Message-ID: <20200313175511.2155-1-grygorii.strashko@ti.com>
Date:   Fri, 13 Mar 2020 19:55:01 +0200
From:   Grygorii Strashko <grygorii.strashko@...com>
To:     Rob Herring <robh+dt@...nel.org>, Tero Kristo <t-kristo@...com>,
        "David S . Miller" <davem@...emloft.net>,
        netdev <netdev@...r.kernel.org>, Roger Quadros <rogerq@...com>,
        <devicetree@...r.kernel.org>, Jakub Kicinski <kuba@...nel.org>
CC:     Murali Karicheri <m-karicheri2@...com>,
        Sekhar Nori <nsekhar@...com>,
        Peter Ujfalusi <peter.ujfalusi@...com>,
        Kishon Vijay Abraham I <kishon@...com>,
        <linux-kernel@...r.kernel.org>,
        <linux-arm-kernel@...ts.infradead.org>,
        Grygorii Strashko <grygorii.strashko@...com>
Subject: [PATCH net-next v3 00/10] net: ethernet: ti: add networking support for k3 am65x/j721e soc

Hi

This v3 series adds basic networking support support TI K3 AM654x/J721E SoC which
have integrated Gigabit Ethernet MAC (Media Access Controller) into device MCU
domain and named MCU_CPSW0 (CPSW2G NUSS).

Formally TRMs refer CPSW2G NUSS as two-port Gigabit Ethernet Switch subsystem
with port 0 being the CPPI DMA host port and port 1 being the external Ethernet
port, but for 1 external port device it's just Port 0 <-> ALE <-> Port 1 and it's
rather device with HW filtering capabilities then actually switching device.
It's expected to have similar devices, but with more external ports.

The new Host port 0 Communications Port Programming Interface (CPPI5) is
operating by TI AM654x/J721E NAVSS Unified DMA Peripheral Root Complex (UDMA-P)
controller [1].

The CPSW2G contains below modules for which existing code is re-used:
 - MAC SL: cpsw_sl.c
 - Address Lookup Engine (ALE): cpsw_ale.c, basically compatible with K2 66AK2E/G
 - Management Data Input/Output interface (MDIO): davinci_mdio.c, fully 
   compatible with TI AM3/4/5 devices

Basic features supported by CPSW2G NUSS driver:
 - VLAN support, 802.1Q compliant, Auto add port VLAN for untagged frames on
   ingress, Auto VLAN removal on egress and auto pad to minimum frame size.
 - multicast filtering
 - promisc mode
 - TX multiq support in Round Robin or Fixed priority modes
 - RX checksum offload for non-fragmented IPv4/IPv6 TCP/UDP packets
 - TX checksum offload support for IPv4/IPv6 TCP/UDP packets (J721E only).

Features under development:
 - Support for IEEE 1588 Clock Synchronization. The CPSW2G NUSS includes new
   version of Common Platform Time Sync (CPTS)
 - tc-mqprio: priority level Quality Of Service (QOS) support (802.1p)
 - tc-cbs: Support for Audio/Video Bridging (P802.1Qav/D6.0) HW shapers
 - tc-taprio: IEEE 802.1Qbv/D2.2 Enhancements for Scheduled Traffic
 - frame preemption: IEEE P902.3br/D2.0 Interspersing Express Traffic, 802.1Qbu
 - extended ALE features: classifier/policers, auto-aging

This series depends on:
 [for-next PATCH 0/5] phy: ti: gmii-sel: add support for am654x/j721e soc
 https://lkml.org/lkml/2020/2/22/100

Patches 1-5 are intended for netdev, Patches 6-10 are intended for K3 Platform
tree and provided here for testing purposes.

Changes in v3:
 - add ARM64 defconfig changes for testing purposes
 - fixed DT yaml definition
 - fixed comments from Jakub Kicinski <kuba@...nel.org>

Changes in v2:
 - fixed DT yaml definition
 - fixed comments from David Miller

v2: https://patchwork.ozlabs.org/cover/1250674/
v1: https://lwn.net/Articles/813087/

TRMs:
 AM654: http://www.ti.com/lit/ug/spruid7e/spruid7e.pdf
 J721E: http://www.ti.com/lit/ug/spruil1a/spruil1a.pdf

Preliminary documentation can be found at:
 http://software-dl.ti.com/processor-sdk-linux/esd/docs/latest/linux/Foundational_Components/Kernel/Kernel_Drivers/Network/K3_CPSW2g.html

[1] https://lwn.net/Articles/808030/

Grygorii Strashko (10):
  net: ethernet: ti: ale: fix seeing unreg mcast packets with promisc
    and allmulti disabled
  net: ethernet: ti: ale: add support for mac-only mode
  net: ethernet: ti: ale: am65: add support for default thread cfg
  dt-binding: ti: am65x: document mcu cpsw nuss
  net: ethernet: ti: introduce am65x/j721e gigabit eth subsystem driver
  arm64: dts: ti: k3-am65-mcu: add cpsw nuss node
  arm64: dts: k3-am654-base-board: add mcu cpsw nuss pinmux and phy defs
  arm64: dts: ti: k3-j721e-mcu: add mcu cpsw nuss node
  arm64: dts: ti: k3-j721e-common-proc-board: add mcu cpsw nuss pinmux
    and phy defs
  arm64: defconfig: ti: k3: enable dma and networking

 .../bindings/net/ti,k3-am654-cpsw-nuss.yaml   |  226 ++
 arch/arm64/boot/dts/ti/k3-am65-mcu.dtsi       |   49 +
 arch/arm64/boot/dts/ti/k3-am65.dtsi           |    1 +
 .../arm64/boot/dts/ti/k3-am654-base-board.dts |   42 +
 .../dts/ti/k3-j721e-common-proc-board.dts     |   43 +
 .../boot/dts/ti/k3-j721e-mcu-wakeup.dtsi      |   49 +
 arch/arm64/boot/dts/ti/k3-j721e.dtsi          |    1 +
 arch/arm64/configs/defconfig                  |    3 +
 drivers/net/ethernet/ti/Kconfig               |   19 +-
 drivers/net/ethernet/ti/Makefile              |    3 +
 drivers/net/ethernet/ti/am65-cpsw-ethtool.c   |  747 +++++++
 drivers/net/ethernet/ti/am65-cpsw-nuss.c      | 1965 +++++++++++++++++
 drivers/net/ethernet/ti/am65-cpsw-nuss.h      |  143 ++
 drivers/net/ethernet/ti/cpsw_ale.c            |   38 +
 drivers/net/ethernet/ti/cpsw_ale.h            |    4 +
 drivers/net/ethernet/ti/k3-udma-desc-pool.c   |  126 ++
 drivers/net/ethernet/ti/k3-udma-desc-pool.h   |   30 +
 17 files changed, 3487 insertions(+), 2 deletions(-)
 create mode 100644 Documentation/devicetree/bindings/net/ti,k3-am654-cpsw-nuss.yaml
 create mode 100644 drivers/net/ethernet/ti/am65-cpsw-ethtool.c
 create mode 100644 drivers/net/ethernet/ti/am65-cpsw-nuss.c
 create mode 100644 drivers/net/ethernet/ti/am65-cpsw-nuss.h
 create mode 100644 drivers/net/ethernet/ti/k3-udma-desc-pool.c
 create mode 100644 drivers/net/ethernet/ti/k3-udma-desc-pool.h

-- 
2.17.1

Powered by blists - more mailing lists