linux-kernel - [PATCH 3/4] arm64: dts: marvell: espressobin-ultra: add PHY and switch reset pins

lists.openwall.net		lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC
Open Source and information security mailing list archives

Hash Suite: Windows password security audit tool. GUI, reports in PDF.

[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]

Message-Id: <20210927154159.2168500-3-robert.marko@sartura.hr>
Date:   Mon, 27 Sep 2021 17:41:58 +0200
From:   Robert Marko <robert.marko@...tura.hr>
To:     andrew@...n.ch, gregory.clement@...tlin.com,
        sebastian.hesselbarth@...il.com, robh+dt@...nel.org,
        linux-arm-kernel@...ts.infradead.org, devicetree@...r.kernel.org,
        linux-kernel@...r.kernel.org
Cc:     Robert Marko <robert.marko@...tura.hr>
Subject: [PATCH 3/4] arm64: dts: marvell: espressobin-ultra: add PHY and switch reset pins

Both the Topaz switch and 88E1512 PHY have their reset and interrupts
connected to the SoC.

So, define the Topaz and 88E1512 reset pins in the DTS.

Defining the interrupt pins wont work as both the 88E1512 and the
Topaz switch uses active LOW IRQ signals but the A37xx GPIO controller
only supports edge triggers.
88E1512 would require special setup anyway as its INT pin is shared with
the LED2 and you first need to configure it as INT.

Signed-off-by: Robert Marko <robert.marko@...tura.hr>
---
 arch/arm64/boot/dts/marvell/armada-3720-espressobin-ultra.dts | 4 ++++
 1 file changed, 4 insertions(+)

diff --git a/arch/arm64/boot/dts/marvell/armada-3720-espressobin-ultra.dts b/arch/arm64/boot/dts/marvell/armada-3720-espressobin-ultra.dts
index 8a700afd0570..96855a10b4a0 100644
--- a/arch/arm64/boot/dts/marvell/armada-3720-espressobin-ultra.dts
+++ b/arch/arm64/boot/dts/marvell/armada-3720-espressobin-ultra.dts
@@ -118,12 +118,16 @@ &usb3 {
 &mdio {
 	extphy: ethernet-phy@1 {
 		reg = <1>;
+
+		reset-gpios = <&gpionb 2 GPIO_ACTIVE_LOW>;
 	};
 };
 
 &switch0 {
 	reg = <3>;
 
+	reset-gpios = <&gpiosb 23 GPIO_ACTIVE_LOW>;
+
 	ports {
 		switch0port1: port@1 {
 			reg = <1>;
-- 
2.31.1