[<prev] [next>] [thread-next>] [day] [month] [year] [list]
Message-Id: <20201116233757.15409-1-mark.tomlinson@alliedtelesis.co.nz>
Date: Tue, 17 Nov 2020 12:37:57 +1300
From: Mark Tomlinson <mark.tomlinson@...iedtelesis.co.nz>
To: rjui@...adcom.com, sbranden@...adcom.com
Cc: linux-gpio@...r.kernel.org, linux-kernel@...r.kernel.org,
Mark Tomlinson <mark.tomlinson@...iedtelesis.co.nz>
Subject: [PATCH] pinctrl: bcm: pinctrl-nsp-gpio: Fix setting GPIO as output
When setting a GPIO pin to an output, it is important to set the value
correctly before enabling the output so that a glitch is not seen on the
pin. This glitch may be very short, but can be important if this is a
reset signal.
Fixes: 8bfcbbbcabe0 ("pinctrl: nsp: add gpio-a driver support for Broadcom NSP SoC")
Signed-off-by: Mark Tomlinson <mark.tomlinson@...iedtelesis.co.nz>
---
drivers/pinctrl/bcm/pinctrl-nsp-gpio.c | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)
diff --git a/drivers/pinctrl/bcm/pinctrl-nsp-gpio.c b/drivers/pinctrl/bcm/pinctrl-nsp-gpio.c
index a00a42a61a90..942f04ca4868 100644
--- a/drivers/pinctrl/bcm/pinctrl-nsp-gpio.c
+++ b/drivers/pinctrl/bcm/pinctrl-nsp-gpio.c
@@ -289,8 +289,8 @@ static int nsp_gpio_direction_output(struct gpio_chip *gc, unsigned gpio,
unsigned long flags;
raw_spin_lock_irqsave(&chip->lock, flags);
- nsp_set_bit(chip, REG, NSP_GPIO_OUT_EN, gpio, true);
nsp_set_bit(chip, REG, NSP_GPIO_DATA_OUT, gpio, !!(val));
+ nsp_set_bit(chip, REG, NSP_GPIO_OUT_EN, gpio, true);
raw_spin_unlock_irqrestore(&chip->lock, flags);
dev_dbg(chip->dev, "gpio:%u set output, value:%d\n", gpio, val);
--
2.29.2
Powered by blists - more mailing lists