Message-ID: <CO6PR18MB4417276AD6E894F061F16D8FCA199@CO6PR18MB4417.namprd18.prod.outlook.com>
Date:   Thu, 8 Jul 2021 07:50:09 +0000
From:   Kostya Porotchkin <kostap@...vell.com>
To:     Gregory CLEMENT <gregory.clement@...tlin.com>,
        "linux-kernel@...r.kernel.org" <linux-kernel@...r.kernel.org>,
        "devicetree@...r.kernel.org" <devicetree@...r.kernel.org>,
        "linux-arm-kernel@...ts.infradead.org" 
        <linux-arm-kernel@...ts.infradead.org>
CC:     "vladimir.vid@...tura.hr" <vladimir.vid@...tura.hr>,
        "tmn505@...il.com" <tmn505@...il.com>,
        "luka.kovacic@...tura.hr" <luka.kovacic@...tura.hr>,
        "sebastian.hesselbarth@...il.com" <sebastian.hesselbarth@...il.com>,
        "andrew@...n.ch" <andrew@...n.ch>,
        "robh+dt@...nel.org" <robh+dt@...nel.org>,
        "vkoul@...nel.org" <vkoul@...nel.org>,
        "kishon@...com" <kishon@...com>,
        "miquel.raynal@...tlin.com" <miquel.raynal@...tlin.com>,
        "mw@...ihalf.com" <mw@...ihalf.com>,
        "jaz@...ihalf.com" <jaz@...ihalf.com>,
        Nadav Haklai <nadavh@...vell.com>,
        Stefan Chulski <stefanc@...vell.com>,
        Ben Peled <bpeled@...vell.com>
Subject: RE: [EXT] Re: [PATCH v4 0/5] DTS updates for Marvell Armada CN913x
 platforms

Hi, Gregory,

The last series was v5. I will rebase on top of Linus 5.13-rcx and then post new v6 set.

