linux-kernel - [PATCH 0/2] iio: ad74413r: allow setting sink current for digital input

lists.openwall.net		lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC
Open Source and information security mailing list archives

Hash Suite: Windows password security audit tool. GUI, reports in PDF.

[<prev] [next>] [thread-next>] [day] [month] [year] [list]

Message-Id: <20230302134922.1120217-1-linux@rasmusvillemoes.dk>
Date:   Thu,  2 Mar 2023 14:49:19 +0100
From:   Rasmus Villemoes <linux@...musvillemoes.dk>
To:     Lars-Peter Clausen <lars@...afoo.de>,
        Michael Hennerich <Michael.Hennerich@...log.com>,
        Cosmin Tanislav <cosmin.tanislav@...log.com>,
        Jonathan Cameron <jic23@...nel.org>, linux-iio@...r.kernel.org,
        linux-kernel@...r.kernel.org
Cc:     devicetree@...r.kernel.org, Rob Herring <robh+dt@...nel.org>,
        Rasmus Villemoes <linux@...musvillemoes.dk>
Subject: [PATCH 0/2] iio: ad74413r: allow setting sink current for digital input

Depending on the actual hardware wired up to a digital input channel,
it may be necessary to configure the ad74413r to sink a small
current. For example, in the case of a simple mechanical switch, the
charge on the external 68 nF capacitor (cf. the data sheet's Figure
34) will keep the channel as reading high even after the switch is
turned off again.

Add a DT binding and driver support for setting the desired sink current.

I have chosen the term "drive strength" because it matches existing
practice, even if this is only a sink. E.g. there's

 * @PIN_CONFIG_DRIVE_STRENGTH_UA: the pin will sink or source at most the current
 *      passed as argument. The argument is in uA.

and indeed it would be trivial to hook up that
PIN_CONFIG_DRIVE_STRENGTH_UA in ad74413r_gpio_set_comp_config().

However, unlike the debounce time, there does not appear to be any way
to actually tweak the drive strength from userspace, nor do I know if
that would actually be a good idea. For our application(s), the
current sink needed is a property of the attached hardware, and thus
can and should be defined in DT.

Rasmus Villemoes (2):
  dt-bindings: iio: ad74413r: allow setting sink current for digital
    input
  iio: ad74413r: wire up support for drive-strength-microamp property

 .../bindings/iio/addac/adi,ad74413r.yaml      | 10 ++++++++
 drivers/iio/addac/ad74413r.c                  | 24 +++++++++++++++++++
 2 files changed, 34 insertions(+)

-- 
2.37.2