| lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
|
Open Source and information security mailing list archives
| ||
|
Message-Id: <20230502010759.17282-6-aford173@gmail.com>
Date: Mon, 1 May 2023 20:07:57 -0500
From: Adam Ford <aford173@...il.com>
To: dri-devel@...ts.freedesktop.org
Cc: marex@...x.de, aford@...conembedded.com,
Adam Ford <aford173@...il.com>,
Chen-Yu Tsai <wenst@...omium.org>,
Andrzej Hajda <andrzej.hajda@...el.com>,
Neil Armstrong <neil.armstrong@...aro.org>,
Robert Foss <rfoss@...nel.org>,
Laurent Pinchart <Laurent.pinchart@...asonboard.com>,
Jonas Karlman <jonas@...boo.se>,
Jernej Skrabec <jernej.skrabec@...il.com>,
David Airlie <airlied@...il.com>,
Daniel Vetter <daniel@...ll.ch>,
Inki Dae <inki.dae@...sung.com>,
Jagan Teki <jagan@...rulasolutions.com>,
Marek Szyprowski <m.szyprowski@...sung.com>,
Frieder Schrempf <frieder.schrempf@...tron.de>,
linux-kernel@...r.kernel.org
Subject: [PATCH V3 5/7] drm: bridge: samsung-dsim: Dynamically configure DPHY timing
The DPHY timings are currently hard coded. Since the input
clock can be variable, the phy timings need to be variable
too. Add an additional variable to the driver data to enable
this feature to prevent breaking boards that don't support it.
The phy_mipi_dphy_get_default_config function configures the
DPHY timings in pico-seconds, and a small macro converts those
timings into clock cycles based on the pixel clock rate.
Signed-off-by: Adam Ford <aford173@...il.com>
Tested-by: Chen-Yu Tsai <wenst@...omium.org>
---
drivers/gpu/drm/bridge/samsung-dsim.c | 79 +++++++++++++++++++++++----
include/drm/bridge/samsung-dsim.h | 1 +
2 files changed, 70 insertions(+), 10 deletions(-)
diff --git a/drivers/gpu/drm/bridge/samsung-dsim.c b/drivers/gpu/drm/bridge/samsung-dsim.c
index 2dc02a9e37c0..99642230a54a 100644
--- a/drivers/gpu/drm/bridge/samsung-dsim.c
+++ b/drivers/gpu/drm/bridge/samsung-dsim.c
@@ -18,9 +18,7 @@
#include <linux/media-bus-format.h>
#include <linux/of_device.h>
#include <linux/phy/phy.h>
-
#include <video/mipi_display.h>
-
#include <drm/bridge/samsung-dsim.h>
#include <drm/drm_panel.h>
#include <drm/drm_print.h>
@@ -218,6 +216,8 @@
#define OLD_SCLK_MIPI_CLK_NAME "pll_clk"
+#define PS_TO_CYCLE(PS, MHz) DIV64_U64_ROUND_CLOSEST(((PS) * (MHz)), 1000000000000ULL)
+
static const char *const clk_names[5] = {
"bus_clk",
"sclk_mipi",
@@ -487,6 +487,7 @@ static const struct samsung_dsim_driver_data imx8mm_dsi_driver_data = {
.m_min = 64,
.m_max = 1023,
.min_freq = 1050,
+ .dynamic_dphy = 1,
};
static const struct samsung_dsim_driver_data *
@@ -698,13 +699,50 @@ static void samsung_dsim_set_phy_ctrl(struct samsung_dsim *dsi)
const struct samsung_dsim_driver_data *driver_data = dsi->driver_data;
const unsigned int *reg_values = driver_data->reg_values;
u32 reg;
+ struct drm_display_mode *m = &dsi->mode;
+ int bpp = mipi_dsi_pixel_format_to_bpp(dsi->format);
+ struct phy_configure_opts_mipi_dphy cfg;
+ int clk_prepare, lpx, clk_zero, clk_post, clk_trail;
+ int hs_exit, hs_prepare, hs_zero, hs_trail;
+ unsigned long long clock_in_hz = m->clock * 1000;
if (driver_data->has_freqband)
return;
+ /* The dynamic_phy has the ability to adjust PHY Timing settings */
+ if (driver_data->dynamic_dphy) {
+ phy_mipi_dphy_get_default_config(clock_in_hz, bpp, dsi->lanes, &cfg);
+
+ /*
+ * TODO:
+ * The tech reference manual for i.MX8M Mini/Nano/Plus
+ * doesn't state what the definition of the PHYTIMING
+ * bits are beyond their address and bit position.
