x0 0x18 0x5c
> > + 3
> > + /*fw_rsc_vdev*/
> > + 7 0 1 0 0 0x200
> > + /*fw_rsc_vdev_vring*/
> > + 0x90000000 4096 256 1 0
> > + 0x90008000 4096 256 2 0
> > + 3
> > + /*fw_rsc_vdev*/
> > + 7 1 1 0 0 0x200
> > + /*fw_rsc_vdev_vring*/
> > + 0x90010000 4096 256 1 0
> > + 0x90018000 4096 256 2 0
> > + >;
> > + early-booted;
> > + mbox-names = "tx", "rx", "rxdb";
> > + mboxes = <&lsio_mu5 0 1
> > + &lsio_mu5 1 1
> > + &lsio_mu5 3 1>;
> > + mub-partition = <3>;
> > + memory-region = <&vdev0vring0>, <&vdev0vring1>,
> <&vdev0buffer>,
> > + <&vdev1vring0>, <&vdev1vring1>,
> <&vdev0buffer>;
> > + };
> > +
> > + reserved-memory {
> > + #address-cells = <2>;
> > + #size-cells = <2>;
> > + ranges;
> > +
> > + vdev0vring0: vdev0vring0@...00000 {
> > + compatible = "shared-dma-pool";
> > + reg = <0 0x90000000 0 0x8000>;
> > + no-map;
> > + };
> > +
> > + vdev0vring1: vdev0vring1@...08000 {
> > + compatible = "shared-dma-pool";
> > + reg = <0 0x90008000 0 0x8000>;
> > + no-map;
> > + };
> > +
> > + vdev1vring0: vdev1vring0@...10000 {
> > + compatible = "shared-dma-pool";
> > + reg = <0 0x90010000 0 0x8000>;
> > + no-map;
> > + };
> > +
> > + vdev1vring1: vdev1vring1@...18000 {
> > + compatible = "shared-dma-pool";
> > + reg = <0 0x90018000 0 0x8000>;
> > + no-map;
> > + };
> > +
> > + vdev0buffer: vdev0buffer {
> > + compatible = "shared-dma-pool";
> > + reg = <0 0x90400000 0 0x100000>;
> > + no-map;
> > + };
> > + };
> > +
> >
> > Peng Fan (9):
> > dt-bindings: remoteproc: Convert imx-rproc to json-schema
> > dt-bindings: remoteproc: imx-rproc: support i.MX[8,8M,7ULP]
> > remoteproc: add support to skip firmware load when recovery
> > remoteproc: imx_rproc: surport early booted remote processor
> > remoteproc: imx_rproc: parse early-booted property
> > remoteproc: imx_proc: enable virtio/mailbox
> > remoteproc: imx_rproc: add i.MX8QM/QXP
> > remoteproc: imx_rproc: support i.MX7ULP
> > remoteproc: imx_rproc: add i.MX8MM support
> >
> > .../devicetree/bindings/remoteproc/imx-rproc.txt | 33 --
> > .../devicetree/bindings/remoteproc/imx-rproc.yaml | 95 +++++
> > drivers/remoteproc/imx_rproc.c | 455
> +++++++++++++++++++--
> > drivers/remoteproc/remoteproc_core.c | 19 +-
> > include/linux/remoteproc.h | 1 +
> > 5 files changed, 531 insertions(+), 72 deletions(-) delete mode
> > 100644 Documentation/devicetree/bindings/remoteproc/imx-rproc.txt
> > create mode 100644
> > Documentation/devicetree/bindings/remoteproc/imx-rproc.yaml
> >
> > --
> > 2.16.4
> >
Powered by blists - more mailing lists