| lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
|
Open Source and information security mailing list archives
| ||
|
Message-Id: <1595471649-25675-8-git-send-email-cang@codeaurora.org>
Date: Wed, 22 Jul 2020 19:34:06 -0700
From: Can Guo <cang@...eaurora.org>
To: asutoshd@...eaurora.org, nguyenb@...eaurora.org,
hongwus@...eaurora.org, rnayak@...eaurora.org,
sh425.lee@...sung.com, linux-scsi@...r.kernel.org,
kernel-team@...roid.com, saravanak@...gle.com, salyzyn@...gle.com,
cang@...eaurora.org
Cc: Alim Akhtar <alim.akhtar@...sung.com>,
Avri Altman <avri.altman@....com>,
"James E.J. Bottomley" <jejb@...ux.ibm.com>,
"Martin K. Petersen" <martin.petersen@...cle.com>,
Stanley Chu <stanley.chu@...iatek.com>,
Bean Huo <beanhuo@...ron.com>,
Bart Van Assche <bvanassche@....org>,
Satya Tangirala <satyat@...gle.com>,
linux-kernel@...r.kernel.org (open list)
Subject: [PATCH v5 7/9] scsi: ufs: Recover hba runtime PM error in error handler
Current error handler cannot work well or recover hba runtime PM error if
ufshcd_suspend/resume has failed due to UFS errors, e.g. hibern8 enter/exit
error or SSU cmd error. When this happens, error handler may fail doing
full reset and restore because error handler always assumes that powers,
IRQs and clocks are ready after pm_runtime_get_sync returns, but actually
they are not if ufshcd_reusme fails [1]. Besides, if ufschd_suspend/resume
fails due to UFS error, runtime PM framework saves the error value to
dev.power.runtime_error. After that, hba dev runtime suspend/resume would
not be invoked anymore unless runtime_error is cleared [2].
In case of ufshcd_suspend/resume fails due to UFS errors, for scenario [1],
error handler cannot assume anything of pm_runtime_get_sync, meaning error
handler should explicitly turn ON powers, IRQs and clocks again. To get the
hba runtime PM work as regard for scenario [2], error handler can clear the
runtime_error by calling pm_runtime_set_active() if full reset and restore
succeeds. And, more important, if pm_runtime_set_active() returns no error,
which means runtime_error has been cleared, we also need to resume those
scsi devices under hba in case any of them has failed to be resumed due to
hba runtime resume failure. This is to unblock blk_queue_enter in case
there are bios waiting inside it.
In addition, if ufshcd_resume errors out, ufshcd_release in ufshcd_resume
would be skipped. After hba runtime PM error is recovered in error handler,
we should do ufshcd_release once to get clock gating back to work.
Signed-off-by: Can Guo <cang@...eaurora.org>
---
drivers/scsi/ufs/ufshcd.c | 90 +++++++++++++++++++++++++++++++++++++++++++----
drivers/scsi/ufs/ufshcd.h | 1 +
2 files changed, 85 insertions(+), 6 deletions(-)
diff --git a/drivers/scsi/ufs/ufshcd.c b/drivers/scsi/ufs/ufshcd.c
index c01743a..68705a1 100644
--- a/drivers/scsi/ufs/ufshcd.c
+++ b/drivers/scsi/ufs/ufshcd.c
@@ -15,6 +15,7 @@
#include <linux/of.h>
#include <linux/bitfield.h>
#include <linux/blk-pm.h>
+#include <linux/blkdev.h>
#include "ufshcd.h"
#include "ufs_quirks.h"
#include "unipro.h"
@@ -229,6 +230,10 @@ static irqreturn_t ufshcd_intr(int irq, void *__hba);
static int ufshcd_change_power_mode(struct ufs_hba *hba,
struct ufs_pa_layer_attr *pwr_mode);
static void ufshcd_schedule_eh_work(struct ufs_hba *hba);
+static int ufshcd_setup_hba_vreg(struct ufs_hba *hba, bool on);
+static int ufshcd_setup_vreg(struct ufs_hba *hba, bool on);
+static inline int ufshcd_config_vreg_hpm(struct ufs_hba *hba,
+ struct ufs_vreg *vreg);
static int ufshcd_wb_buf_flush_enable(struct ufs_hba *hba);
static int ufshcd_wb_buf_flush_disable(struct ufs_hba *hba);
static int ufshcd_wb_ctrl(struct ufs_hba *hba, bool enable);
@@ -5553,6 +5558,77 @@ static inline void ufshcd_schedule_eh_work(struct ufs_hba *hba)
}
}
+static void ufshcd_err_handler_prepare(struct ufs_hba *hba)
+{
+ pm_runtime_get_sync(hba->dev);
+ /*
+ * Don't assume anything of pm_runtime_get_sync(), if resume fails,
+ * irq and clocks can be OFF, and powers can be OFF or in LPM.
