[<prev] [next>] [day] [month] [year] [list]
Message-Id: <20210205234515.1216538-9-lyude@redhat.com>
Date: Fri, 5 Feb 2021 18:45:12 -0500
From: Lyude Paul <lyude@...hat.com>
To: dri-devel@...ts.freedesktop.org, nouveau@...ts.freedesktop.org,
intel-gfx@...ts.freedesktop.org
Cc: Jani Nikula <jani.nikula@...ux.intel.com>,
Joonas Lahtinen <joonas.lahtinen@...ux.intel.com>,
Rodrigo Vivi <rodrigo.vivi@...el.com>,
David Airlie <airlied@...ux.ie>,
Daniel Vetter <daniel@...ll.ch>,
Sean Paul <seanpaul@...omium.org>,
linux-kernel@...r.kernel.org (open list)
Subject: [RFC v3 08/10] drm/i915/dpcd_bl: Return early in vesa_calc_max_backlight if we can't read PWMGEN_BIT_COUNT
If we can't read DP_EDP_PWMGEN_BIT_COUNT in
intel_dp_aux_vesa_calc_max_backlight() but do have a valid PWM frequency
defined in the VBT, we'll keep going in the function until we inevitably
fail on reading DP_EDP_PWMGEN_BIT_COUNT_CAP_MIN. There's not much point in
doing this, so just return early.
Signed-off-by: Lyude Paul <lyude@...hat.com>
---
drivers/gpu/drm/i915/display/intel_dp_aux_backlight.c | 9 ++++++---
1 file changed, 6 insertions(+), 3 deletions(-)
diff --git a/drivers/gpu/drm/i915/display/intel_dp_aux_backlight.c b/drivers/gpu/drm/i915/display/intel_dp_aux_backlight.c
index 431758058aa0..c66350cdf7e9 100644
--- a/drivers/gpu/drm/i915/display/intel_dp_aux_backlight.c
+++ b/drivers/gpu/drm/i915/display/intel_dp_aux_backlight.c
@@ -449,11 +449,14 @@ static u32 intel_dp_aux_vesa_calc_max_backlight(struct intel_connector *connecto
int freq, fxp, fxp_min, fxp_max, fxp_actual, f = 1;
u8 pn, pn_min, pn_max;
- if (drm_dp_dpcd_readb(&intel_dp->aux, DP_EDP_PWMGEN_BIT_COUNT, &pn) == 1) {
- pn &= DP_EDP_PWMGEN_BIT_COUNT_MASK;
- max_backlight = (1 << pn) - 1;
+ if (drm_dp_dpcd_readb(&intel_dp->aux, DP_EDP_PWMGEN_BIT_COUNT, &pn) != 1) {
+ drm_dbg_kms(&i915->drm, "Failed to read pwmgen bit count cap\n");
+ return 0;
}
+ pn &= DP_EDP_PWMGEN_BIT_COUNT_MASK;
+ max_backlight = (1 << pn) - 1;
+
/* Find desired value of (F x P)
* Note that, if F x P is out of supported range, the maximum value or
* minimum value will applied automatically. So no need to check that.
--
2.29.2
Powered by blists - more mailing lists