linux-kernel - Re: [PATCH v2 14/16] hwmon: (mr75203) parse thermal coefficients from device-tree

lists.openwall.net		lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC
Open Source and information security mailing list archives

Hash Suite: Windows password security audit tool. GUI, reports in PDF.

[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]

Message-ID: <20220819113644.GC3106213@roeck-us.net>
Date:   Fri, 19 Aug 2022 04:36:44 -0700
From:   Guenter Roeck <linux@...ck-us.net>
To:     "Farber, Eliav" <farbere@...zon.com>
Cc:     jdelvare@...e.com, robh+dt@...nel.org, mark.rutland@....com,
        linux-hwmon@...r.kernel.org, devicetree@...r.kernel.org,
        linux-kernel@...r.kernel.org, talel@...zon.com, hhhawa@...zon.com,
        jonnyc@...zon.com, hanochu@...zon.com, ronenk@...zon.com,
        itamark@...zon.com, shellykz@...zon.com, shorer@...zon.com,
        amitlavi@...zon.com, almogbs@...zon.com, dwmw@...zon.co.uk,
        rtanwar@...linear.com
Subject: Re: [PATCH v2 14/16] hwmon: (mr75203) parse thermal coefficients
 from device-tree

On Fri, Aug 19, 2022 at 10:57:58AM +0300, Farber, Eliav wrote:
> On 8/18/2022 11:28 PM, Guenter Roeck wrote:
> > The calculation was just changed to use new defaults in a previous
> > patch. This patch makes it quite clear that the coefficients
> > are implementation (?) dependent. So the previous patch just changes
> > the defaults to (presumably) the coefficients used in your system.
> > That is inappropriate. Adding non-default corefficients is ok
> > and makes sense is supported by the chip, but changing defaults
> > isn't.
> The calculation was changed in previous patch to match series 5 of the
> Moortec Embedded Temperature Sensor (METS) datasheet.
> In our SOC we use series 6 which has a slightly different equation and
> different coefficients.
> I did the changes in steps.
> With this last change, both series 5 and 6 are supported, in addition to
> calibrated vs. non-calibrated modes.
> In addition the data sheet just recommends default values but they also
> specifically mention that actual values might vary from product to product.
> 
Please mention all this in the commit description.

Guenter

> --
> Regards, Eliav