| lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
|
Open Source and information security mailing list archives
| ||
|
Message-ID: <20230419035646.43702-4-changhuang.liang@starfivetech.com>
Date: Tue, 18 Apr 2023 20:56:43 -0700
From: Changhuang Liang <changhuang.liang@...rfivetech.com>
To: Rob Herring <robh+dt@...nel.org>,
Krzysztof Kozlowski <krzysztof.kozlowski+dt@...aro.org>,
Emil Renner Berthing <kernel@...il.dk>,
Conor Dooley <conor@...nel.org>,
Paul Walmsley <paul.walmsley@...ive.com>,
Palmer Dabbelt <palmer@...belt.com>,
Albert Ou <aou@...s.berkeley.edu>
CC: Walker Chen <walker.chen@...rfivetech.com>,
Changhuang Liang <changhuang.liang@...rfivetech.com>,
Hal Feng <hal.feng@...rfivetech.com>,
<devicetree@...r.kernel.org>, <linux-kernel@...r.kernel.org>,
<linux-riscv@...ts.infradead.org>
Subject: [RESEND v2 3/6] soc: starfive: Modify ioremap to regmap
Modify ioremap to regmap which can be compatible with the syscon
interface, such as:
struct regmap *syscon_node_to_regmap(struct device_node *np)
Convenient introduction of syscon operation.
Signed-off-by: Changhuang Liang <changhuang.liang@...rfivetech.com>
---
drivers/soc/starfive/jh71xx_pmu.c | 43 +++++++++++++++++--------------
1 file changed, 23 insertions(+), 20 deletions(-)
diff --git a/drivers/soc/starfive/jh71xx_pmu.c b/drivers/soc/starfive/jh71xx_pmu.c
index 7d5f50d71c0d..306218c83691 100644
--- a/drivers/soc/starfive/jh71xx_pmu.c
+++ b/drivers/soc/starfive/jh71xx_pmu.c
@@ -6,13 +6,13 @@
*/
#include <linux/interrupt.h>
-#include <linux/io.h>
-#include <linux/iopoll.h>
+#include <linux/mfd/syscon.h>
#include <linux/module.h>
#include <linux/of.h>
#include <linux/of_device.h>
#include <linux/platform_device.h>
#include <linux/pm_domain.h>
+#include <linux/regmap.h>
#include <dt-bindings/power/starfive,jh7110-pmu.h>
/* register offset */
@@ -59,7 +59,7 @@ struct jh71xx_pmu_match_data {
struct jh71xx_pmu {
struct device *dev;
const struct jh71xx_pmu_match_data *match_data;
- void __iomem *base;
+ struct regmap *base;
struct generic_pm_domain **genpd;
struct genpd_onecell_data genpd_data;
int irq;
@@ -75,11 +75,14 @@ struct jh71xx_pmu_dev {
static int jh71xx_pmu_get_state(struct jh71xx_pmu_dev *pmd, u32 mask, bool *is_on)
{
struct jh71xx_pmu *pmu = pmd->pmu;
+ unsigned int val;
if (!mask)
return -EINVAL;
- *is_on = readl(pmu->base + JH71XX_PMU_CURR_POWER_MODE) & mask;
+ regmap_read(pmu->base, JH71XX_PMU_CURR_POWER_MODE, &val);
+
+ *is_on = val & mask;
return 0;
}
@@ -130,7 +133,7 @@ static int jh71xx_pmu_set_state(struct jh71xx_pmu_dev *pmd, u32 mask, bool on)
encourage_hi = JH71XX_PMU_SW_ENCOURAGE_DIS_HI;
}
- writel(mask, pmu->base + mode);
+ regmap_write(pmu->base, mode, mask);
/*
* 2.Write SW encourage command sequence to the Software Encourage Reg (offset 0x44)
@@ -140,21 +143,21 @@ static int jh71xx_pmu_set_state(struct jh71xx_pmu_dev *pmd, u32 mask, bool on)
* Then write the lower bits of the command sequence, followed by the upper
* bits. The sequence differs between powering on & off a domain.
