| lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
|
Open Source and information security mailing list archives
| ||
|
Message-ID: <CAHp75Vd48LiEDUV+otHhdLqtQuLv50aptfA1e9X_0PEpQ4BAsw@mail.gmail.com>
Date: Wed, 22 Dec 2021 14:03:04 +0200
From: Andy Shevchenko <andy.shevchenko@...il.com>
To: Felix Fietkau <nbd@....name>
Cc: linux-arm Mailing List <linux-arm-kernel@...ts.infradead.org>,
Linus Walleij <linus.walleij@...aro.org>,
Bartosz Golaszewski <brgl@...ev.pl>, john <john@...ozen.org>,
Linux Kernel Mailing List <linux-kernel@...r.kernel.org>,
"open list:GPIO SUBSYSTEM" <linux-gpio@...r.kernel.org>
Subject: Re: [PATCH v8 13/14] gpio: Add support for Airoha EN7523 GPIO controller
On Tue, Dec 21, 2021 at 12:02 AM Felix Fietkau <nbd@....name> wrote:
>
> From: John Crispin <john@...ozen.org>
>
> Airoha's GPIO controller on their ARM EN7523 SoCs consists of two banks of 32
> GPIOs. Each instance in DT is for a single bank.
FWIW,
Reviewed-by: Andy Shevchenko <andy.shevchenko@...il.com>
A couple of minor comments and one about headers below.
> Signed-off-by: John Crispin <john@...ozen.org>
> Signed-off-by: Felix Fietkau <nbd@....name>
> ---
> drivers/gpio/Kconfig | 9 +++
> drivers/gpio/Makefile | 1 +
> drivers/gpio/gpio-en7523.c | 134 +++++++++++++++++++++++++++++++++++++
> 3 files changed, 144 insertions(+)
> create mode 100644 drivers/gpio/gpio-en7523.c
>
> diff --git a/drivers/gpio/Kconfig b/drivers/gpio/Kconfig
> index 072ed610f9c6..e4a34272504f 100644
> --- a/drivers/gpio/Kconfig
> +++ b/drivers/gpio/Kconfig
> @@ -247,6 +247,15 @@ config GPIO_EM
> help
> Say yes here to support GPIO on Renesas Emma Mobile SoCs.
>
> +config GPIO_EN7523
> + tristate "Airoha GPIO support"
> + depends on ARCH_AIROHA
> + default ARCH_AIROHA
> + select GPIO_GENERIC
> + select GPIOLIB_IRQCHIP
> + help
> + Say yes here to support the GPIO controller on Airoha EN7523.
Checkpatch nowadays wants a better description. Also add a paragraph
at the end, like many other drivers do, what the module would be if
selected as M.
> config GPIO_EP93XX
> def_bool y
> depends on ARCH_EP93XX
> diff --git a/drivers/gpio/Makefile b/drivers/gpio/Makefile
> index 71ee9fc2ff83..d2269ee0948e 100644
> --- a/drivers/gpio/Makefile
> +++ b/drivers/gpio/Makefile
> @@ -56,6 +56,7 @@ obj-$(CONFIG_GPIO_DLN2) += gpio-dln2.o
> obj-$(CONFIG_GPIO_DWAPB) += gpio-dwapb.o
> obj-$(CONFIG_GPIO_EIC_SPRD) += gpio-eic-sprd.o
> obj-$(CONFIG_GPIO_EM) += gpio-em.o
> +obj-$(CONFIG_GPIO_EN7523) += gpio-en7523.o
> obj-$(CONFIG_GPIO_EP93XX) += gpio-ep93xx.o
> obj-$(CONFIG_GPIO_EXAR) += gpio-exar.o
> obj-$(CONFIG_GPIO_F7188X) += gpio-f7188x.o
> diff --git a/drivers/gpio/gpio-en7523.c b/drivers/gpio/gpio-en7523.c
> new file mode 100644
> index 000000000000..67631396cd93
> --- /dev/null
> +++ b/drivers/gpio/gpio-en7523.c
> @@ -0,0 +1,134 @@
> +// SPDX-License-Identifier: GPL-2.0-only
> +
> +#include <linux/gpio/driver.h>
> +#include <linux/mod_devicetable.h>
> +#include <linux/module.h>
> +#include <linux/platform_device.h>
> +#include <linux/property.h>
Missed headers
types.h for _iomem, etc.
io.h for I/O accessors.
bits.h for BIT(), etc.
> +#define AIROHA_GPIO_MAX 32
> +
> +/**
> + * airoha_gpio_ctrl - Airoha GPIO driver data
> + * @gc: Associated gpio_chip instance.
> + * @data: The data register.
> + * @dir0: The direction register for the lower 16 pins.
> + * @dir1: The direction register for the higher 16 pins.
> + * @output: The output enable register.
