[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]
Message-ID: <ce79643c-e854-a48f-2faf-f405c310a8a7@codeaurora.org>
Date: Tue, 17 Mar 2020 18:35:31 +0530
From: Akash Asthana <akashast@...eaurora.org>
To: Douglas Anderson <dianders@...omium.org>,
gregkh@...uxfoundation.org
Cc: mka@...omium.org, swboyd@...omium.org, ryandcase@...omium.org,
bjorn.andersson@...aro.org, skakit@...eaurora.org,
rojay@...eaurora.org, mgautam@...eaurora.org,
Andy Gross <agross@...nel.org>,
Doug Anderson <dianders@...gle.com>,
Girish Mahadevan <girishm@...eaurora.org>,
Jiri Slaby <jslaby@...e.com>,
Karthikeyan Ramasubramanian <kramasub@...eaurora.org>,
Sagar Dharia <sdharia@...eaurora.org>,
linux-arm-msm@...r.kernel.org, linux-kernel@...r.kernel.org,
linux-serial@...r.kernel.org
Subject: Re: [PATCH 1/2] tty: serial: qcom_geni_serial: No need to stop tx/rx
on UART shutdown
On 3/14/2020 2:16 AM, Douglas Anderson wrote:
> On a board using qcom_geni_serial I found that I could no longer
> interact with kdb if I got a crash after the "agetty" running on the
> same serial port was killed. This meant that various classes of
> crashes that happened at reboot time were undebuggable.
>
> Reading through the code, I couldn't figure out why qcom_geni_serial
> felt the need to run so much code at port shutdown time. All we need
> to do is disable the interrupt.
>
> After I make this change then a hardcoded kgdb_breakpoint in some late
> shutdown code now allows me to interact with the debugger. I also
> could freely close / re-open the port without problems.
>
> Fixes: c4f528795d1a ("tty: serial: msm_geni_serial: Add serial driver support for GENI based QUP")
> Signed-off-by: Douglas Anderson <dianders@...omium.org>
> ---
Looks good to me.
Reviewed-by: Akash Asthana <akashast@...eaurora.org>
--
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,\na Linux Foundation Collaborative Project
Powered by blists - more mailing lists