[<prev] [next>] [<thread-prev] [day] [month] [year] [list]
Message-ID: <CAMuHMdXVob60P+RXv3i-2-h6FRksSsfgc+2vmX1PfXtCZh26-g@mail.gmail.com>
Date: Wed, 10 Feb 2021 15:28:16 +0100
From: Geert Uytterhoeven <geert@...ux-m68k.org>
To: Lars Povlsen <lars.povlsen@...rochip.com>
Cc: Alexandre Belloni <alexandre.belloni@...tlin.com>,
Linus Walleij <linus.walleij@...aro.org>,
Steen Hegelund <Steen.Hegelund@...rochip.com>,
Microchip Linux Driver Support <UNGLinuxDriver@...rochip.com>,
"open list:GPIO SUBSYSTEM" <linux-gpio@...r.kernel.org>,
Linux ARM <linux-arm-kernel@...ts.infradead.org>,
"open list:BROADCOM NVRAM DRIVER" <linux-mips@...r.kernel.org>,
Linux Kernel Mailing List <linux-kernel@...r.kernel.org>
Subject: Re: [PATCH] pinctrl: PINCTRL_MICROCHIP_SGPIO should depend on
ARCH_SPARX5 || SOC_VCOREIII
Hi Lars,
On Wed, Feb 10, 2021 at 3:24 PM Lars Povlsen <lars.povlsen@...rochip.com> wrote:
> Geert Uytterhoeven writes:
> > On Wed, Feb 10, 2021 at 3:17 PM Alexandre Belloni
> > <alexandre.belloni@...tlin.com> wrote:
> >> On 10/02/2021 14:53:01+0100, Geert Uytterhoeven wrote:
> >> > On Wed, Feb 10, 2021 at 2:45 PM Lars Povlsen <lars.povlsen@...rochip.com> wrote:
> >> > > Geert Uytterhoeven writes:
> >> > > > the Microsemi/Microchip Serial GPIO device is present only Microsemi
> >> > > > VCore III and Microchip Sparx5 SoCs. Hence add a dependency on
> >> > > > ARCH_SPARX5 || SOC_VCOREIII, to prevent asking the user about this
> >> > > > driver when configuring a kernel without support for these SoCs.
> >> > > >
> >> > > > Fixes: 7e5ea974e61c8dd0 ("pinctrl: pinctrl-microchip-sgpio: Add pinctrl driver for Microsemi Serial GPIO")
> >> > > > Signed-off-by: Geert Uytterhoeven <geert+renesas@...der.be>
> >> > > > ---
> >> > > > drivers/pinctrl/Kconfig | 4 ++--
> >> > > > 1 file changed, 2 insertions(+), 2 deletions(-)
> >> > > >
> >> > > > diff --git a/drivers/pinctrl/Kconfig b/drivers/pinctrl/Kconfig
> >> > > > index 113073d5f89bbf70..3b75b1d7d3d1f1b0 100644
> >> > > > --- a/drivers/pinctrl/Kconfig
> >> > > > +++ b/drivers/pinctrl/Kconfig
> >> > > > @@ -353,8 +353,8 @@ config PINCTRL_OCELOT
> >> > > >
> >> > > > config PINCTRL_MICROCHIP_SGPIO
> >> > > > bool "Pinctrl driver for Microsemi/Microchip Serial GPIO"
> >> > > > - depends on OF
> >> > > > - depends on HAS_IOMEM
> >> > > > + depends on OF && HAS_IOMEM
> >> > > > + depends on ARCH_SPARX5 || SOC_VCOREIII || COMPILE_TEST
> >> > > > select GPIOLIB
> >> > > > select GPIOLIB_IRQCHIP
> >> > > > select GENERIC_PINCONF
> >> > >
> >> > > Thank you for your patch. Unfortunately, it makes it impossible to use
> >> > > the driver across PCIe - which is a specifically desired configuration.
> >> > >
> >> > > Could you add CONFIG_PCI to the || chain?
> >> >
> >> > Sure.
> >> >
> >> > Is PCIe the only other transport over which the register can be accessed?
> >> > Or can this also be done over e.g. SPI, like on Ocelot[1]?
> >> >
> >> > [1] https://lore.kernel.org/linux-gpio/20200511145329.GV34497@piout.net/
> >> >
> >>
> >> Yes, this driver IP is also available on Ocelot (this is SOC_VCOREIII)
> >> so this is also available over SPI.
> >
> > Hence would you consider
> >
> > depends on ARCH_SPARX5 || SOC_VCOREIII || PCI || SPI || COMPILE_TEST
> >
> > acceptable? Or would that be futile, as must systems have PCI and/or
> > SPI enabled anyway?
> >
> > Gr{oetje,eeting}s,
> >
> > Geert
>
> Yes, that would be fine, but as you say - not have a lot of impact.
>
> Up to you...
OK, I'll drop this.
Gr{oetje,eeting}s,
Geert
--
Geert Uytterhoeven -- There's lots of Linux beyond ia32 -- geert@...ux-m68k.org
In personal conversations with technical people, I call myself a hacker. But
when I'm talking to journalists I just say "programmer" or something like that.
-- Linus Torvalds
Powered by blists - more mailing lists