| lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
|
Open Source and information security mailing list archives
| ||
|
Date: Tue, 26 Apr 2022 14:58:38 -0700
From: Matthias Kaehlcke <mka@...omium.org>
To: Srinivasa Rao Mandadapu <quic_srivasam@...cinc.com>
Cc: agross@...nel.org, bjorn.andersson@...aro.org, robh+dt@...nel.org,
linux-arm-msm@...r.kernel.org, devicetree@...r.kernel.org,
linux-kernel@...r.kernel.org, quic_rohkumar@...cinc.com,
srinivas.kandagatla@...aro.org, dianders@...omium.org,
swboyd@...omium.org, judyhsiao@...omium.org,
Venkata Prasad Potturu <quic_potturu@...cinc.com>
Subject: Re: [PATCH v11 2/4] arm64: dts: qcom: sc7280: Add MI2S pinmux
specifications for CRD 3.0/3.1
On Tue, Apr 26, 2022 at 12:51:04PM +0530, Srinivasa Rao Mandadapu wrote:
> Subject: arm64: dts: qcom: sc7280: Add MI2S pinmux specifications for CRD 3.0/3.1
>
> Add drive strength property for primary and secondary MI2S on
> sc7280 based platforms of rev5+ (aka CRD 3.0/3.1) boards.
The subject and the commit message are misleading. What this
change does is to configure these setting for all herobrine
based boards, not only the CRD rev5+.
That doesn't seem correct. The setting may be similar across
boards, but they aren't necessarily the same, especially for
the drive strength. One could argue that mi2s0 and the wcd9385
are on the qcard and hence the config should be in
sc7280-qcard.dtsi, however not all qcard based boards use the
wcd9385, so the config shouldn't be shared across all of them.
Please move it to sc7280-herobrine-crd.dts
Powered by blists - more mailing lists