Regards
Kosta

> -----Original Message-----
> From: Gregory CLEMENT <gregory.clement@...tlin.com>
> Sent: Thursday, June 17, 2021 18:40
> To: Kostya Porotchkin <kostap@...vell.com>; linux-kernel@...r.kernel.org;
> devicetree@...r.kernel.org; linux-arm-kernel@...ts.infradead.org
> Cc: vladimir.vid@...tura.hr; tmn505@...il.com; luka.kovacic@...tura.hr;
> sebastian.hesselbarth@...il.com; andrew@...n.ch; robh+dt@...nel.org;
> vkoul@...nel.org; kishon@...com; miquel.raynal@...tlin.com;
> mw@...ihalf.com; jaz@...ihalf.com; Nadav Haklai
> <nadavh@...vell.com>; Stefan Chulski <stefanc@...vell.com>; Ben Peled
> <bpeled@...vell.com>; Kostya Porotchkin <kostap@...vell.com>
> Subject: [EXT] Re: [PATCH v4 0/5] DTS updates for Marvell Armada CN913x
> platforms
> 
> External Email
> 
> ----------------------------------------------------------------------
> Hello,
> 
> > From: Konstantin Porotchkin <kostap@...vell.com>
> >
> > This patch series contains the following changes/fixes:
> > 1. Add support for Armada CN913x Development Board topology "B"
> > 2. Add support for Armada CN913x Reference Design boards (CRB) 3.
> > Fixes the CP11X references in PHY binding document 4. Fixes the NAND
> > paritioninig scheme in DTS eliminating gap between consecutive
> > partitions All above changes are already intergated into Marvell
> > official SDK sources
> >
> > v2:
> > - extract common nodes from DB boards to separate DTSI files
> > - disable eth2 on CRB boards until the required phy mode support is
> > added
> > - mention the switch part ID in CRB board description
> >
> > v3:
> > - do not rename setup A DTS files for DB variants
> > - fix a couple of wrong include names
> >
> > v4:
> > - Rebase on top of Linus master branch (v5.11-rc7)
> > - Remove HS400 timing from CRB AP SDHCI (not supported by connected
> > eMMC)
> > - Add cd-gpio entry to CP0 SDHCI for SD card support
> > - Add a comment to CN9130-CRB patch about the required defconfig
> >   changes for supporting the onboard i2c expander
> > - Add Stefan's patch to enable 10G port on CN9130-DB platforms
> >
> > Grzegorz Jaszczyk (1):
> >   Documentation/bindings: phy: update references to cp11x
> >
> > Konstantin Porotchkin (3):
> >   arch/arm64/boot/dts/marvell: fix NAND partitioning scheme
> >   arm64: dts: cn913x: add device trees for topology B boards
> >   arm64: dts: add support for Marvell cn9130-crb platform
> >
> > Stefan Chulski (1):
> >   dts: marvell: Enable 10G interface on 9130-DB board
> >
> 
> I've applied patches 1 and 2, but I have issue with patch 3, there was some
> changes around the phys and I am not sure of the correct way to modify the
> patch.
> 
> Could you rebase it on v5.13-c1 and fix the merge issue ?
> 
> Thanks,
> 
> Gregory
> 
> >  .../bindings/phy/phy-mvebu-comphy.txt         |  12 +-
> >  arch/arm64/boot/dts/marvell/Makefile          |   5 +
> >  arch/arm64/boot/dts/marvell/cn9130-crb-A.dts  |  38 ++
> > arch/arm64/boot/dts/marvell/cn9130-crb-B.dts  |  46 ++
> >  arch/arm64/boot/dts/marvell/cn9130-crb.dtsi   | 221 ++++++++++
> >  arch/arm64/boot/dts/marvell/cn9130-db-B.dts   |  22 +
> >  arch/arm64/boot/dts/marvell/cn9130-db.dts     | 393 +----------------
> >  arch/arm64/boot/dts/marvell/cn9130-db.dtsi    | 402 ++++++++++++++++++
> >  arch/arm64/boot/dts/marvell/cn9131-db-B.dts   |  22 +
> >  arch/arm64/boot/dts/marvell/cn9131-db.dts     | 192 +--------
> >  arch/arm64/boot/dts/marvell/cn9131-db.dtsi    | 201 +++++++++
> >  arch/arm64/boot/dts/marvell/cn9132-db-B.dts   |  22 +
> >  arch/arm64/boot/dts/marvell/cn9132-db.dts     | 211 +--------
> >  arch/arm64/boot/dts/marvell/cn9132-db.dtsi    | 220 ++++++++++
> >  14 files changed, 1223 insertions(+), 784 deletions(-)  create mode
> > 100644 arch/arm64/boot/dts/marvell/cn9130-crb-A.dts
> >  create mode 100644 arch/arm64/boot/dts/marvell/cn9130-crb-B.dts
> >  create mode 100644 arch/arm64/boot/dts/marvell/cn9130-crb.dtsi
> >  create mode 100644 arch/arm64/boot/dts/marvell/cn9130-db-B.dts
> >  create mode 100644 arch/arm64/boot/dts/marvell/cn9130-db.dtsi
> >  create mode 100644 arch/arm64/boot/dts/marvell/cn9131-db-B.dts
> >  create mode 100644 arch/arm64/boot/dts/marvell/cn9131-db.dtsi
> >  create mode 100644 arch/arm64/boot/dts/marvell/cn9132-db-B.dts
> >  create mode 100644 arch/arm64/boot/dts/marvell/cn9132-db.dtsi
> >
> > --
> > 2.17.1
> >
> 
> --
> Gregory Clement, Bootlin
> Embedded Linux and Kernel engineering
> https://urldefense.proofpoint.com/v2/url?u=http-
> 3A__bootlin.com&d=DwIBAg&c=nKjWec2b6R0mOyPaz7xtfQ&r=-
> N9sN4p5NSr0JGQoQ_2UCOgAqajG99W1EbSOww0WU8o&m=yb2JOcVicfAZRe
> thZJoDE-
> wbwtupb3tk_D7VGKCNsqc&s=4oskkLywYJujfGQ4XpFfP6n4ybkC0722K_8qH3xz
> bK8&e=

Powered by blists - more mailing lists