| lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
|
Open Source and information security mailing list archives
| ||
|
Date: Wed, 09 Dec 2020 15:19:17 +0800
From: Can Guo <cang@...eaurora.org>
To: Ziqi Chen <ziqichen@...eaurora.org>
Cc: asutoshd@...eaurora.org, nguyenb@...eaurora.org,
hongwus@...eaurora.org, rnayak@...eaurora.org,
vinholikatti@...il.com, jejb@...ux.vnet.ibm.com,
martin.petersen@...cle.com, linux-scsi@...r.kernel.org,
kernel-team@...roid.com, saravanak@...gle.com, salyzyn@...gle.com,
Andy Gross <agross@...nel.org>,
Bjorn Andersson <bjorn.andersson@...aro.org>,
Alim Akhtar <alim.akhtar@...sung.com>,
Avri Altman <avri.altman@....com>,
"James E.J. Bottomley" <jejb@...ux.ibm.com>,
Stanley Chu <stanley.chu@...iatek.com>,
Bean Huo <beanhuo@...ron.com>,
Bart Van Assche <bvanassche@....org>,
Adrian Hunter <adrian.hunter@...el.com>,
Satya Tangirala <satyat@...gle.com>,
linux-arm-msm@...r.kernel.org, linux-kernel@...r.kernel.org
Subject: Re: [PATCH v1 1/1] scsi: ufs: Fix ufs power down/on specs violation
On 2020-12-09 15:09, Ziqi Chen wrote:
> As per specs, e.g, JESD220E chapter 7.2, while powering
> off/on the ufs device, RST_N signal and REF_CLK signal
> should be between VSS(Ground) and VCCQ/VCCQ2.
>
> Power down:
> 1. Assert RST_N low
> 2. Turn-off REF_CLK
> 3. Turn-off VCC
> 4. Turn-off VCCQ/VCCQ2.
> power on:
> 1. Turn-on VCC
> 2. Turn-on VCCQ/VCCQ2
> 3. Turn-On REF_CLK
> 4. Deassert RST_N high.
>
> Signed-off-by: Ziqi Chen <ziqichen@...eaurora.org>
> ---
> drivers/scsi/ufs/ufs-qcom.c | 14 ++++++++++----
> drivers/scsi/ufs/ufshcd.c | 19 +++++++++----------
> drivers/scsi/ufs/ufshcd.h | 4 ++--
> 3 files changed, 21 insertions(+), 16 deletions(-)
>
> diff --git a/drivers/scsi/ufs/ufs-qcom.c b/drivers/scsi/ufs/ufs-qcom.c
> index 1e434cc..5ed3a63d 100644
> --- a/drivers/scsi/ufs/ufs-qcom.c
> +++ b/drivers/scsi/ufs/ufs-qcom.c
> @@ -582,6 +582,9 @@ static int ufs_qcom_suspend(struct ufs_hba *hba,
> enum ufs_pm_op pm_op)
> ufs_qcom_disable_lane_clks(host);
> phy_power_off(phy);
>
> + if (hba->vops && hba->vops->device_reset)
> + hba->vops->device_reset(hba, false);
> +
Can you make a new wrapper func to do this? ufs-qcom.c is the vendor
driver, why call hba->vops->func() in vendor driver?
> } else if (!ufs_qcom_is_link_active(hba)) {
> ufs_qcom_disable_lane_clks(host);
> }
> @@ -1400,10 +1403,11 @@ static void ufs_qcom_dump_dbg_regs(struct
> ufs_hba *hba)
> /**
> * ufs_qcom_device_reset() - toggle the (optional) device reset line
> * @hba: per-adapter instance
> + * @toggle: need pulling up or not
> *
> * Toggles the (optional) reset line to reset the attached device.
> */
> -static int ufs_qcom_device_reset(struct ufs_hba *hba)
> +static int ufs_qcom_device_reset(struct ufs_hba *hba, bool toggle)
> {
> struct ufs_qcom_host *host = ufshcd_get_variant(hba);
>
> @@ -1416,10 +1420,12 @@ static int ufs_qcom_device_reset(struct ufs_hba
> *hba)
> * be on the safe side.