> + */
> +struct airoha_gpio_ctrl {
> + struct gpio_chip gc;
> + void __iomem *data;
> + void __iomem *dir[2];
> + void __iomem *output;
> +};
> +
> +static struct airoha_gpio_ctrl *gc_to_ctrl(struct gpio_chip *gc)
> +{
> + return container_of(gc, struct airoha_gpio_ctrl, gc);
> +}
> +
> +static int airoha_dir_set(struct gpio_chip *gc, unsigned int gpio,
> + int val, int out)
> +{
> + struct airoha_gpio_ctrl *ctrl = gc_to_ctrl(gc);
> + u32 dir = ioread32(ctrl->dir[gpio / 16]);
> + u32 output = ioread32(ctrl->output);
> + u32 mask = BIT((gpio % 16) * 2);
> +
> + if (out) {
> + dir |= mask;
> + output |= BIT(gpio);
> + } else {
> + dir &= ~mask;
> + output &= ~BIT(gpio);
> + }
> +
> + iowrite32(dir, ctrl->dir[gpio / 16]);
> +
> + if (out)
> + gc->set(gc, gpio, val);
> +
> + iowrite32(output, ctrl->output);
> +
> + return 0;
> +}
> +
> +static int airoha_dir_out(struct gpio_chip *gc, unsigned int gpio,
> + int val)
> +{
> + return airoha_dir_set(gc, gpio, val, 1);
> +}
> +
> +static int airoha_dir_in(struct gpio_chip *gc, unsigned int gpio)
> +{
> + return airoha_dir_set(gc, gpio, 0, 0);
> +}
> +
> +static int airoha_get_dir(struct gpio_chip *gc, unsigned int gpio)
> +{
> + struct airoha_gpio_ctrl *ctrl = gc_to_ctrl(gc);
> + u32 dir = ioread32(ctrl->dir[gpio / 16]);
> + u32 mask = BIT((gpio % 16) * 2);
> +
> + return (dir & mask) ? GPIO_LINE_DIRECTION_OUT : GPIO_LINE_DIRECTION_IN;
> +}
> +static const struct of_device_id airoha_gpio_of_match[] = {
> + { .compatible = "airoha,en7523-gpio" },
> + { }
> +};
> +MODULE_DEVICE_TABLE(of, airoha_gpio_of_match);
Move this below, closer to its user.
> +static int airoha_gpio_probe(struct platform_device *pdev)
> +{
> + struct device *dev = &pdev->dev;
> + struct airoha_gpio_ctrl *ctrl;
> + int err;
> +
> + ctrl = devm_kzalloc(dev, sizeof(*ctrl), GFP_KERNEL);
> + if (!ctrl)
> + return -ENOMEM;
> +
> + ctrl->data = devm_platform_ioremap_resource(pdev, 0);
> + if (IS_ERR(ctrl->data))
> + return PTR_ERR(ctrl->data);
> +
> + ctrl->dir[0] = devm_platform_ioremap_resource(pdev, 1);
> + if (IS_ERR(ctrl->dir[0]))
> + return PTR_ERR(ctrl->dir[0]);
> +
> + ctrl->dir[1] = devm_platform_ioremap_resource(pdev, 2);
> + if (IS_ERR(ctrl->dir[1]))
> + return PTR_ERR(ctrl->dir[1]);
> +
> + ctrl->output = devm_platform_ioremap_resource(pdev, 3);
> + if (IS_ERR(ctrl->output))
> + return PTR_ERR(ctrl->output);
> +
> + err = bgpio_init(&ctrl->gc, dev, 4, ctrl->data, NULL,
> + NULL, NULL, NULL, 0);
> + if (err)
> + return dev_err_probe(dev, err, "unable to init generic GPIO");
> +
> + ctrl->gc.ngpio = AIROHA_GPIO_MAX;
> + ctrl->gc.owner = THIS_MODULE;
> + ctrl->gc.direction_output = airoha_dir_out;
> + ctrl->gc.direction_input = airoha_dir_in;
> + ctrl->gc.get_direction = airoha_get_dir;
> +
> + return devm_gpiochip_add_data(dev, &ctrl->gc, ctrl);
> +}
> +
> +static struct platform_driver airoha_gpio_driver = {
> + .driver = {
> + .name = "airoha-gpio",
> + .of_match_table = airoha_gpio_of_match,
> + },
> + .probe = airoha_gpio_probe,
> +};
> +module_platform_driver(airoha_gpio_driver);
> +
> +MODULE_DESCRIPTION("Airoha GPIO support");
> +MODULE_AUTHOR("John Crispin <john@...ozen.org>");
> +MODULE_LICENSE("GPL v2");
> --
> 2.34.1
>
--
With Best Regards,
Andy Shevchenko
Powered by blists - more mailing lists