| lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
|
Open Source and information security mailing list archives
| ||
|
Message-Id: <20200227182210.89512-1-andre.przywara@arm.com>
Date: Thu, 27 Feb 2020 18:21:57 +0000
From: Andre Przywara <andre.przywara@....com>
To: Rob Herring <robh@...nel.org>,
linux-arm-kernel@...ts.infradead.org, linux-kernel@...r.kernel.org,
devicetree@...r.kernel.org
Cc: Maxime Ripard <mripard@...nel.org>,
Robert Richter <rric@...nel.org>, soc@...nel.org,
Jon Loeliger <jdl@....com>,
Mark Langsdorf <mlangsdo@...hat.com>,
Eric Auger <eric.auger@...hat.com>,
Will Deacon <will@...nel.org>,
Catalin Marinas <catalin.marinas@....com>
Subject: [PATCH v2 00/13] arm: calxeda: update DTS, bindings and MAINTAINERS
Hi,
some smaller changes, as pointed out by Maxime. Many thanks!
------------------
This series is an answer to the attempt [1] of removing the Calxeda
Highbank platform support from the kernel. Apart from the pending removal
of ARM32 host KVM support from the kernel, the lack of proper DT schema
bindings was another major reason for Rob's series.
This series addresses this. The first four patches adjust the .dts files
to pass the existing (mostly generic) DT schema binding checks. Those
changes should not affect the functionality.
The following eight patches then convert the "prose" DT binding
documentation to the json-schema format, so that the automatic checking
actually does something useful.
After those patches "make dtbs_check" comes back clean for the two .dts
files in the kernel, and "dt_validate -m" reports only those three
not-covered nodes (on Highbank, only the last one on Midway):
arm,cortex-a9-twd-timer
arm,cortex-a9-twd-wdt
calxeda,hb-sdhci
The first two are generic ARM devices, for which the binding doc just
does not have been converted yet. The SDHCI controller is actually
disabled in the DTs, and the SD slot is populated on very few special
systems only, also there has never been a driver in the kernel for
this device anyway.
The final patch then changes the MAINTAINERS file to hand over the
maintainership to me. I have a working machine under my desk and have
some interest in keeping this platform support alive.
Changelog:
v1 ... v2:
- Remove unneeded property type from clocks and sgpio-gpio
- add additionalProperties: false to bindings missing it before
- limit number in "phydev" to the hardware constraint of 5 bits
- add required: properties to l2ecc binding
- fix enumeration of compatible strings in calxeda-ddr-ctrlr
Cheers,
Andre.
[1] https://lore.kernel.org/linux-arm-kernel/20200218171321.30990-1-robh@kernel.org/
Andre Przywara (13):
arm: dts: calxeda: Basic DT file fixes
arm: dts: calxeda: Provide UART clock
arm: dts: calxeda: Fix interrupt grouping
arm: dts: calxeda: Group port-phys and sgpio-gpio items
dt-bindings: clock: Convert Calxeda clock bindings to json-schema
dt-bindings: sata: Convert Calxeda SATA controller to json-schema
dt-bindings: net: Convert Calxeda Ethernet binding to json-schema
dt-bindings: phy: Convert Calxeda ComboPHY binding to json-schema
dt-bindings: arm: Convert Calxeda L2 cache controller to json-schema
dt-bindings: memory-controllers: convert Calxeda DDR to json-schema
dt-bindings: ipmi: Convert IPMI-SMIC bindings to json-schema
dt-bindings: arm: Add Calxeda system registers json-schema binding
MAINTAINERS: Update Calxeda Highbank maintainership
.../bindings/arm/calxeda/hb-sregs.yaml | 47 +++++++++
.../devicetree/bindings/arm/calxeda/l2ecc.txt | 15 ---
.../bindings/arm/calxeda/l2ecc.yaml | 36 +++++++
.../devicetree/bindings/ata/sata_highbank.txt | 44 ---------
.../bindings/ata/sata_highbank.yaml | 96 +++++++++++++++++++
.../devicetree/bindings/clock/calxeda.txt | 17 ----
.../devicetree/bindings/clock/calxeda.yaml | 83 ++++++++++++++++
.../devicetree/bindings/ipmi/ipmi-smic.txt | 25 -----
.../devicetree/bindings/ipmi/ipmi-smic.yaml | 56 +++++++++++
.../memory-controllers/calxeda-ddr-ctrlr.txt | 16 ----
.../memory-controllers/calxeda-ddr-ctrlr.yaml | 41 ++++++++
.../devicetree/bindings/net/calxeda-xgmac.txt | 18 ----
.../bindings/net/calxeda-xgmac.yaml | 47 +++++++++
.../bindings/phy/calxeda-combophy.txt | 17 ----
.../bindings/phy/calxeda-combophy.yaml | 47 +++++++++
MAINTAINERS | 2 +-
arch/arm/boot/dts/ecx-2000.dts | 5 +-
arch/arm/boot/dts/ecx-common.dtsi | 17 ++--