> */
> gpiod_set_value_cansleep(host->device_reset, 1);
> - usleep_range(10, 15);
>
> - gpiod_set_value_cansleep(host->device_reset, 0);
> - usleep_range(10, 15);
> + if (toggle) {
> + usleep_range(10, 15);
> + gpiod_set_value_cansleep(host->device_reset, 0);
> + usleep_range(10, 15);
> + }
>
> return 0;
> }
> diff --git a/drivers/scsi/ufs/ufshcd.c b/drivers/scsi/ufs/ufshcd.c
> index 92d433d..5ab1c02 100644
> --- a/drivers/scsi/ufs/ufshcd.c
> +++ b/drivers/scsi/ufs/ufshcd.c
> @@ -8633,8 +8633,6 @@ static int ufshcd_suspend(struct ufs_hba *hba,
> enum ufs_pm_op pm_op)
> if (ret)
> goto set_dev_active;
>
> - ufshcd_vreg_set_lpm(hba);
> -
> disable_clks:
> /*
> * Call vendor specific suspend callback. As these callbacks may
> access
> @@ -8664,6 +8662,7 @@ static int ufshcd_suspend(struct ufs_hba *hba,
> enum ufs_pm_op pm_op)
>
> /* Put the host controller in low power mode if possible */
> ufshcd_hba_vreg_set_lpm(hba);
> + ufshcd_vreg_set_lpm(hba);
> goto out;
>
> set_link_active:
> @@ -8729,18 +8728,18 @@ static int ufshcd_resume(struct ufs_hba *hba,
> enum ufs_pm_op pm_op)
> old_link_state = hba->uic_link_state;
>
> ufshcd_hba_vreg_set_hpm(hba);
> + ret = ufshcd_vreg_set_hpm(hba);
> + if (ret)
> + goto out;
> +
> /* Make sure clocks are enabled before accessing controller */
> ret = ufshcd_setup_clocks(hba, true);
> if (ret)
> - goto out;
> + goto disable_vreg;
>
> /* enable the host irq as host controller would be active soon */
> ufshcd_enable_irq(hba);
>
> - ret = ufshcd_vreg_set_hpm(hba);
> - if (ret)
> - goto disable_irq_and_vops_clks;
> -
> /*
> * Call vendor specific resume callback. As these callbacks may
> access
> * vendor specific host controller register space call them when the
> @@ -8748,7 +8747,7 @@ static int ufshcd_resume(struct ufs_hba *hba,
> enum ufs_pm_op pm_op)
> */
> ret = ufshcd_vops_resume(hba, pm_op);
> if (ret)
> - goto disable_vreg;
> + goto disable_irq_and_vops_clks;
>
> /* For DeepSleep, the only supported option is to have the link off
> */
> WARN_ON(ufshcd_is_ufs_dev_deepsleep(hba) &&
> !ufshcd_is_link_off(hba));
> @@ -8815,8 +8814,6 @@ static int ufshcd_resume(struct ufs_hba *hba,
> enum ufs_pm_op pm_op)
> ufshcd_link_state_transition(hba, old_link_state, 0);
> vendor_suspend:
> ufshcd_vops_suspend(hba, pm_op);
> -disable_vreg:
> - ufshcd_vreg_set_lpm(hba);
> disable_irq_and_vops_clks:
> ufshcd_disable_irq(hba);
> if (hba->clk_scaling.is_allowed)
> @@ -8827,6 +8824,8 @@ static int ufshcd_resume(struct ufs_hba *hba,
> enum ufs_pm_op pm_op)
> trace_ufshcd_clk_gating(dev_name(hba->dev),
> hba->clk_gating.state);
> }
> +disable_vreg:
> + ufshcd_vreg_set_lpm(hba);
> out:
> hba->pm_op_in_progress = 0;
> if (ret)
> diff --git a/drivers/scsi/ufs/ufshcd.h b/drivers/scsi/ufs/ufshcd.h
> index 61344c4..47c7dab6 100644
> --- a/drivers/scsi/ufs/ufshcd.h
> +++ b/drivers/scsi/ufs/ufshcd.h
> @@ -323,7 +323,7 @@ struct ufs_hba_variant_ops {
> int (*resume)(struct ufs_hba *, enum ufs_pm_op);
> void (*dbg_register_dump)(struct ufs_hba *hba);
> int (*phy_initialization)(struct ufs_hba *);
> - int (*device_reset)(struct ufs_hba *hba);
> + int (*device_reset)(struct ufs_hba *hba, bool);
> void (*config_scaling_param)(struct ufs_hba *hba,
> struct devfreq_dev_profile *profile,
> void *data);
> @@ -1211,7 +1211,7 @@ static inline void
> ufshcd_vops_dbg_register_dump(struct ufs_hba *hba)
> static inline void ufshcd_vops_device_reset(struct ufs_hba *hba)
> {
> if (hba->vops && hba->vops->device_reset) {
> - int err = hba->vops->device_reset(hba);
> + int err = hba->vops->device_reset(hba, true);
>
> if (!err)
> ufshcd_set_ufs_dev_active(hba);
Powered by blists - more mailing lists