| lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
|
Open Source and information security mailing list archives
| ||
|
Message-ID: <8f196323-d8b1-8f10-dee7-f958560ddeac@microchip.com>
Date: Fri, 17 Dec 2021 14:33:37 +0000
From: <Tudor.Ambarus@...rochip.com>
To: <p.yadav@...com>, <michael@...le.cc>
CC: <miquel.raynal@...tlin.com>, <richard@....at>, <vigneshr@...com>,
<linux-mtd@...ts.infradead.org>, <linux-kernel@...r.kernel.org>
Subject: Re: [PATCH v3 2/2] mtd: spi-nor: macronix: Add support for
mx66lm1g45g
On 12/17/21 3:44 PM, Tudor Ambarus wrote:
> mx66lm1g45g supports just 1-1-1, 8-8-8 and 8d-8d-8d modes. There are
> versions of mx66lm1g45g which do not support SFDP, thus use
> SPI_NOR_SKIP_SFDP. The RDID command issued through the octal peripheral
> interface outputs data always in STR mode for whatever reason. Since
> 8d-8d-8s is not common, avoid reading the ID when enabling the octal dtr
> mode. Instead, read back the CR2 to check if the switch was successful.
> Tested in 1-1-1 and 8d-8d-8d modes using sama7g5 QSPI IP.
>
> Signed-off-by: Tudor Ambarus <tudor.ambarus@...rochip.com>
> ---
> v3:
> - resend the patch, this time prefixed with v3
> - drop setting of dummy cycles, use the default value
> - avoid odd lengths in octal dtr mode
> - s/8d-8d-8d/8D-8D-8D
>
> v2: SPI_NOR_SOFT_RESET as a FIXUP_FLAG
>
> # cat /sys/devices/platform/soc/e080c000.spi/spi_master/spi1/spi1.0/spi-nor/jedec_id
> c2853b
> # cat /sys/devices/platform/soc/e080c000.spi/spi_master/spi1/spi1.0/spi-nor/manufacturer
> macronix
> # cat /sys/devices/platform/soc/e080c000.spi/spi_master/spi1/spi1.0/spi-nor/partname
> mx66lm1g45g
> # cat /sys/devices/platform/soc/e080c000.spi/spi_master/spi1/spi1.0/spi-nor/sfdp
> cat: can't open '/sys/devices/platform/soc/e080c000.spi/spi_master/spi1/spi1.0/spi-nor/sfdp': No such file or directory
>
> drivers/mtd/spi-nor/macronix.c | 96 ++++++++++++++++++++++++++++++++++
> 1 file changed, 96 insertions(+)
>
> diff --git a/drivers/mtd/spi-nor/macronix.c b/drivers/mtd/spi-nor/macronix.c
> index 67aaa83038b6..4c672deb1d1c 100644
> --- a/drivers/mtd/spi-nor/macronix.c
> +++ b/drivers/mtd/spi-nor/macronix.c
> @@ -32,6 +32,95 @@ static struct spi_nor_fixups mx25l25635_fixups = {
> .post_bfpt = mx25l25635_post_bfpt_fixups,
> };
>
> +#define SPINOR_OP_READ_CR2 0x71
> +#define SPINOR_OP_WRITE_CR2 0x72
> +#define SPINOR_OP_MX_DTR_RD 0xee
> +
> +#define SPINOR_REG_CR2_MODE_ADDR 0
> +#define SPINOR_REG_CR2_DTR_OPI_ENABLE BIT(1)
> +#define SPINOR_REG_CR2_SPI 0
> +
> +static int spi_nor_macronix_octal_dtr_enable(struct spi_nor *nor, bool enable)
> +{
> + u8 *buf = nor->bouncebuf;
> + struct spi_mem_op op;
> + int ret;
> +
> + /* Set/unset the octal and DTR enable bits. */
> + if (enable) {
> + buf[0] = SPINOR_REG_CR2_DTR_OPI_ENABLE;
> + } else {
> + /*
> + * The register is one byte wide, but the one byte transactions
> + * are not allowed in 8D-8D-8D mode. Since there is no register
> + * at the next location, just initialize the value to zero and
> + * let the transaction go on.
> + */
actually CR2 is indexed by address, from 00000000h to 80000000h. And macronix states
that "All addresses not shown in the table must keep value unchanged.". So I should
maybe read what's at address one, and when disabling octal to use the value read,
so that I don't change undefined values. Meh.
