| lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
|
Open Source and information security mailing list archives
| ||
|
Message-ID: <5849ce60595aef1018bdde7dcfb54a7397597545.1606830377.git.Adam.Ward.opensource@diasemi.com>
Date: Tue, 1 Dec 2020 13:52:32 +0000
From: Adam Ward <Adam.Ward.opensource@...semi.com>
To: Mark Brown <broonie@...nel.org>, Rob Herring <robh+dt@...nel.org>
CC: Liam Girdwood <lgirdwood@...il.com>,
Vincent Whitchurch <vincent.whitchurch@...s.com>,
<linux-kernel@...r.kernel.org>, <devicetree@...r.kernel.org>,
Support Opensource <support.opensource@...semi.com>
Subject: [PATCH V4 06/10] regulator: da9121: Add support for device variants
via devicetree
Add devicetree configuration and device variant parameters. Use the latter
to enable the check and use of parameters specific to dual buck variants.
Signed-off-by: Adam Ward <Adam.Ward.opensource@...semi.com>
---
drivers/regulator/da9121-regulator.c | 119 +++++++++++++++++++++++++++++++++++
include/linux/regulator/da9121.h | 11 ++++
2 files changed, 130 insertions(+)
diff --git a/drivers/regulator/da9121-regulator.c b/drivers/regulator/da9121-regulator.c
index a717e2b..1f74371 100644
--- a/drivers/regulator/da9121-regulator.c
+++ b/drivers/regulator/da9121-regulator.c
@@ -14,6 +14,7 @@
// Copyright (C) 2020 Dialog Semiconductor
#include <linux/of_device.h>
+#include <linux/of_gpio.h>
#include <linux/regulator/of_regulator.h>
#include <linux/regulator/machine.h>
#include <linux/regulator/driver.h>
@@ -28,10 +29,67 @@
/* Chip data */
struct da9121 {
struct device *dev;
+ struct da9121_pdata *pdata;
struct regmap *regmap;
int variant_id;
};
+/* Define ranges for different variants, enabling translation to/from
+ * registers. Maximums give scope to allow for transients.
+ */
+struct da9121_range {
+ int val_min;
+ int val_max;
+ int val_stp;
+ int reg_min;
+ int reg_max;
+};
+
+struct da9121_range da9121_10A_2phase_current = {
+ .val_min = 7000000,
+ .val_max = 20000000,
+ .val_stp = 1000000,
+ .reg_min = 1,
+ .reg_max = 14,
+};
+
+struct da9121_range da9121_6A_2phase_current = {
+ .val_min = 7000000,
+ .val_max = 12000000,
+ .val_stp = 1000000,
+ .reg_min = 1,
+ .reg_max = 6,
+};
+
+struct da9121_range da9121_5A_1phase_current = {
+ .val_min = 3500000,
+ .val_max = 10000000,
+ .val_stp = 500000,
+ .reg_min = 1,
+ .reg_max = 14,
+};
+
+struct da9121_range da9121_3A_1phase_current = {
+ .val_min = 3500000,
+ .val_max = 6000000,
+ .val_stp = 500000,
+ .reg_min = 1,
+ .reg_max = 6,
+};
+
+struct da9121_variant_info {
+ int num_bucks;
+ int num_phases;
+ struct da9121_range *current_range;
+};
+
+static const struct da9121_variant_info variant_parameters[] = {
+ { 1, 2, &da9121_10A_2phase_current }, //DA9121_TYPE_DA9121_DA9130
+ { 2, 1, &da9121_3A_1phase_current }, //DA9121_TYPE_DA9220_DA9132
+ { 2, 1, &da9121_5A_1phase_current }, //DA9121_TYPE_DA9122_DA9131
+ { 1, 2, &da9121_6A_2phase_current }, //DA9121_TYPE_DA9217
+};
+
static const struct regulator_ops da9121_buck_ops = {
.enable = regulator_enable_regmap,
.disable = regulator_disable_regmap,
@@ -46,6 +104,59 @@ struct da9121 {
[DA9121_IDX_BUCK2] = { .name = "buck2" },
};
+static int da9121_of_parse_cb(struct device_node *np,
+ const struct regulator_desc *desc,
+ struct regulator_config *config)
+{
+ struct da9121 *chip = config->driver_data;
+ struct da9121_pdata *pdata;
+ struct gpio_desc *ena_gpiod;
+
+ if (chip->pdata == NULL) {
+ pdata = devm_kzalloc(chip->dev, sizeof(*pdata), GFP_KERNEL);
+ if (!pdata)
+ return -ENOMEM;
+ } else {
+ pdata = chip->pdata;
+ }
