[<prev] [next>] [thread-next>] [day] [month] [year] [list]
Message-Id: <20220830182821.47919-1-andriy.shevchenko@linux.intel.com>
Date: Tue, 30 Aug 2022 21:28:20 +0300
From: Andy Shevchenko <andriy.shevchenko@...ux.intel.com>
To: Mark Brown <broonie@...nel.org>,
Patrice Chotard <patrice.chotard@...s.st.com>,
linux-spi@...r.kernel.org,
linux-stm32@...md-mailman.stormreply.com,
linux-arm-kernel@...ts.infradead.org, linux-kernel@...r.kernel.org
Cc: Maxime Coquelin <mcoquelin.stm32@...il.com>,
Alexandre Torgue <alexandre.torgue@...s.st.com>,
Andy Shevchenko <andriy.shevchenko@...ux.intel.com>
Subject: [PATCH v1 1/2] spi: stm32-qspi: Replace of_gpio_named_count() by gpiod_count()
As a preparation to unexport of_gpio_named_count(), convert the
driver to use gpiod_count() instead.
Signed-off-by: Andy Shevchenko <andriy.shevchenko@...ux.intel.com>
---
drivers/spi/spi-stm32-qspi.c | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/drivers/spi/spi-stm32-qspi.c b/drivers/spi/spi-stm32-qspi.c
index 227f450aa5f0..5858f5f9c758 100644
--- a/drivers/spi/spi-stm32-qspi.c
+++ b/drivers/spi/spi-stm32-qspi.c
@@ -656,7 +656,7 @@ static int stm32_qspi_setup(struct spi_device *spi)
mode = spi->mode & (SPI_TX_OCTAL | SPI_RX_OCTAL);
if ((mode == SPI_TX_OCTAL || mode == SPI_RX_OCTAL) ||
((mode == (SPI_TX_OCTAL | SPI_RX_OCTAL)) &&
- of_gpio_named_count(qspi->dev->of_node, "cs-gpios") == -ENOENT)) {
+ gpiod_count(qspi->dev, "cs") == -ENOENT)) {
dev_err(qspi->dev, "spi-rx-bus-width\\/spi-tx-bus-width\\/cs-gpios\n");
dev_err(qspi->dev, "configuration not supported\n");
@@ -681,7 +681,7 @@ static int stm32_qspi_setup(struct spi_device *spi)
* are both set in spi->mode and "cs-gpios" properties is found in DT
*/
if (((spi->mode & (SPI_TX_OCTAL | SPI_RX_OCTAL)) == (SPI_TX_OCTAL | SPI_RX_OCTAL)) &&
- of_gpio_named_count(qspi->dev->of_node, "cs-gpios")) {
+ gpiod_count(qspi->dev, "cs")) {
qspi->cr_reg |= CR_DFM;
dev_dbg(qspi->dev, "Dual flash mode enable");
}
--
2.35.1
Powered by blists - more mailing lists