| lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
|
Open Source and information security mailing list archives
| ||
|
Message-Id: <20230330135747.15684-1-andriy.shevchenko@linux.intel.com>
Date: Thu, 30 Mar 2023 16:57:47 +0300
From: Andy Shevchenko <andriy.shevchenko@...ux.intel.com>
To: Wolfram Sang <wsa@...nel.org>,
Khalil Blaiech <kblaiech@...dia.com>,
Asmaa Mnebhi <asmaa@...dia.com>, linux-i2c@...r.kernel.org,
linux-kernel@...r.kernel.org
Cc: Andy Shevchenko <andriy.shevchenko@...ux.intel.com>
Subject: [PATCH v1 1/1] i2c: mlxbf: Use readl_poll_timeout_atomic() for polling
Convert the usage of an open-coded custom tight poll while loop
with the provided readl_poll_timeout_atomic() macro.
Signed-off-by: Andy Shevchenko <andriy.shevchenko@...ux.intel.com>
---
drivers/i2c/busses/i2c-mlxbf.c | 106 ++++++++-------------------------
1 file changed, 26 insertions(+), 80 deletions(-)
diff --git a/drivers/i2c/busses/i2c-mlxbf.c b/drivers/i2c/busses/i2c-mlxbf.c
index 1810d5791b3d..8087c556694d 100644
--- a/drivers/i2c/busses/i2c-mlxbf.c
+++ b/drivers/i2c/busses/i2c-mlxbf.c
@@ -12,6 +12,7 @@
#include <linux/interrupt.h>
#include <linux/i2c.h>
#include <linux/io.h>
+#include <linux/iopoll.h>
#include <linux/kernel.h>
#include <linux/module.h>
#include <linux/mutex.h>
@@ -495,65 +496,6 @@ static u8 mlxbf_i2c_bus_count;
static struct mutex mlxbf_i2c_bus_lock;
-/*
- * Function to poll a set of bits at a specific address; it checks whether
- * the bits are equal to zero when eq_zero is set to 'true', and not equal
- * to zero when eq_zero is set to 'false'.
- * Note that the timeout is given in microseconds.
- */
-static u32 mlxbf_i2c_poll(void __iomem *io, u32 addr, u32 mask,
- bool eq_zero, u32 timeout)
-{
- u32 bits;
-
- timeout = (timeout / MLXBF_I2C_POLL_FREQ_IN_USEC) + 1;
-
- do {
- bits = readl(io + addr) & mask;
- if (eq_zero ? bits == 0 : bits != 0)
- return eq_zero ? 1 : bits;
- udelay(MLXBF_I2C_POLL_FREQ_IN_USEC);
- } while (timeout-- != 0);
-
- return 0;
-}
-
-/*
- * SW must make sure that the SMBus Master GW is idle before starting
- * a transaction. Accordingly, this function polls the Master FSM stop
- * bit; it returns false when the bit is asserted, true if not.
- */
-static bool mlxbf_i2c_smbus_master_wait_for_idle(struct mlxbf_i2c_priv *priv)
-{
- u32 mask = MLXBF_I2C_SMBUS_MASTER_FSM_STOP_MASK;
- u32 addr = priv->chip->smbus_master_fsm_off;
- u32 timeout = MLXBF_I2C_SMBUS_TIMEOUT;
-
- if (mlxbf_i2c_poll(priv->mst->io, addr, mask, true, timeout))
- return true;
-
- return false;
-}
-
-/*
- * wait for the lock to be released before acquiring it.
- */
-static bool mlxbf_i2c_smbus_master_lock(struct mlxbf_i2c_priv *priv)
-{
- if (mlxbf_i2c_poll(priv->mst->io, MLXBF_I2C_SMBUS_MASTER_GW,
- MLXBF_I2C_MASTER_LOCK_BIT, true,
- MLXBF_I2C_SMBUS_LOCK_POLL_TIMEOUT))
- return true;
-
- return false;
-}
-
-static void mlxbf_i2c_smbus_master_unlock(struct mlxbf_i2c_priv *priv)
-{
- /* Clear the gw to clear the lock */
- writel(0, priv->mst->io + MLXBF_I2C_SMBUS_MASTER_GW);
-}
-
static bool mlxbf_i2c_smbus_transaction_success(u32 master_status,
u32 cause_status)
{
@@ -583,6 +525,7 @@ static int mlxbf_i2c_smbus_check_status(struct mlxbf_i2c_priv *priv)
{
u32 master_status_bits;
u32 cause_status_bits;
+ u32 bits;
/*
* GW busy bit is raised by the driver and cleared by the HW
@@ -591,9 +534,9 @@ static int mlxbf_i2c_smbus_check_status(struct mlxbf_i2c_priv *priv)
* then read the cause and master status bits to determine if
* errors occurred during the transaction.
