linux-kernel - Re: [PATCH v2] wifi: ath11k: Trigger sta disconnect on hardware restart

lists.openwall.net		lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC
Open Source and information security mailing list archives

Hash Suite: Windows password security audit tool. GUI, reports in PDF.

[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]

Message-ID: <eb549cdc-01ef-2f9b-719c-3c2857e43313@quicinc.com>
Date:   Fri, 4 Nov 2022 16:20:39 +0530
From:   "Youghandhar Chintala (Temp)" <quic_youghand@...cinc.com>
To:     Kalle Valo <kvalo@...nel.org>
CC:     <ath11k@...ts.infradead.org>, <linux-wireless@...r.kernel.org>,
        <linux-kernel@...r.kernel.org>, kernel test robot <lkp@...el.com>
Subject: Re: [PATCH v2] wifi: ath11k: Trigger sta disconnect on hardware
 restart


On 11/4/2022 4:17 PM, Kalle Valo wrote:
> Youghandhar Chintala <quic_youghand@...cinc.com> wrote:
>
>> Currently after the hardware restart triggered from the driver, the
>> station interface connection remains intact, since a disconnect trigger
>> is not sent to userspace. This can lead to a problem in targets where
>> the wifi mac sequence is added by the firmware.
>>
>> After the target restart, its wifi mac sequence number gets reset to
>> zero. Hence AP to which our device is connected will receive frames with
>> a  wifi mac sequence number jump to the past, thereby resulting in the
>> AP dropping all these frames, until the frame arrives with a wifi mac
>> sequence number which AP was expecting.
>>
>> To avoid such frame drops, its better to trigger a station disconnect
>> upon target hardware restart which can be done with API
>> ieee80211_reconfig_disconnect exposed to mac80211.
>>
>> The other targets are not affected by this change, since the hardware
>> params flag is not set.
>>
>> Reported-by: kernel test robot <lkp@...el.com>
>>
>> Tested-on: WCN6750 hw1.0 AHB WLAN.MSL.1.0.1-00887-QCAMSLSWPLZ-1
>>
>> Signed-off-by: Youghandhar Chintala <quic_youghand@...cinc.com>
>> Signed-off-by: Kalle Valo <quic_kvalo@...cinc.com>
> This had a new warning:
>
> drivers/net/wireless/ath/ath11k/mac.c:8056: Blank lines aren't necessary before a close brace '}'
>
> I fixed it in the pending branch.

Thank you Kalle.

Regards,

Youghandhar