linux-kernel - Re: [PATCH v14 2/4] phy: Add media type and speed serdes configuration interfaces

lists.openwall.net		lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC
Open Source and information security mailing list archives

Hash Suite: Windows password security audit tool. GUI, reports in PDF.

[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]

Message-ID: <YCqAMUfinMsnZnrq@lunn.ch>
Date:   Mon, 15 Feb 2021 15:07:45 +0100
From:   Andrew Lunn <andrew@...n.ch>
To:     Kishon Vijay Abraham I <kishon@...com>
Cc:     Steen Hegelund <steen.hegelund@...rochip.com>,
        Vinod Koul <vkoul@...nel.org>,
        Alexandre Belloni <alexandre.belloni@...tlin.com>,
        Lars Povlsen <lars.povlsen@...rochip.com>,
        Bjarni Jonasson <bjarni.jonasson@...rochip.com>,
        Microchip UNG Driver List <UNGLinuxDriver@...rochip.com>,
        netdev@...r.kernel.org, linux-kernel@...r.kernel.org
Subject: Re: [PATCH v14 2/4] phy: Add media type and speed serdes
 configuration interfaces

On Mon, Feb 15, 2021 at 05:25:10PM +0530, Kishon Vijay Abraham I wrote:
> Okay. Is it going to be some sort of manual negotiation where the
> Ethernet controller invokes set_speed with different speeds? Or the
> Ethernet controller will get the speed using some out of band mechanism
> and invokes set_speed once with the actual speed?

Hi Kishon

There are a few different mechanism possible.

The SFP has an EEPROM which contains lots of parameters. One is the
maximum baud rate the module supports. PHYLINK will combine this
information with the MAC capabilities to determine the default speed.

The users can select the mode the MAC works in, e.g. 1000BaseX vs
2500BaseX, via ethtool -s. Different modes needs different speeds.

Some copper PHYs will change there host side interface baud rate when
the media side interface changes mode. 10GBASE-X for 10G copper,
5GBase-X for 5G COPPER, 2500Base-X for 2.5G copper, and SGMII for
old school 10/100/1G Ethernet.

Mainline Linux has no support for it, but some 'vendor crap' will do a
manual negotiation, simply trying different speeds and see if the
SERDES establishes link. There is nothing standardised for this, as
far as i know.

    Andrew