linux-kernel - [PATCH V1 0/3] scsi: ufs: Add a vops to configure VCC voltage level

lists.openwall.net		lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC
Open Source and information security mailing list archives

Hash Suite: Windows password security audit tool. GUI, reports in PDF.

[<prev] [next>] [thread-next>] [day] [month] [year] [list]

Message-Id: <1611852899-2171-1-git-send-email-nitirawa@codeaurora.org>
Date:   Thu, 28 Jan 2021 22:24:56 +0530
From:   Nitin Rawat <nitirawa@...eaurora.org>
To:     asutoshd@...eaurora.org, cang@...eaurora.org,
        stummala@...eaurora.org, vbadigan@...eaurora.org,
        alim.akhtar@...sung.com, avri.altman@....com, jejb@...ux.ibm.com,
        martin.petersen@...cle.com, stanley.chu@...iatek.com,
        beanhuo@...ron.com
Cc:     bvanassche@....org, linux-scsi@...r.kernel.org,
        linux-kernel@...r.kernel.org, Nitin Rawat <nitirawa@...eaurora.org>
Subject: [PATCH V1 0/3] scsi: ufs: Add a vops to configure VCC voltage level

UFS specification allows different VCC configurations for UFS devices,
for example,
        (1)2.70V - 3.60V (For UFS 2.x devices)
        (2)2.40V - 2.70V (For UFS 3.x devices)
For platforms supporting both ufs 2.x (2.7v-3.6v) and
ufs 3.x (2.4v-2.7v), the voltage requirements (VCC) is 2.4v-3.6v.
So to support this, we need to start the ufs device initialization with
the common VCC voltage(2.7v) and after reading the device descriptor we
need to switch to the correct range(vcc min and vcc max) of VCC voltage
as per UFS device type since 2.7v is the marginal voltage as per specs
for both type of devices.

Once VCC regulator supply has been intialised to 2.7v and UFS device
type is read from device descriptor, we follows below steps to
change the VCC voltage values.

1. Set the device to SLEEP state.
2. Disable the Vcc Regulator.
3. Set the vcc voltage according to the device type and reenable
   the regulator.
4. Set the device mode back to ACTIVE.

The above changes are done in vendor specific file by
adding a vops which will be needed for platform
supporting both ufs 2.x and ufs 3.x devices.

Nitin Rawat (3):
  scsi: ufs: export api for use in vendor file
  scsi: ufs: add a vops to configure VCC voltage level
  scsi: ufs-qcom: configure VCC voltage level in vendor file

 drivers/scsi/ufs/ufs-qcom.c | 51 +++++++++++++++++++++++++++++++++++++++++++++
 drivers/scsi/ufs/ufshcd.c   | 14 ++++++++++---
 drivers/scsi/ufs/ufshcd.h   | 14 +++++++++++++
 3 files changed, 76 insertions(+), 3 deletions(-)

--
2.7.4