*/
- mlxbf_i2c_poll(priv->mst->io, MLXBF_I2C_SMBUS_MASTER_GW,
- MLXBF_I2C_MASTER_BUSY_BIT, true,
- MLXBF_I2C_SMBUS_TIMEOUT);
+ readl_poll_timeout_atomic(priv->mst->io + MLXBF_I2C_SMBUS_MASTER_GW,
+ bits, !(bits & MLXBF_I2C_MASTER_BUSY_BIT),
+ MLXBF_I2C_POLL_FREQ_IN_USEC, MLXBF_I2C_SMBUS_TIMEOUT);
/* Read cause status bits. */
cause_status_bits = readl(priv->mst_cause->io +
@@ -740,7 +683,8 @@ mlxbf_i2c_smbus_start_transaction(struct mlxbf_i2c_priv *priv,
u8 read_en, write_en, block_en, pec_en;
u8 slave, flags, addr;
u8 *read_buf;
- int ret = 0;
+ u32 bits;
+ int ret;
if (request->operation_cnt > MLXBF_I2C_SMBUS_MAX_OP_CNT)
return -EINVAL;
@@ -760,11 +704,22 @@ mlxbf_i2c_smbus_start_transaction(struct mlxbf_i2c_priv *priv,
* Try to acquire the smbus gw lock before any reads of the GW register since
* a read sets the lock.
*/
- if (WARN_ON(!mlxbf_i2c_smbus_master_lock(priv)))
+ ret = readl_poll_timeout_atomic(priv->mst->io + MLXBF_I2C_SMBUS_MASTER_GW,
+ bits, !(bits & MLXBF_I2C_MASTER_LOCK_BIT),
+ MLXBF_I2C_POLL_FREQ_IN_USEC,
+ MLXBF_I2C_SMBUS_LOCK_POLL_TIMEOUT);
+ if (WARN_ON(ret))
return -EBUSY;
- /* Check whether the HW is idle */
- if (WARN_ON(!mlxbf_i2c_smbus_master_wait_for_idle(priv))) {
+ /*
+ * SW must make sure that the SMBus Master GW is idle before starting
+ * a transaction. Accordingly, this call polls the Master FSM stop bit;
+ * it returns 0 when the bit is asserted, -ETIMEDOUT if not.
+ */
+ ret = readl_poll_timeout_atomic(priv->mst->io + priv->chip->smbus_master_fsm_off,
+ bits, !(bits & MLXBF_I2C_SMBUS_MASTER_FSM_STOP_MASK),
+ MLXBF_I2C_POLL_FREQ_IN_USEC, MLXBF_I2C_SMBUS_TIMEOUT);
+ if (WARN_ON(ret)) {
ret = -EBUSY;
goto out_unlock;
}
@@ -855,7 +810,8 @@ mlxbf_i2c_smbus_start_transaction(struct mlxbf_i2c_priv *priv,
}
out_unlock:
- mlxbf_i2c_smbus_master_unlock(priv);
+ /* Clear the gw to clear the lock */
+ writel(0, priv->mst->io + MLXBF_I2C_SMBUS_MASTER_GW);
return ret;
}
@@ -1835,18 +1791,6 @@ static bool mlxbf_i2c_has_coalesce(struct mlxbf_i2c_priv *priv, bool *read,
return true;
}
-static bool mlxbf_i2c_slave_wait_for_idle(struct mlxbf_i2c_priv *priv,
- u32 timeout)
-{
- u32 mask = MLXBF_I2C_CAUSE_S_GW_BUSY_FALL;
- u32 addr = MLXBF_I2C_CAUSE_ARBITER;
-
- if (mlxbf_i2c_poll(priv->slv_cause->io, addr, mask, false, timeout))
- return true;
-
- return false;
-}
-
static struct i2c_client *mlxbf_i2c_get_slave_from_addr(
struct mlxbf_i2c_priv *priv, u8 addr)
{
@@ -1949,7 +1893,9 @@ static int mlxbf_i2c_irq_send(struct mlxbf_i2c_priv *priv, u8 recv_bytes)
* Wait until the transfer is completed; the driver will wait
* until the GW is idle, a cause will rise on fall of GW busy.
*/
- mlxbf_i2c_slave_wait_for_idle(priv, MLXBF_I2C_SMBUS_TIMEOUT);
+ readl_poll_timeout_atomic(priv->slv_cause->io + MLXBF_I2C_CAUSE_ARBITER,
+ data32, data32 & MLXBF_I2C_CAUSE_S_GW_BUSY_FALL,
+ MLXBF_I2C_POLL_FREQ_IN_USEC, MLXBF_I2C_SMBUS_TIMEOUT);
clear_csr:
/* Release the Slave GW. */
--
2.40.0.1.gaa8946217a0b
Powered by blists - more mailing lists