> + buf[0] = SPINOR_REG_CR2_SPI;
> + buf[1] = 0;
> + }
> +
> + op = (struct spi_mem_op)
> + SPI_MEM_OP(SPI_MEM_OP_CMD(SPINOR_OP_WRITE_CR2, 1),
> + SPI_MEM_OP_ADDR(4, SPINOR_REG_CR2_MODE_ADDR, 1),
> + SPI_MEM_OP_NO_DUMMY,
> + SPI_MEM_OP_DATA_OUT(enable ? 1 : 2, buf, 1));
> + if (!enable)
> + spi_nor_spimem_setup_op(nor, &op, SNOR_PROTO_8_8_8_DTR);
> +
> + ret = spi_nor_write_enable(nor);
> + if (ret)
> + return ret;
> +
> + ret = spi_mem_exec_op(nor->spimem, &op);
> + if (ret)
> + return ret;
> +
> + /* Read back CR2 to make sure the switch was successful. */
> + op = (struct spi_mem_op)
> + SPI_MEM_OP(SPI_MEM_OP_CMD(SPINOR_OP_READ_CR2, 1),
> + SPI_MEM_OP_ADDR(4, SPINOR_REG_CR2_MODE_ADDR, 1),
> + SPI_MEM_OP_DUMMY(enable ? 4 : 0, 1),
> + SPI_MEM_OP_DATA_IN(enable ? 2 : 1, buf, 1));
> + if (enable)
> + spi_nor_spimem_setup_op(nor, &op, SNOR_PROTO_8_8_8_DTR);
> +
> + ret = spi_mem_exec_op(nor->spimem, &op);
> + if (ret)
> + return ret;
> +
> + if (enable) {
> + if (buf[0] != SPINOR_REG_CR2_DTR_OPI_ENABLE) {
> + dev_dbg(nor->dev, "Failed to enable 8D-8D-8D mode.\n");
> + return -EINVAL;
> + }
> + } else if (buf[0] != SPINOR_REG_CR2_SPI) {
> + dev_dbg(nor->dev, "Failed to disable 8D-8D-8D mode.\n");
> + return -EINVAL;
> + }
> +
> + return 0;
> +}
> +
> +static void mx66lm1g45g_late_init(struct spi_nor *nor)
> +{
> + nor->params->octal_dtr_enable = spi_nor_macronix_octal_dtr_enable;
> +
> + /* Set the Fast Read settings. */
> + nor->params->hwcaps.mask |= SNOR_HWCAPS_READ_8_8_8_DTR;
> + spi_nor_set_read_settings(&nor->params->reads[SNOR_CMD_READ_8_8_8_DTR],
> + 0, 20, SPINOR_OP_MX_DTR_RD,
> + SNOR_PROTO_8_8_8_DTR);
> +
> + nor->cmd_ext_type = SPI_NOR_EXT_INVERT;
> + nor->params->rdsr_dummy = 4;
> + nor->params->rdsr_addr_nbytes = 4;
> +}
> +
> +static struct spi_nor_fixups mx66lm1g45g_fixups = {
> + .late_init = mx66lm1g45g_late_init,
> +};
> +
> static const struct flash_info macronix_parts[] = {
> /* Macronix */
> { "mx25l512e", INFO(0xc22010, 0, 64 * 1024, 1)
> @@ -100,6 +189,13 @@ static const struct flash_info macronix_parts[] = {
> { "mx66u2g45g", INFO(0xc2253c, 0, 64 * 1024, 4096)
> NO_SFDP_FLAGS(SECT_4K | SPI_NOR_DUAL_READ | SPI_NOR_QUAD_READ)
> FIXUP_FLAGS(SPI_NOR_4B_OPCODES) },
> + { "mx66lm1g45g", INFO(0xc2853b, 0, 64 * 1024, 2048)
> + NO_SFDP_FLAGS(SPI_NOR_SKIP_SFDP | SECT_4K |
> + SPI_NOR_OCTAL_DTR_READ | SPI_NOR_OCTAL_DTR_PP)
> + FIXUP_FLAGS(SPI_NOR_4B_OPCODES | SPI_NOR_IO_MODE_EN_VOLATILE |
> + SPI_NOR_SOFT_RESET)
> + .fixups = &mx66lm1g45g_fixups,
> + },
> };
>
> static void macronix_default_init(struct spi_nor *nor)
>
Powered by blists - more mailing lists