[<prev] [next>] [thread-next>] [day] [month] [year] [list]
Message-Id: <df3f5c4fc6e43c55429fd3662a636036a21eed49.1607363522.git.stefan@agner.ch>
Date: Mon, 7 Dec 2020 18:57:59 +0100
From: Stefan Agner <stefan@...er.ch>
To: khilman@...libre.com
Cc: robh+dt@...nel.org, narmstrong@...libre.com, jbrunet@...libre.com,
martin.blumenstingl@...glemail.com, christianshewitt@...il.com,
jian.hu@...ogic.com, devicetree@...r.kernel.org,
linux-arm-kernel@...ts.infradead.org,
linux-amlogic@...ts.infradead.org, linux-kernel@...r.kernel.org,
Stefan Agner <stefan@...er.ch>
Subject: [PATCH v3 1/5] arm64: dts: meson: g12b: odroid-n2: fix PHY deassert timing requirements
According to the datasheet (Rev. 1.9) the RTL8211F requires at least
72ms "for internal circuits settling time" before accessing the PHY
registers. This fixes an issue where the Ethernet link doesn't come up
when using ip link set down/up:
[ 29.360965] meson8b-dwmac ff3f0000.ethernet eth0: Link is Down
[ 34.569012] meson8b-dwmac ff3f0000.ethernet eth0: PHY [0.0:00] driver [RTL8211F Gigabit Ethernet] (irq=31)
[ 34.676732] meson8b-dwmac ff3f0000.ethernet: Failed to reset the dma
[ 34.678874] meson8b-dwmac ff3f0000.ethernet eth0: stmmac_hw_setup: DMA engine initialization failed
[ 34.687850] meson8b-dwmac ff3f0000.ethernet eth0: stmmac_open: Hw setup failed
Fixes: 658e4129bb81 ("arm64: dts: meson: g12b: odroid-n2: add the Ethernet PHY reset line")
Reviewed-by: Martin Blumenstingl <martin.blumenstingl@...glemail.com>
Signed-off-by: Stefan Agner <stefan@...er.ch>
---
arch/arm64/boot/dts/amlogic/meson-g12b-odroid-n2.dtsi | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)
diff --git a/arch/arm64/boot/dts/amlogic/meson-g12b-odroid-n2.dtsi b/arch/arm64/boot/dts/amlogic/meson-g12b-odroid-n2.dtsi
index 6982632ae646..39a09661c5f6 100644
--- a/arch/arm64/boot/dts/amlogic/meson-g12b-odroid-n2.dtsi
+++ b/arch/arm64/boot/dts/amlogic/meson-g12b-odroid-n2.dtsi
@@ -413,7 +413,7 @@ external_phy: ethernet-phy@0 {
max-speed = <1000>;
reset-assert-us = <10000>;
- reset-deassert-us = <30000>;
+ reset-deassert-us = <80000>;
reset-gpios = <&gpio GPIOZ_15 (GPIO_ACTIVE_LOW | GPIO_OPEN_DRAIN)>;
interrupt-parent = <&gpio_intc>;
--
2.29.2
Powered by blists - more mailing lists