+
+ pdata->num_buck++;
+
+ if (pdata->num_buck > variant_parameters[chip->variant_id].num_bucks) {
+ dev_err(chip->dev, "Error: excessive regulators for device\n");
+ return -ENODEV;
+ }
+
+ ena_gpiod = fwnode_gpiod_get_index(of_fwnode_handle(np), "enable", 0,
+ GPIOD_OUT_HIGH |
+ GPIOD_FLAGS_BIT_NONEXCLUSIVE,
+ "da9121-enable");
+ if (!IS_ERR(ena_gpiod))
+ config->ena_gpiod = ena_gpiod;
+
+ if (variant_parameters[chip->variant_id].num_bucks == 2) {
+ uint32_t ripple_cancel;
+ uint32_t ripple_reg;
+ int ret;
+
+ if (of_property_read_u32(da9121_matches[pdata->num_buck].of_node,
+ "dlg,ripple-cancel", &ripple_cancel)) {
+ if (pdata->num_buck > 1)
+ ripple_reg = DA9xxx_REG_BUCK_BUCK2_7;
+ else
+ ripple_reg = DA9121_REG_BUCK_BUCK1_7;
+
+ ret = regmap_update_bits(chip->regmap, ripple_reg,
+ DA9xxx_MASK_BUCK_BUCKx_7_CHx_RIPPLE_CANCEL,
+ ripple_cancel);
+ if (ret < 0)
+ dev_err(chip->dev, "Cannot set ripple mode, err: %d\n", ret);
+ }
+ }
+
+ return 0;
+}
+
#define DA9121_MIN_MV 300
#define DA9121_MAX_MV 1900
#define DA9121_STEP_MV 10
@@ -57,6 +168,7 @@ struct da9121 {
.id = DA9121_IDX_BUCK1,
.name = "da9121",
.of_match = "buck1",
+ .of_parse_cb = da9121_of_parse_cb,
.owner = THIS_MODULE,
.regulators_node = of_match_ptr("regulators"),
.ops = &da9121_buck_ops,
@@ -80,6 +192,7 @@ struct da9121 {
.id = DA9121_IDX_BUCK1,
.name = "DA9220/DA9132 BUCK1",
.of_match = "buck1",
+ .of_parse_cb = da9121_of_parse_cb,
.owner = THIS_MODULE,
.regulators_node = of_match_ptr("regulators"),
.ops = &da9121_buck_ops,
@@ -97,6 +210,7 @@ struct da9121 {
.id = DA9121_IDX_BUCK2,
.name = "DA9220/DA9132 BUCK2",
.of_match = "buck2",
+ .of_parse_cb = da9121_of_parse_cb,
.owner = THIS_MODULE,
.regulators_node = of_match_ptr("regulators"),
.ops = &da9121_buck_ops,
@@ -117,6 +231,7 @@ struct da9121 {
.id = DA9121_IDX_BUCK1,
.name = "DA9122/DA9131 BUCK1",
.of_match = "buck1",
+ .of_parse_cb = da9121_of_parse_cb,
.owner = THIS_MODULE,
.regulators_node = of_match_ptr("regulators"),
.ops = &da9121_buck_ops,
@@ -134,6 +249,7 @@ struct da9121 {
.id = DA9121_IDX_BUCK2,
.name = "DA9122/DA9131 BUCK2",
.of_match = "buck2",
+ .of_parse_cb = da9121_of_parse_cb,
.owner = THIS_MODULE,
.regulators_node = of_match_ptr("regulators"),
.ops = &da9121_buck_ops,
@@ -153,6 +269,7 @@ struct da9121 {
.id = DA9121_IDX_BUCK1,
.name = "DA9217 BUCK1",
.of_match = "buck1",
+ .of_parse_cb = da9121_of_parse_cb,
.owner = THIS_MODULE,
.regulators_node = of_match_ptr("regulators"),
.ops = &da9121_buck_ops,
@@ -415,6 +532,7 @@ static int da9121_i2c_probe(struct i2c_client *i2c,
goto error;
}
+ chip->pdata = i2c->dev.platform_data;
chip->variant_id = da9121_of_get_id(&i2c->dev);
ret = da9121_assign_chip_model(i2c, chip);
@@ -422,6 +540,7 @@ static int da9121_i2c_probe(struct i2c_client *i2c,
goto error;
config.dev = &i2c->dev;
+ config.driver_data = chip;
config.of_node = dev->of_node;
config.regmap = chip->regmap;
diff --git a/include/linux/regulator/da9121.h b/include/linux/regulator/da9121.h
index c31180d..62d9d257 100644
--- a/include/linux/regulator/da9121.h
+++ b/include/linux/regulator/da9121.h
@@ -16,10 +16,21 @@
#ifndef __LINUX_REGULATOR_DA9121_H
#define __LINUX_REGULATOR_DA9121_H
+#include <linux/regulator/machine.h>
+
+struct gpio_desc;
+
enum {
DA9121_IDX_BUCK1,
DA9121_IDX_BUCK2,
DA9121_IDX_MAX
};
+struct da9121_pdata {
+ int num_buck;
+ struct gpio_desc *gpiod_ren[DA9121_IDX_MAX];
+ struct device_node *reg_node[DA9121_IDX_MAX];
+ struct regulator_init_data *init_data[DA9121_IDX_MAX];
+};
+
#endif
--
1.9.1
Powered by blists - more mailing lists