*/
- writel(JH71XX_PMU_SW_ENCOURAGE_ON, pmu->base + JH71XX_PMU_SW_ENCOURAGE);
- writel(encourage_lo, pmu->base + JH71XX_PMU_SW_ENCOURAGE);
- writel(encourage_hi, pmu->base + JH71XX_PMU_SW_ENCOURAGE);
+ regmap_write(pmu->base, JH71XX_PMU_SW_ENCOURAGE, JH71XX_PMU_SW_ENCOURAGE_ON);
+ regmap_write(pmu->base, JH71XX_PMU_SW_ENCOURAGE, encourage_lo);
+ regmap_write(pmu->base, JH71XX_PMU_SW_ENCOURAGE, encourage_hi);
spin_unlock_irqrestore(&pmu->lock, flags);
/* Wait for the power domain bit to be enabled / disabled */
if (on) {
- ret = readl_poll_timeout_atomic(pmu->base + JH71XX_PMU_CURR_POWER_MODE,
- val, val & mask,
- 1, JH71XX_PMU_TIMEOUT_US);
+ ret = regmap_read_poll_timeout_atomic(pmu->base, JH71XX_PMU_CURR_POWER_MODE,
+ val, val & mask,
+ 1, JH71XX_PMU_TIMEOUT_US);
} else {
- ret = readl_poll_timeout_atomic(pmu->base + JH71XX_PMU_CURR_POWER_MODE,
- val, !(val & mask),
- 1, JH71XX_PMU_TIMEOUT_US);
+ ret = regmap_read_poll_timeout_atomic(pmu->base, JH71XX_PMU_CURR_POWER_MODE,
+ val, !(val & mask),
+ 1, JH71XX_PMU_TIMEOUT_US);
}
if (ret) {
@@ -190,14 +193,14 @@ static void jh71xx_pmu_int_enable(struct jh71xx_pmu *pmu, u32 mask, bool enable)
unsigned long flags;
spin_lock_irqsave(&pmu->lock, flags);
- val = readl(pmu->base + JH71XX_PMU_TIMER_INT_MASK);
+ regmap_read(pmu->base, JH71XX_PMU_TIMER_INT_MASK, &val);
if (enable)
val &= ~mask;
else
val |= mask;
- writel(val, pmu->base + JH71XX_PMU_TIMER_INT_MASK);
+ regmap_write(pmu->base, JH71XX_PMU_TIMER_INT_MASK, val);
spin_unlock_irqrestore(&pmu->lock, flags);
}
@@ -206,7 +209,7 @@ static irqreturn_t jh71xx_pmu_interrupt(int irq, void *data)
struct jh71xx_pmu *pmu = data;
u32 val;
- val = readl(pmu->base + JH71XX_PMU_INT_STATUS);
+ regmap_read(pmu->base, JH71XX_PMU_INT_STATUS, &val);
if (val & JH71XX_PMU_INT_SEQ_DONE)
dev_dbg(pmu->dev, "sequence done.\n");
@@ -220,8 +223,8 @@ static irqreturn_t jh71xx_pmu_interrupt(int irq, void *data)
dev_err(pmu->dev, "p-channel fail event.\n");
/* clear interrupts */
- writel(val, pmu->base + JH71XX_PMU_INT_STATUS);
- writel(val, pmu->base + JH71XX_PMU_EVENT_STATUS);
+ regmap_write(pmu->base, JH71XX_PMU_INT_STATUS, val);
+ regmap_write(pmu->base, JH71XX_PMU_EVENT_STATUS, val);
return IRQ_HANDLED;
}
@@ -271,7 +274,7 @@ static int jh71xx_pmu_probe(struct platform_device *pdev)
if (!pmu)
return -ENOMEM;
- pmu->base = devm_platform_ioremap_resource(pdev, 0);
+ pmu->base = device_node_to_regmap(np);
if (IS_ERR(pmu->base))
return PTR_ERR(pmu->base);
--
2.25.1
Powered by blists - more mailing lists