+ */
+ ufshcd_setup_vreg(hba, true);
+ ufshcd_config_vreg_hpm(hba, hba->vreg_info.vccq);
+ ufshcd_config_vreg_hpm(hba, hba->vreg_info.vccq2);
+ ufshcd_setup_hba_vreg(hba, true);
+ ufshcd_enable_irq(hba);
+
+ ufshcd_hold(hba, false);
+ if (!ufshcd_is_clkgating_allowed(hba))
+ ufshcd_setup_clocks(hba, true);
+
+ if (ufshcd_is_clkscaling_supported(hba)) {
+ cancel_work_sync(&hba->clk_scaling.suspend_work);
+ cancel_work_sync(&hba->clk_scaling.resume_work);
+ ufshcd_suspend_clkscaling(hba);
+ }
+}
+
+static void ufshcd_err_handler_unprepare(struct ufs_hba *hba)
+{
+ /* If clk_gating is held by pm ops, release it */
+ if (pm_runtime_active(hba->dev) && hba->clk_gating.held_by_pm) {
+ hba->clk_gating.held_by_pm = false;
+ ufshcd_release(hba);
+ }
+ ufshcd_release(hba);
+ if (ufshcd_is_clkscaling_supported(hba))
+ ufshcd_resume_clkscaling(hba);
+ pm_runtime_put(hba->dev);
+}
+
+#ifdef CONFIG_PM
+static void ufshcd_recover_pm_error(struct ufs_hba *hba)
+{
+ struct Scsi_Host *shost = hba->host;
+ struct scsi_device *sdev;
+ struct request_queue *q;
+ int ret;
+
+ /*
+ * Set RPM status of hba device to RPM_ACTIVE,
+ * this also clears its runtime error.
+ */
+ ret = pm_runtime_set_active(hba->dev);
+ /*
+ * If hba device had runtime error, we also need to resume those
+ * scsi devices under hba in case any of them has failed to be
+ * resumed due to hba runtime resume failure. This is to unblock
+ * blk_queue_enter in case there are bios waiting inside it.
+ */
+ if (!ret) {
+ list_for_each_entry(sdev, &shost->__devices, siblings) {
+ q = sdev->request_queue;
+ if (q->dev && (q->rpm_status == RPM_SUSPENDED ||
+ q->rpm_status == RPM_SUSPENDING))
+ pm_request_resume(q->dev);
+ }
+ }
+}
+#else
+static inline void ufshcd_recover_pm_error(struct ufs_hba *hba)
+{
+}
+#endif
+
/**
* ufshcd_err_handler - handle UFS errors that require s/w attention
* @work: pointer to work structure
@@ -5580,9 +5656,7 @@ static void ufshcd_err_handler(struct work_struct *work)
}
ufshcd_set_eh_in_progress(hba);
spin_unlock_irqrestore(hba->host->host_lock, flags);
- pm_runtime_get_sync(hba->dev);
- ufshcd_hold(hba, false);
-
+ ufshcd_err_handler_prepare(hba);
spin_lock_irqsave(hba->host->host_lock, flags);
hba->ufshcd_state = UFSHCD_STATE_RESET;
@@ -5661,10 +5735,12 @@ static void ufshcd_err_handler(struct work_struct *work)
hba->force_reset = false;
spin_unlock_irqrestore(hba->host->host_lock, flags);
err = ufshcd_reset_and_restore(hba);
- spin_lock_irqsave(hba->host->host_lock, flags);
if (err)
dev_err(hba->dev, "%s: reset and restore failed with err %d\n",
__func__, err);
+ else
+ ufshcd_recover_pm_error(hba);
+ spin_lock_irqsave(hba->host->host_lock, flags);
}
skip_err_handling:
@@ -5679,8 +5755,7 @@ static void ufshcd_err_handler(struct work_struct *work)
ufshcd_clear_eh_in_progress(hba);
spin_unlock_irqrestore(hba->host->host_lock, flags);
ufshcd_scsi_unblock_requests(hba);
- ufshcd_release(hba);
- pm_runtime_put_sync(hba->dev);
+ ufshcd_err_handler_unprepare(hba);
}
/**
@@ -8232,6 +8307,7 @@ static int ufshcd_suspend(struct ufs_hba *hba, enum ufs_pm_op pm_op)
* just gate the clocks.
*/
ufshcd_hold(hba, false);
+ hba->clk_gating.held_by_pm = true;
hba->clk_gating.is_suspended = true;
if (hba->clk_scaling.is_allowed) {
@@ -8351,6 +8427,7 @@ static int ufshcd_suspend(struct ufs_hba *hba, enum ufs_pm_op pm_op)
hba->clk_gating.is_suspended = false;
hba->dev_info.b_rpm_dev_flush_capable = false;
ufshcd_release(hba);
+ hba->clk_gating.held_by_pm = false;
out:
if (hba->dev_info.b_rpm_dev_flush_capable) {
schedule_delayed_work(&hba->rpm_dev_flush_recheck_work,
@@ -8457,6 +8534,7 @@ static int ufshcd_resume(struct ufs_hba *hba, enum ufs_pm_op pm_op)
/* Schedule clock gating in case of no access to UFS device yet */
ufshcd_release(hba);
+ hba->clk_gating.held_by_pm = false;
goto out;
diff --git a/drivers/scsi/ufs/ufshcd.h b/drivers/scsi/ufs/ufshcd.h
index 83e5cd9..585e58b 100644
--- a/drivers/scsi/ufs/ufshcd.h
+++ b/drivers/scsi/ufs/ufshcd.h
@@ -354,6 +354,7 @@ struct ufs_clk_gating {
struct device_attribute delay_attr;
struct device_attribute enable_attr;
bool is_enabled;
+ bool held_by_pm;
int active_reqs;
struct workqueue_struct *clk_gating_workq;
};
--
Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum, a Linux Foundation Collaborative Project.
Powered by blists - more mailing lists