Message-Id: <20210811084924.52293-1-daniel@0x0f.com>
Date:   Wed, 11 Aug 2021 17:49:24 +0900
From:   Daniel Palmer <daniel@...f.com>
To:     linux-mtd@...ts.infradead.org, miquel.raynal@...tlin.com,
        richard@....at
Cc:     linux-kernel@...r.kernel.org, linux-arm-kernel@...ts.infradead.org,
        Daniel Palmer <daniel@...f.com>
Subject: [PATCH v3] mtd: spinand: add support for Foresee FS35ND0*G parts

Add support for the various Foresee FS35ND0*G parts manufactured by Longsys.

Signed-off-by: Daniel Palmer <daniel@...f.com>

Link: https://datasheet.lcsc.com/szlcsc/2008121142_FORESEE-FS35ND01G-S1Y2QWFI000_C719495.pdf
---
 Changes since v2:
 - Originally I only had the 1Gbit version of this chip, now I have the 2Gbit and 4Gbit
   variations so I've added support for those too. There is no datasheet for the bigger
   chips but they are documented in a flashing tool from an SoC vendor so I took the parameters
   from there.
 - Previous versions of this patch only had single io read cache variants. My SPI flash driver
   now supports dual and quad io for reading so I added and tested those modes too.
   My driver/hardware only supports single io for writing so those are still left out.
 - Implemented proper logic for checking the ECC status.
 - Combined with the previous patch for 1-filling the OOB in the page buffer before writing
   I have been using this for a few months now without anything getting broken.
 
 drivers/mtd/nand/spi/Makefile  |   2 +-
 drivers/mtd/nand/spi/core.c    |   1 +
 drivers/mtd/nand/spi/longsys.c | 134 +++++++++++++++++++++++++++++++++
 include/linux/mtd/spinand.h    |   1 +
 4 files changed, 137 insertions(+), 1 deletion(-)
 create mode 100644 drivers/mtd/nand/spi/longsys.c

diff --git a/drivers/mtd/nand/spi/Makefile b/drivers/mtd/nand/spi/Makefile
index 9662b9c1d5a9..1d6819022e43 100644
--- a/drivers/mtd/nand/spi/Makefile
+++ b/drivers/mtd/nand/spi/Makefile
@@ -1,3 +1,3 @@
 # SPDX-License-Identifier: GPL-2.0
-spinand-objs := core.o gigadevice.o macronix.o micron.o paragon.o toshiba.o winbond.o
+spinand-objs := core.o gigadevice.o longsys.o macronix.o micron.o paragon.o toshiba.o winbond.o
 obj-$(CONFIG_MTD_SPI_NAND) += spinand.o
diff --git a/drivers/mtd/nand/spi/core.c b/drivers/mtd/nand/spi/core.c
index 446ba8d43fbc..48f635d5c1ff 100644
--- a/drivers/mtd/nand/spi/core.c
+++ b/drivers/mtd/nand/spi/core.c
@@ -895,6 +895,7 @@ static const struct nand_ops spinand_ops = {
 
