[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]
Message-ID: <fca68f0f-e1f9-c6d0-3287-b889e22ce1eb@infradead.org>
Date: Wed, 3 Feb 2021 19:35:27 -0800
From: Randy Dunlap <rdunlap@...radead.org>
To: Bhaskar Chowdhury <unixbhaskar@...il.com>, linux@...linux.org.uk,
davem@...emloft.net, kuba@...nel.org,
linux-arm-kernel@...ts.infradead.org, netdev@...r.kernel.org,
linux-kernel@...r.kernel.org
Subject: Re: [PATCH V3] drivers: net: ethernet: i825xx: Fix couple of
spellings in the file ether1.c
On 2/3/21 7:16 PM, Bhaskar Chowdhury wrote:
>
>
> s/initialsation/initialisation/
> s/specifiing/specifying/
>
> Signed-off-by: Bhaskar Chowdhury <unixbhaskar@...il.com>
Aside from the Subject: being longer than needed, as Jakub commented,
it's fine for me. Thanks.
Acked-by: Randy Dunlap <rdunlap@...radead.org>
> ---
> Changes from V2:
> Adjust and make changes which are obvious as per Randy's suggestions
>
> drivers/net/ethernet/i825xx/ether1.c | 4 ++--
> 1 file changed, 2 insertions(+), 2 deletions(-)
>
> diff --git a/drivers/net/ethernet/i825xx/ether1.c b/drivers/net/ethernet/i825xx/ether1.c
> index a0bfb509e002..c612ef526d16 100644
> --- a/drivers/net/ethernet/i825xx/ether1.c
> +++ b/drivers/net/ethernet/i825xx/ether1.c
> @@ -20,7 +20,7 @@
> * 1.02 RMK 25/05/1997 Added code to restart RU if it goes not ready
> * 1.03 RMK 14/09/1997 Cleaned up the handling of a reset during the TX interrupt.
> * Should prevent lockup.
> - * 1.04 RMK 17/09/1997 Added more info when initialsation of chip goes wrong.
> + * 1.04 RMK 17/09/1997 Added more info when initialisation of chip goes wrong.
> * TDR now only reports failure when chip reports non-zero
> * TDR time-distance.
> * 1.05 RMK 31/12/1997 Removed calls to dev_tint for 2.1
> @@ -117,7 +117,7 @@ ether1_outw_p (struct net_device *dev, unsigned short val, int addr, int svflgs)
> * Some inline assembler to allow fast transfers on to/off of the card.
> * Since this driver depends on some features presented by the ARM
> * specific architecture, and that you can't configure this driver
> - * without specifiing ARM mode, this is not a problem.
> + * without specifying ARM mode, this is not a problem.
> *
> * This routine is essentially an optimised memcpy from the card's
> * onboard RAM to kernel memory.
> --
--
~Randy
Powered by blists - more mailing lists