[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]
Message-ID: <20220222182415.50922b90@thinkpad>
Date: Tue, 22 Feb 2022 18:24:15 +0100
From: Marek Behún <kabel@...nel.org>
To: Pali Rohár <pali@...nel.org>
Cc: Lorenzo Pieralisi <lorenzo.pieralisi@....com>,
Bjorn Helgaas <bhelgaas@...gle.com>,
Rob Herring <robh+dt@...nel.org>, Andrew Lunn <andrew@...n.ch>,
Thomas Petazzoni <thomas.petazzoni@...tlin.com>,
Krzysztof Wilczyński <kw@...ux.com>,
Russell King <rmk+kernel@...linux.org.uk>,
Gregory Clement <gregory.clement@...tlin.com>,
linux-pci@...r.kernel.org, linux-arm-kernel@...ts.infradead.org,
linux-kernel@...r.kernel.org
Subject: Re: [PATCH 3/6] dt-bindings: Add 'slot-power-limit-milliwatt' PCIe
port property
On Tue, 22 Feb 2022 17:31:55 +0100
Pali Rohár <pali@...nel.org> wrote:
> This property specifies slot power limit in mW unit. It is a form-factor
> and board specific value and must be initialized by hardware.
>
> Some PCIe controllers delegate this work to software to allow hardware
> flexibility and therefore this property basically specifies what should
> host bridge program into PCIe Slot Capabilities registers.
>
> The property needs to be specified in mW unit instead of the special format
> defined by Slot Capabilities (which encodes scaling factor or different
> unit). Host drivers should convert the value from mW to needed format.
>
> Signed-off-by: Pali Rohár <pali@...nel.org>
> Signed-off-by: Marek Behún <kabel@...nel.org>
This patch is not needed, the property already is described in
dtschema.
Marek
Powered by blists - more mailing lists