| lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
|
Open Source and information security mailing list archives
| ||
|
Message-Id: <20220818164616.2064242-9-sean.anderson@seco.com>
Date: Thu, 18 Aug 2022 12:46:14 -0400
From: Sean Anderson <sean.anderson@...o.com>
To: netdev@...r.kernel.org, Andrew Lunn <andrew@...n.ch>,
Heiner Kallweit <hkallweit1@...il.com>,
Russell King <linux@...linux.org.uk>
Cc: "David S . Miller" <davem@...emloft.net>,
Paolo Abeni <pabeni@...hat.com>,
Vladimir Oltean <olteanv@...il.com>,
linux-kernel@...r.kernel.org, Eric Dumazet <edumazet@...gle.com>,
Jakub Kicinski <kuba@...nel.org>,
Alexandru Marginean <alexandru.marginean@....com>,
Sean Anderson <sean.anderson@...o.com>
Subject: [PATCH net-next v4 08/10] net: phylink: Adjust advertisement based on rate adaptation
This adds support for adjusting the advertisement for pause-based rate
adaptation. This may result in a lossy link, since the final link settings
are not adjusted. Asymmetric pause support is necessary. It would be
possible for a MAC supporting only symmetric pause to use pause-based rate
adaptation, but only if pause reception was enabled as well.
Signed-off-by: Sean Anderson <sean.anderson@...o.com>
---
(no changes since v3)
Changes in v3:
- Add phylink_cap_from_speed_duplex to look up the mac capability
corresponding to the interface's speed.
- Include RATE_ADAPT_CRS; it's a few lines and it doesn't hurt.
Changes in v2:
- Determine the interface speed and max mac speed directly instead of
guessing based on the caps.
drivers/net/phy/phylink.c | 58 +++++++++++++++++++++++++++++++++++++--
include/linux/phylink.h | 3 +-
2 files changed, 57 insertions(+), 4 deletions(-)
diff --git a/drivers/net/phy/phylink.c b/drivers/net/phy/phylink.c
index 3e4bbeb1fab2..6cc033148ebf 100644
--- a/drivers/net/phy/phylink.c
+++ b/drivers/net/phy/phylink.c
@@ -433,14 +433,18 @@ EXPORT_SYMBOL_GPL(phylink_caps_find_max_speed);
* phylink_get_capabilities() - get capabilities for a given MAC
* @interface: phy interface mode defined by &typedef phy_interface_t
* @mac_capabilities: bitmask of MAC capabilities
+ * @rate_adaptation: type of rate adaptation being performed
*
* Get the MAC capabilities that are supported by the @interface mode and
* @mac_capabilities.
*/
unsigned long phylink_get_capabilities(phy_interface_t interface,
- unsigned long mac_capabilities)
+ unsigned long mac_capabilities,
+ int rate_adaptation)
{
+ int max_speed = phylink_interface_max_speed(interface);
unsigned long caps = MAC_SYM_PAUSE | MAC_ASYM_PAUSE;
+ unsigned long adapted_caps = 0;
switch (interface) {
case PHY_INTERFACE_MODE_USXGMII:
@@ -513,7 +517,53 @@ unsigned long phylink_get_capabilities(phy_interface_t interface,
break;
}
- return caps & mac_capabilities;
+ switch (rate_adaptation) {
+ case RATE_ADAPT_OPEN_LOOP:
+ /* TODO */
+ fallthrough;
+ case RATE_ADAPT_NONE:
+ adapted_caps = 0;
+ break;
+ case RATE_ADAPT_PAUSE: {
+ /* The MAC must support asymmetric pause towards the local
+ * device for this. We could allow just symmetric pause, but
+ * then we might have to renegotiate if the link partner
+ * doesn't support pause. This is because there's no way to
+ * accept pause frames without transmitting them if we only
+ * support symmetric pause.
+ */
+ if (!(mac_capabilities & MAC_SYM_PAUSE) ||
+ !(mac_capabilities & MAC_ASYM_PAUSE))
+ break;
+
+ /* We can't adapt if the MAC doesn't support the interface's
+ * max speed at full duplex.
+ */
+ if (mac_capabilities &
+ phylink_cap_from_speed_duplex(max_speed, DUPLEX_FULL)) {
+ /* Although a duplex-adapting phy might exist, we
+ * conservatively remove these modes because the MAC
+ * will not be aware of the half-duplex nature of the
+ * link.
+ */
+ adapted_caps = GENMASK(__fls(caps), __fls(MAC_10HD));
+ adapted_caps &= ~(MAC_1000HD | MAC_100HD | MAC_10HD);
+ }
+ break;
+ }
+ case RATE_ADAPT_CRS:
+ /* The MAC must support half duplex at the interface's max
+ * speed.
+ */
+ if (mac_capabilities &
+ phylink_cap_from_speed_duplex(max_speed, DUPLEX_HALF)) {
+ adapted_caps = GENMASK(__fls(caps), __fls(MAC_10HD));
+ adapted_caps &= mac_capabilities;
+ }
+ break;
+ }
+
+ return (caps & mac_capabilities) | adapted_caps;
}
EXPORT_SYMBOL_GPL(phylink_get_capabilities);
@@ -537,7 +587,8 @@ void phylink_generic_validate(struct phylink_config *config,
phylink_set_port_modes(mask);
phylink_set(mask, Autoneg);
caps = phylink_get_capabilities(state->interface,
- config->mac_capabilities);
+ config->mac_capabilities,
+ state->rate_adaptation);
phylink_caps_to_linkmodes(mask, caps);
linkmode_and(supported, supported, mask);
@@ -1563,6 +1614,7 @@ static int phylink_bringup_phy(struct phylink *pl, struct phy_device *phy,
config.interface = PHY_INTERFACE_MODE_NA;
else
config.interface = interface;
+ config.rate_adaptation = phy_get_rate_adaptation(phy, config.interface);
ret = phylink_validate(pl, supported, &config);
if (ret) {
diff --git a/include/linux/phylink.h b/include/linux/phylink.h
index 192a18a8674a..265a344e1039 100644
--- a/include/linux/phylink.h
+++ b/include/linux/phylink.h
@@ -543,7 +543,8 @@ void phylink_caps_to_linkmodes(unsigned long *linkmodes, unsigned long caps);
int phylink_caps_find_max_speed(unsigned long caps, int *speed,
unsigned int *duplex);
unsigned long phylink_get_capabilities(phy_interface_t interface,
- unsigned long mac_capabilities);
+ unsigned long mac_capabilities,
+ int rate_adaptation);
void phylink_generic_validate(struct phylink_config *config,
unsigned long *supported,
struct phylink_link_state *state);
--
2.35.1.1320.gc452695387.dirty
Powered by blists - more mailing lists