lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
Open Source and information security mailing list archives
| ||
|
Date: Sat, 31 Oct 2020 14:16:07 +0200 From: Alexandru Ardelean <ardeleanalex@...il.com> To: Andrew Lunn <andrew@...n.ch> Cc: Alexandru Ardelean <alexandru.ardelean@...log.com>, netdev@...r.kernel.org, LKML <linux-kernel@...r.kernel.org>, Heiner Kallweit <hkallweit1@...il.com>, linux@...linux.org.uk, David Miller <davem@...emloft.net>, Jakub Kicinski <kuba@...nel.org> Subject: Re: [PATCH v2 1/2] net: phy: adin: disable diag clock & disable standby mode in config_aneg On Sat, Oct 24, 2020 at 1:43 AM Andrew Lunn <andrew@...n.ch> wrote: > > On Thu, Oct 22, 2020 at 10:45:50AM +0300, Alexandru Ardelean wrote: > > When the PHY powers up, the diagnostics clock isn't enabled (bit 2 in > > register PHY_CTRL_1 (0x0012)). > > Also, the PHY is not in standby mode, so bit 13 in PHY_CTRL_3 (0x0017) is > > always set at power up. > > > > The standby mode and the diagnostics clock are both meant to be for the > > cable diagnostics feature of the PHY (in phylib this would be equivalent to > > the cable-test support), and for the frame-generator feature of the PHY. > > > > In standby mode, the PHY doesn't negotiate links or manage links. > > > > To use the cable diagnostics/test (or frame-generator), the PHY must be > > first set in standby mode, so that the link operation doesn't interfere. > > Then, the diagnostics clock must be enabled. > > > > For the cable-test feature, when the operation finishes, the PHY goes into > > PHY_UP state, and the config_aneg hook is called. > > > > For the ADIN PHY, we need to make sure that during autonegotiation > > configuration/setup the PHY is removed from standby mode and the > > diagnostics clock is disabled, so that normal operation is resumed. > > > > This change does that by moving the set of the ADIN1300_LINKING_EN bit (2) > > in the config_aneg (to disable standby mode). > > Previously, this was set in the downshift setup, because the downshift > > retry value and the ADIN1300_LINKING_EN are in the same register. > > > > And the ADIN1300_DIAG_CLK_EN bit (13) is cleared, to disable the > > diagnostics clock. > > > > Signed-off-by: Alexandru Ardelean <alexandru.ardelean@...log.com> > > Reviewed-by: Andrew Lunn <andrew@...n.ch> So, then re-send for this or just this patch ping? Naturally, this is for net-next. I don't mind doing either way. Thanks Alex > > Andrew
Powered by blists - more mailing lists