[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]
Message-ID: <Y7Mjx8ZEVEcU2mK8@lunn.ch>
Date: Mon, 2 Jan 2023 19:34:47 +0100
From: Andrew Lunn <andrew@...n.ch>
To: Roger Quadros <rogerq@...nel.org>
Cc: MD Danish Anwar <danishanwar@...com>,
"Andrew F. Davis" <afd@...com>, Tero Kristo <t-kristo@...com>,
Suman Anna <s-anna@...com>, YueHaibing <yuehaibing@...wei.com>,
Vignesh Raghavendra <vigneshr@...com>,
Krzysztof Kozlowski <krzysztof.kozlowski+dt@...aro.org>,
Rob Herring <robh+dt@...nel.org>,
Paolo Abeni <pabeni@...hat.com>,
Jakub Kicinski <kuba@...nel.org>,
Eric Dumazet <edumazet@...gle.com>,
"David S. Miller" <davem@...emloft.net>, nm@...com,
ssantosh@...nel.org, srk@...com, linux-kernel@...r.kernel.org,
devicetree@...r.kernel.org, netdev@...r.kernel.org,
linux-omap@...r.kernel.org, linux-arm-kernel@...ts.infradead.org
Subject: Re: [PATCH v3 1/2] dt-bindings: net: Add ICSSG Ethernet Driver
bindings
On Mon, Jan 02, 2023 at 03:04:19PM +0200, Roger Quadros wrote:
>
>
> On 23/12/2022 16:28, Andrew Lunn wrote:
> >> + ethernet-ports {
> >> + #address-cells = <1>;
> >> + #size-cells = <0>;
> >> + pruss2_emac0: port@0 {
> >> + reg = <0>;
> >> + phy-handle = <&pruss2_eth0_phy>;
> >> + phy-mode = "rgmii-rxid";
> >
> > That is unusual. Where are the TX delays coming from?
>
> >From the below property
>
> + ti,syscon-rgmii-delay = <&scm_conf 0x4120>;
>
> The TX delay can be enabled/disabled from within the ICSSG block.
>
> If this property exists and PHY mode is neither PHY_INTERFACE_MODE_RGMII_ID
> nor PHY_INTERFACE_MODE_RGMII_TXID then the internal delay is enabled.
>
> This logic is in prueth_config_rgmiidelay() function in the introduced driver.
What nearly every other MAC driver does is pass the phy-mode to the
PHY and lets the PHY add the delays. I would recommend you do that,
rather than be special and different.
Andrew
Powered by blists - more mailing lists