| lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
|
Open Source and information security mailing list archives
| ||
|
Message-ID: <20201218190020.1572-3-erwan.leray@foss.st.com>
Date: Fri, 18 Dec 2020 20:00:13 +0100
From: Erwan Le Ray <erwan.leray@...s.st.com>
To: Greg Kroah-Hartman <gregkh@...uxfoundation.org>,
Jiri Slaby <jslaby@...e.com>, Rob Herring <robh+dt@...nel.org>,
Maxime Coquelin <mcoquelin.stm32@...il.com>,
Alexandre Torgue <alexandre.torgue@...s.st.com>
CC: <linux-serial@...r.kernel.org>, <devicetree@...r.kernel.org>,
<linux-stm32@...md-mailman.stormreply.com>,
<linux-arm-kernel@...ts.infradead.org>,
<linux-kernel@...r.kernel.org>,
Erwan Le Ray <erwan.leray@...s.st.com>,
Fabrice Gasnier <fabrice.gasnier@...s.st.com>,
Valentin Caron <valentin.caron@...s.st.com>
Subject: [PATCH 2/8] serial: stm32: fix code cleaning warnings and checks
Fixes checkpatch --strict warnings and checks:
- checkpatch --strict "Unnecessary parentheses"
- checkpatch --strict "Blank lines aren't necessary before a close brace
- checkpatch --strict "Alignment should match open parenthesis"
- checkpatch --strict "Please don't use multiple blank lines"
- checkpatch --strict "Comparison to NULL could be written ..."
- visual check code ordering warning
Signed-off-by: Erwan Le Ray <erwan.leray@...s.st.com>
diff --git a/drivers/tty/serial/stm32-usart.c b/drivers/tty/serial/stm32-usart.c
index 6248304a001f..a0ef86d71317 100644
--- a/drivers/tty/serial/stm32-usart.c
+++ b/drivers/tty/serial/stm32-usart.c
@@ -176,8 +176,7 @@ static int stm32_pending_rx(struct uart_port *port, u32 *sr, int *last_res,
status = dmaengine_tx_status(stm32_port->rx_ch,
stm32_port->rx_ch->cookie,
&state);
- if ((status == DMA_IN_PROGRESS) &&
- (*last_res != state.residue))
+ if (status == DMA_IN_PROGRESS && (*last_res != state.residue))
return 1;
else
return 0;
@@ -464,7 +463,7 @@ static irqreturn_t stm32_interrupt(int irq, void *ptr)
writel_relaxed(USART_ICR_RTOCF,
port->membase + ofs->icr);
- if ((sr & USART_SR_WUF) && (ofs->icr != UNDEF_REG))
+ if ((sr & USART_SR_WUF) && ofs->icr != UNDEF_REG)
writel_relaxed(USART_ICR_WUCF,
port->membase + ofs->icr);
@@ -620,7 +619,6 @@ static void stm32_stop_rx(struct uart_port *port)
stm32_clr_bits(port, ofs->cr1, stm32_port->cr1_irq);
if (stm32_port->cr3_irq)
stm32_clr_bits(port, ofs->cr3, stm32_port->cr3_irq);
-
}
/* Handle breaks - ignored by us */
@@ -724,7 +722,7 @@ static unsigned int stm32_get_databits(struct ktermios *termios)
}
static void stm32_set_termios(struct uart_port *port, struct ktermios *termios,
- struct ktermios *old)
+ struct ktermios *old)
{
struct stm32_port *stm32_port = to_stm32_port(port);
struct stm32_usart_offsets *ofs = &stm32_port->info->ofs;
@@ -923,7 +921,7 @@ stm32_verify_port(struct uart_port *port, struct serial_struct *ser)
}
static void stm32_pm(struct uart_port *port, unsigned int state,
- unsigned int oldstate)
+ unsigned int oldstate)
{
struct stm32_port *stm32port = container_of(port,
struct stm32_port, port);
@@ -973,18 +971,17 @@ static int stm32_init_port(struct stm32_port *stm32port,
struct resource *res;
int ret;
+ ret = platform_get_irq(pdev, 0);
+ if (ret <= 0)
+ return ret ? : -ENODEV;
+
port->iotype = UPIO_MEM;
port->flags = UPF_BOOT_AUTOCONF;
port->ops = &stm32_uart_ops;
port->dev = &pdev->dev;
port->fifosize = stm32port->info->cfg.fifosize;
port->has_sysrq = IS_ENABLED(CONFIG_SERIAL_STM32_CONSOLE);
-
- ret = platform_get_irq(pdev, 0);
- if (ret <= 0)
- return ret ? : -ENODEV;
port->irq = ret;
-
port->rs485_config = stm32_config_rs485;
ret = stm32_init_rs485(port, pdev);
@@ -1101,8 +1098,8 @@ static int stm32_of_dma_rx_probe(struct stm32_port *stm32port,
return -ENODEV;
}
stm32port->rx_buf = dma_alloc_coherent(&pdev->dev, RX_BUF_L,
- &stm32port->rx_dma_buf,
- GFP_KERNEL);
+ &stm32port->rx_dma_buf,
+ GFP_KERNEL);
if (!stm32port->rx_buf) {
ret = -ENOMEM;
goto alloc_err;
@@ -1177,8 +1174,8 @@ static int stm32_of_dma_tx_probe(struct stm32_port *stm32port,
return -ENODEV;
}
stm32port->tx_buf = dma_alloc_coherent(&pdev->dev, TX_BUF_L,
- &stm32port->tx_dma_buf,
- GFP_KERNEL);
+ &stm32port->tx_dma_buf,
+ GFP_KERNEL);
if (!stm32port->tx_buf) {
ret = -ENOMEM;
goto alloc_err;
@@ -1322,7 +1319,6 @@ static int stm32_serial_remove(struct platform_device *pdev)
return err;
}
-
#ifdef CONFIG_SERIAL_STM32_CONSOLE
static void stm32_console_putchar(struct uart_port *port, int ch)
{
@@ -1335,7 +1331,8 @@ static void stm32_console_putchar(struct uart_port *port, int ch)
writel_relaxed(ch, port->membase + ofs->tdr);
}
-static void stm32_console_write(struct console *co, const char *s, unsigned cnt)
+static void stm32_console_write(struct console *co, const char *s,
+ unsigned int cnt)
{
struct uart_port *port = &stm32_ports[co->index].port;
struct stm32_port *stm32_port = to_stm32_port(port);
@@ -1388,7 +1385,7 @@ static int stm32_console_setup(struct console *co, char *options)
* this to be called during the uart port registration when the
* driver gets probed and the port should be mapped at that point.
*/
- if (stm32port->port.mapbase == 0 || stm32port->port.membase == NULL)
+ if (stm32port->port.mapbase == 0 || !stm32port->port.membase)
return -ENXIO;
if (options)
--
2.17.1
Powered by blists - more mailing lists