linux-kernel - [PATCH] spi: aspeed: Fix division by zero

lists.openwall.net		lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC
Open Source and information security mailing list archives

Hash Suite: Windows password security audit tool. GUI, reports in PDF.

[<prev] [next>] [thread-next>] [day] [month] [year] [list]

Message-Id: <20220611103929.1484062-1-clg@kaod.org>
Date:   Sat, 11 Jun 2022 12:39:29 +0200
From:   Cédric Le Goater <clg@...d.org>
To:     linux-spi@...r.kernel.org
Cc:     Mark Brown <broonie@...nel.org>, Pratyush Yadav <p.yadav@...com>,
        linux-aspeed@...ts.ozlabs.org, openbmc@...ts.ozlabs.org,
        Joel Stanley <joel@....id.au>,
        Andrew Jeffery <andrew@...id.au>,
        Chin-Ting Kuo <chin-ting_kuo@...eedtech.com>,
        linux-arm-kernel@...ts.infradead.org, linux-kernel@...r.kernel.org,
        Cédric Le Goater <clg@...d.org>,
        Ian Woloschin <ian.woloschin@...mai.com>
Subject: [PATCH] spi: aspeed: Fix division by zero

When using the normal read operation for data transfers, the dummy bus
width is zero. In that case, they are no dummy bytes to transfer and
setting the dummy field in the controller register becomes useless.

Issue was found on a custom "Bifrost" board with a AST2500 SoC and
using a MX25L51245GMI-08G SPI Flash.

Cc: Chin-Ting Kuo <chin-ting_kuo@...eedtech.com>
Reported-by: Ian Woloschin <ian.woloschin@...mai.com>
Fixes: 54613fc6659b ("spi: aspeed: Add support for direct mapping")
Signed-off-by: Cédric Le Goater <clg@...d.org>
---
 drivers/spi/spi-aspeed-smc.c | 12 +++++++++++-
 1 file changed, 11 insertions(+), 1 deletion(-)

diff --git a/drivers/spi/spi-aspeed-smc.c b/drivers/spi/spi-aspeed-smc.c
index 496f3e1e9079..3e891bf22470 100644
--- a/drivers/spi/spi-aspeed-smc.c
+++ b/drivers/spi/spi-aspeed-smc.c
@@ -558,6 +558,14 @@ static int aspeed_spi_dirmap_create(struct spi_mem_dirmap_desc *desc)
 	u32 ctl_val;
 	int ret = 0;
 
+	dev_dbg(aspi->dev,
+		"CE%d %s dirmap [ 0x%.8llx - 0x%.8llx ] OP %#x mode:%d.%d.%d.%d naddr:%#x ndummies:%#x\n",
+		chip->cs, op->data.dir == SPI_MEM_DATA_IN ? "read" : "write",
+		desc->info.offset, desc->info.offset + desc->info.length,
+		op->cmd.opcode, op->cmd.buswidth, op->addr.buswidth,
+		op->dummy.buswidth, op->data.buswidth,
+		op->addr.nbytes, op->dummy.nbytes);
+
 	chip->clk_freq = desc->mem->spi->max_speed_hz;
 
 	/* Only for reads */
@@ -574,9 +582,11 @@ static int aspeed_spi_dirmap_create(struct spi_mem_dirmap_desc *desc)
 	ctl_val = readl(chip->ctl) & ~CTRL_IO_CMD_MASK;
 	ctl_val |= aspeed_spi_get_io_mode(op) |
 		op->cmd.opcode << CTRL_COMMAND_SHIFT |
-		CTRL_IO_DUMMY_SET(op->dummy.nbytes / op->dummy.buswidth) |
 		CTRL_IO_MODE_READ;
 
+	if (op->dummy.nbytes)
+		ctl_val |= CTRL_IO_DUMMY_SET(op->dummy.nbytes / op->dummy.buswidth);
+
 	/* Tune 4BYTE address mode */
 	if (op->addr.nbytes) {
 		u32 addr_mode = readl(aspi->regs + CE_CTRL_REG);
-- 
2.35.3