 static const struct spinand_manufacturer *spinand_manufacturers[] = {
 	&gigadevice_spinand_manufacturer,
+	&longsys_spinand_manufacturer,
 	&macronix_spinand_manufacturer,
 	&micron_spinand_manufacturer,
 	&paragon_spinand_manufacturer,
diff --git a/drivers/mtd/nand/spi/longsys.c b/drivers/mtd/nand/spi/longsys.c
new file mode 100644
index 000000000000..ee38f8728262
--- /dev/null
+++ b/drivers/mtd/nand/spi/longsys.c
@@ -0,0 +1,134 @@
+// SPDX-License-Identifier: GPL-2.0
+/*
+ * Copyright (c) 2020 Daniel Palmer <daniel@...ngy.jp>
+ *
+ */
+
+#include <linux/device.h>
+#include <linux/kernel.h>
+#include <linux/mtd/spinand.h>
+
+#define SPINAND_MFR_LONGSYS			0xCD
+#define FS35ND01G_S1Y2_STATUS_ECC_0_3_BITFLIPS	(0 << 4)
+#define FS35ND01G_S1Y2_STATUS_ECC_4_BITFLIPS	(1 << 4)
+#define FS35ND01G_S1Y2_STATUS_ECC_UNCORRECTABLE	(2 << 4)
+
+static SPINAND_OP_VARIANTS(read_cache_variants,
+		SPINAND_PAGE_READ_FROM_CACHE_QUADIO_OP(0, 2, NULL, 0),
+		SPINAND_PAGE_READ_FROM_CACHE_X4_OP(0, 1, NULL, 0),
+		SPINAND_PAGE_READ_FROM_CACHE_DUALIO_OP(0, 1, NULL, 0),
+		SPINAND_PAGE_READ_FROM_CACHE_X2_OP(0, 1, NULL, 0),
+		SPINAND_PAGE_READ_FROM_CACHE_OP(false, 0, 1, NULL, 0));
+
+static SPINAND_OP_VARIANTS(write_cache_variants,
+		SPINAND_PROG_LOAD(true, 0, NULL, 0));
+
+static SPINAND_OP_VARIANTS(update_cache_variants,
+		SPINAND_PROG_LOAD(false, 0, NULL, 0));
+
+static int fs35nd01g_s1y2_ooblayout_ecc(struct mtd_info *mtd, int section,
+					struct mtd_oob_region *region)
+{
+	if (section > 3)
+		return -ERANGE;
+
+	/* ECC is not user accessible */
+	region->offset = 0;
+	region->length = 0;
+
+	return 0;
+}
+
+static int fs35nd01g_s1y2_ooblayout_free(struct mtd_info *mtd, int section,
+				    struct mtd_oob_region *region)
+{
+	if (section > 3)
+		return -ERANGE;
+
+	/*
+	 * No ECC data is stored in the accessible OOB so the full 16 bytes
+	 * of each spare region is available to the user. Apparently also
+	 * covered by the internal ECC.
+	 */
+	if (section) {
+		region->offset = 16 * section;
+		region->length = 16;
+	} else {
+		/* First byte in spare0 area is used for bad block marker */
+		region->offset = 1;
+		region->length = 15;
+	}
+
+	return 0;
+}
+
+static const struct mtd_ooblayout_ops fs35nd01g_s1y2_ooblayout = {
+	.ecc = fs35nd01g_s1y2_ooblayout_ecc,
+	.free = fs35nd01g_s1y2_ooblayout_free,
+};
+
+static int fs35nd01g_s1y2_ecc_get_status(struct spinand_device *spinand,
+					u8 status)
+{
+	switch (status & STATUS_ECC_MASK) {
+	case FS35ND01G_S1Y2_STATUS_ECC_0_3_BITFLIPS:
+		return 3;
+	/*
+	 * The datasheet says *successful* with 4 bits flipped.
+	 * nandbiterrs always complains that the read reported
+	 * successful but the data is incorrect.
+	 */
+	case FS35ND01G_S1Y2_STATUS_ECC_4_BITFLIPS:
+		return 4;
+	case FS35ND01G_S1Y2_STATUS_ECC_UNCORRECTABLE:
+		return -EBADMSG;
+	default:
+		break;
+	}
+
+	return -EINVAL;
+}
+
+static const struct spinand_info longsys_spinand_table[] = {
+	SPINAND_INFO("FS35ND01G-S1Y2",
+		     SPINAND_ID(SPINAND_READID_METHOD_OPCODE_DUMMY, 0xEA, 0x11),
+		     NAND_MEMORG(1, 2048, 64, 64, 1024, 20, 1, 1, 1),
+		     NAND_ECCREQ(4, 512),
+		     SPINAND_INFO_OP_VARIANTS(&read_cache_variants,
+					      &write_cache_variants,
+					      &update_cache_variants),
+		     SPINAND_HAS_QE_BIT,
+		     SPINAND_ECCINFO(&fs35nd01g_s1y2_ooblayout,
+				     fs35nd01g_s1y2_ecc_get_status)),
+	SPINAND_INFO("FS35ND02G-S3Y2",
+		     SPINAND_ID(SPINAND_READID_METHOD_OPCODE_DUMMY, 0xEB, 0x11),
+		     NAND_MEMORG(1, 2048, 64, 64, 2048, 40, 1, 1, 1),
+		     NAND_ECCREQ(4, 512),
+		     SPINAND_INFO_OP_VARIANTS(&read_cache_variants,
+					      &write_cache_variants,
+					      &update_cache_variants),
+		     SPINAND_HAS_QE_BIT,
+		     SPINAND_ECCINFO(&fs35nd01g_s1y2_ooblayout,
+				     fs35nd01g_s1y2_ecc_get_status)),
+	SPINAND_INFO("FS35ND04G-S2Y2",
+		     SPINAND_ID(SPINAND_READID_METHOD_OPCODE_DUMMY, 0xEC, 0x11),
+		     NAND_MEMORG(1, 2048, 64, 64, 4096, 40, 1, 1, 1),
+		     NAND_ECCREQ(4, 512),
+		     SPINAND_INFO_OP_VARIANTS(&read_cache_variants,
+					      &write_cache_variants,
+					      &update_cache_variants),
+		     SPINAND_HAS_QE_BIT,
+		     SPINAND_ECCINFO(&fs35nd01g_s1y2_ooblayout,
+				     fs35nd01g_s1y2_ecc_get_status)),
+};
+
+static const struct spinand_manufacturer_ops longsys_spinand_manuf_ops = {
+};
+
+const struct spinand_manufacturer longsys_spinand_manufacturer = {
+	.id = SPINAND_MFR_LONGSYS,
+	.name = "Longsys",
+	.chips = longsys_spinand_table,
+	.nchips = ARRAY_SIZE(longsys_spinand_table),
+	.ops = &longsys_spinand_manuf_ops,
+};
diff --git a/include/linux/mtd/spinand.h b/include/linux/mtd/spinand.h
index 6988956b8492..f6c38528bb03 100644
--- a/include/linux/mtd/spinand.h
+++ b/include/linux/mtd/spinand.h
@@ -261,6 +261,7 @@ struct spinand_manufacturer {
 
 /* SPI NAND manufacturers */
 extern const struct spinand_manufacturer gigadevice_spinand_manufacturer;
+extern const struct spinand_manufacturer longsys_spinand_manufacturer;
 extern const struct spinand_manufacturer macronix_spinand_manufacturer;
 extern const struct spinand_manufacturer micron_spinand_manufacturer;
 extern const struct spinand_manufacturer paragon_spinand_manufacturer;
-- 
2.32.0

Powered by blists - more mailing lists