Message-Id: <20210322135325.682257-1-fenghua.yu@intel.com>
Date:   Mon, 22 Mar 2021 13:53:22 +0000
From:   Fenghua Yu <fenghua.yu@...el.com>
To:     "Thomas Gleixner" <tglx@...utronix.de>,
        "Ingo Molnar" <mingo@...hat.com>, "Borislav Petkov" <bp@...en8.de>,
        "Peter Zijlstra" <peterz@...radead.org>,
        "Tony Luck" <tony.luck@...el.com>,
        "Randy Dunlap" <rdunlap@...radead.org>,
        "Xiaoyao Li " <xiaoyao.li@...el.com>,
        "Ravi V Shankar" <ravi.v.shankar@...el.com>
Cc:     "linux-kernel" <linux-kernel@...r.kernel.org>,
        "x86" <x86@...nel.org>, Fenghua Yu <fenghua.yu@...el.com>
Subject: [PATCH v6 0/3] x86/bus_lock: Enable bus lock detection

A bus lock [1] is acquired through either split locked access to
writeback (WB) memory or any locked access to non-WB memory. This is
typically >1000 cycles slower than an atomic operation within
a cache line. It also disrupts performance on other cores.

Although split lock can be detected by #AC trap, the trap is triggered
before the instruction acquires bus lock. This makes it difficult to
mitigate bus lock (e.g. throttle the user application).

Some CPUs have ability to notify the kernel by an #DB trap after a user
instruction acquires a bus lock and is executed. This allows the kernel
to enforce user application throttling or mitigations.

#DB for bus lock detect fixes issues in #AC for split lock detect:
1) It's architectural ... just need to look at one CPUID bit to know it
   exists
2) The IA32_DEBUGCTL MSR, which reports bus lock in #DB, is per-thread.
   So each process or guest can have different behavior.
3) It has support for VMM/guests (new VMEXIT codes, etc).
4) It detects not only split locks but also bus locks from non-WB.

Hardware only generates #DB for bus lock detect when CPL>0 to avoid
nested #DB from multiple bus locks while the first #DB is being handled.

Use the existing kernel command line parameter "split_lock_detect=" to
handle #DB for bus lock with an additional option "ratelimit=N" to set
bus lock rate limit for a user.

[1] Intel Instruction Set Extension Chapter 9:
https://software.intel.com/content/dam/develop/public/us/en/documents/architecture-instruction-set-extensions-programming-reference.pdf

Change Log:
v6:
- Split the v5 patch set into two sets. The first set (this patch set)
  only handles warn and fatal cases. The second set will handle ratelimit
  case and will be released later (Thomas).
v5 is here: https://lore.kernel.org/patchwork/cover/1394659/
 
v5:
Address all comments from Thomas:
- In the cover letter, update the latest ISE link to include the #DB
  for bus lock spec.
- In patch 1, add commit message for breakpoint and bus lock on the same
  instruction.
- In patch 2, change warn to #AC if both #AC and #DB are supported, remove
  sld and bld variables, remove bus lock checking in handle_bus_lock() etc.
- In patch 3 and 4, remove bld_ratelimit < HZ/2 check and define
  bld_ratelimit only for Intel CPUs.
- Merge patch 2 and 3 into one patch for handling warn, fatal, and
  ratelimit.
v4 is here: https://lore.kernel.org/lkml/20201124205245.4164633-2-fenghua.yu@intel.com/

v4:
- Fix a ratelimit wording issue in the doc (Randy).
- Patch 4 is acked by Randy (Randy).

v3:
- Enable Bus Lock Detection when fatal to handle bus lock from non-WB
  (PeterZ).
- Add Acked-by: PeterZ in patch 2.

v2:
- Send SIGBUS in fatal case for bus lock #DB (PeterZ).

v1:
- Check bus lock bit by its positive polarity (Xiaoyao).
- Fix a few wording issues in the documentation (Randy).
[RFC v3 can be found at: https://lore.kernel.org/patchwork/cover/1329943/]

RFC v3:
- Remove DR6_RESERVED change (PeterZ).
- Simplify the documentation (Randy).

RFC v2:
- Architecture changed based on feedback from Thomas and PeterZ. #DB is
  no longer generated for bus lock in ring0.
- Split the one single patch into four patches.
[RFC v1 can be found at: https://lore.kernel.org/lkml/1595021700-68460-1-git-send-email-fenghua.yu@intel.com/]

Fenghua Yu (3):
  x86/cpufeatures: Enumerate #DB for bus lock detection
  x86/bus_lock: Handle #DB for bus lock
  Documentation/admin-guide: Change doc for split_lock_detect parameter

 .../admin-guide/kernel-parameters.txt         |  22 +++-
 arch/x86/include/asm/cpu.h                    |   9 +-
 arch/x86/include/asm/cpufeatures.h            |   1 +
 arch/x86/include/asm/msr-index.h              |   1 +
 arch/x86/include/uapi/asm/debugreg.h          |   1 +
 arch/x86/kernel/cpu/common.c                  |   2 +-
 arch/x86/kernel/cpu/intel.c                   | 111 +++++++++++++++---
 arch/x86/kernel/traps.c                       |   7 ++
 8 files changed, 126 insertions(+), 28 deletions(-)

-- 
2.31.0

Powered by blists - more mailing lists