arch/arm/boot/dts/highbank.dts | 11 +--
19 files changed, 468 insertions(+), 172 deletions(-)
create mode 100644 Documentation/devicetree/bindings/arm/calxeda/hb-sregs.yaml
delete mode 100644 Documentation/devicetree/bindings/arm/calxeda/l2ecc.txt
create mode 100644 Documentation/devicetree/bindings/arm/calxeda/l2ecc.yaml
delete mode 100644 Documentation/devicetree/bindings/ata/sata_highbank.txt
create mode 100644 Documentation/devicetree/bindings/ata/sata_highbank.yaml
delete mode 100644 Documentation/devicetree/bindings/clock/calxeda.txt
create mode 100644 Documentation/devicetree/bindings/clock/calxeda.yaml
delete mode 100644 Documentation/devicetree/bindings/ipmi/ipmi-smic.txt
create mode 100644 Documentation/devicetree/bindings/ipmi/ipmi-smic.yaml
delete mode 100644 Documentation/devicetree/bindings/memory-controllers/calxeda-ddr-ctrlr.txt
create mode 100644 Documentation/devicetree/bindings/memory-controllers/calxeda-ddr-ctrlr.yaml
delete mode 100644 Documentation/devicetree/bindings/net/calxeda-xgmac.txt
create mode 100644 Documentation/devicetree/bindings/net/calxeda-xgmac.yaml
delete mode 100644 Documentation/devicetree/bindings/phy/calxeda-combophy.txt
create mode 100644 Documentation/devicetree/bindings/phy/calxeda-combophy.yaml
--
2.17.1
*** BLURB HERE ***
Andre Przywara (13):
arm: dts: calxeda: Basic DT file fixes
arm: dts: calxeda: Provide UART clock
arm: dts: calxeda: Fix interrupt grouping
arm: dts: calxeda: Group port-phys and sgpio-gpio items
dt-bindings: clock: Convert Calxeda clock bindings to json-schema
dt-bindings: sata: Convert Calxeda SATA controller to json-schema
dt-bindings: net: Convert Calxeda Ethernet binding to json-schema
dt-bindings: phy: Convert Calxeda ComboPHY binding to json-schema
dt-bindings: arm: Convert Calxeda L2 cache controller to json-schema
dt-bindings: memory-controllers: Convert Calxeda DDR to json-schema
dt-bindings: ipmi: Convert IPMI-SMIC bindings to json-schema
dt-bindings: arm: Add Calxeda system registers json-schema binding
MAINTAINERS: Update Calxeda Highbank maintainership
.../bindings/arm/calxeda/hb-sregs.yaml | 49 ++++++++++
.../devicetree/bindings/arm/calxeda/l2ecc.txt | 15 ---
.../bindings/arm/calxeda/l2ecc.yaml | 43 +++++++++
.../devicetree/bindings/ata/sata_highbank.txt | 44 ---------
.../bindings/ata/sata_highbank.yaml | 95 +++++++++++++++++++
.../devicetree/bindings/clock/calxeda.txt | 17 ----
.../devicetree/bindings/clock/calxeda.yaml | 82 ++++++++++++++++
.../devicetree/bindings/ipmi/ipmi-smic.txt | 25 -----
.../devicetree/bindings/ipmi/ipmi-smic.yaml | 56 +++++++++++
.../memory-controllers/calxeda-ddr-ctrlr.txt | 16 ----
.../memory-controllers/calxeda-ddr-ctrlr.yaml | 42 ++++++++
.../devicetree/bindings/net/calxeda-xgmac.txt | 18 ----
.../bindings/net/calxeda-xgmac.yaml | 49 ++++++++++
.../bindings/phy/calxeda-combophy.txt | 17 ----
.../bindings/phy/calxeda-combophy.yaml | 51 ++++++++++
MAINTAINERS | 2 +-
arch/arm/boot/dts/ecx-2000.dts | 5 +-
arch/arm/boot/dts/ecx-common.dtsi | 17 ++--
arch/arm/boot/dts/highbank.dts | 11 +--
19 files changed, 482 insertions(+), 172 deletions(-)
create mode 100644 Documentation/devicetree/bindings/arm/calxeda/hb-sregs.yaml
delete mode 100644 Documentation/devicetree/bindings/arm/calxeda/l2ecc.txt
create mode 100644 Documentation/devicetree/bindings/arm/calxeda/l2ecc.yaml
delete mode 100644 Documentation/devicetree/bindings/ata/sata_highbank.txt
create mode 100644 Documentation/devicetree/bindings/ata/sata_highbank.yaml
delete mode 100644 Documentation/devicetree/bindings/clock/calxeda.txt
create mode 100644 Documentation/devicetree/bindings/clock/calxeda.yaml
delete mode 100644 Documentation/devicetree/bindings/ipmi/ipmi-smic.txt
create mode 100644 Documentation/devicetree/bindings/ipmi/ipmi-smic.yaml
delete mode 100644 Documentation/devicetree/bindings/memory-controllers/calxeda-ddr-ctrlr.txt
create mode 100644 Documentation/devicetree/bindings/memory-controllers/calxeda-ddr-ctrlr.yaml
delete mode 100644 Documentation/devicetree/bindings/net/calxeda-xgmac.txt
create mode 100644 Documentation/devicetree/bindings/net/calxeda-xgmac.yaml
delete mode 100644 Documentation/devicetree/bindings/phy/calxeda-combophy.txt
create mode 100644 Documentation/devicetree/bindings/phy/calxeda-combophy.yaml
--
2.17.1
Powered by blists - more mailing lists