+ * After reviewing NXP's downstream code, it appears
+ * that the various PHYTIMING registers take the number
+ * of cycles and use various dividers on them. This
+ * calculation does not result in an exact match to the
+ * downstream code, but it is very close, and it appears
+ * to sync at a variety of resolutions. If someone
+ * can get a more accurate mathematical equation needed
+ * for these registers, this should be updated.
+ */
+
+ lpx = PS_TO_CYCLE(cfg.lpx, clock_in_hz);
+ hs_exit = PS_TO_CYCLE(cfg.hs_exit, clock_in_hz);
+ clk_prepare = PS_TO_CYCLE(cfg.clk_prepare, clock_in_hz);
+ clk_zero = PS_TO_CYCLE(cfg.clk_zero, clock_in_hz);
+ clk_post = PS_TO_CYCLE(cfg.clk_post, clock_in_hz);
+ clk_trail = PS_TO_CYCLE(cfg.clk_trail, clock_in_hz);
+ hs_prepare = PS_TO_CYCLE(cfg.hs_prepare, clock_in_hz);
+ hs_zero = PS_TO_CYCLE(cfg.hs_zero, clock_in_hz);
+ hs_trail = PS_TO_CYCLE(cfg.hs_trail, clock_in_hz);
+ }
+
/* B D-PHY: D-PHY Master & Slave Analog Block control */
reg = reg_values[PHYCTRL_ULPS_EXIT] | reg_values[PHYCTRL_VREG_LP] |
reg_values[PHYCTRL_SLEW_UP];
+
samsung_dsim_write(dsi, DSIM_PHYCTRL_REG, reg);
/*
@@ -712,7 +750,11 @@ static void samsung_dsim_set_phy_ctrl(struct samsung_dsim *dsi)
* T HS-EXIT: Time that the transmitter drives LP-11 following a HS
* burst
*/
- reg = reg_values[PHYTIMING_LPX] | reg_values[PHYTIMING_HS_EXIT];
+ if (driver_data->dynamic_dphy)
+ reg = DSIM_PHYTIMING_LPX(lpx) | DSIM_PHYTIMING_HS_EXIT(hs_exit);
+ else
+ reg = reg_values[PHYTIMING_LPX] | reg_values[PHYTIMING_HS_EXIT];
+
samsung_dsim_write(dsi, DSIM_PHYTIMING_REG, reg);
/*
@@ -728,10 +770,17 @@ static void samsung_dsim_set_phy_ctrl(struct samsung_dsim *dsi)
* T CLK-TRAIL: Time that the transmitter drives the HS-0 state after
* the last payload clock bit of a HS transmission burst
*/
- reg = reg_values[PHYTIMING_CLK_PREPARE] |
- reg_values[PHYTIMING_CLK_ZERO] |
- reg_values[PHYTIMING_CLK_POST] |
- reg_values[PHYTIMING_CLK_TRAIL];
+ if (driver_data->dynamic_dphy) {
+ reg = DSIM_PHYTIMING1_CLK_PREPARE(clk_prepare) |
+ DSIM_PHYTIMING1_CLK_ZERO(clk_zero) |
+ DSIM_PHYTIMING1_CLK_POST(clk_post) |
+ DSIM_PHYTIMING1_CLK_TRAIL(clk_trail);
+ } else {
+ reg = reg_values[PHYTIMING_CLK_PREPARE] |
+ reg_values[PHYTIMING_CLK_ZERO] |
+ reg_values[PHYTIMING_CLK_POST] |
+ reg_values[PHYTIMING_CLK_TRAIL];
+ }
samsung_dsim_write(dsi, DSIM_PHYTIMING1_REG, reg);
@@ -744,8 +793,17 @@ static void samsung_dsim_set_phy_ctrl(struct samsung_dsim *dsi)
* T HS-TRAIL: Time that the transmitter drives the flipped differential
* state after last payload data bit of a HS transmission burst
*/
- reg = reg_values[PHYTIMING_HS_PREPARE] | reg_values[PHYTIMING_HS_ZERO] |
- reg_values[PHYTIMING_HS_TRAIL];
+
+ if (driver_data->dynamic_dphy) {
+ reg = DSIM_PHYTIMING2_HS_PREPARE(hs_prepare) |
+ DSIM_PHYTIMING2_HS_ZERO(hs_zero) |
+ DSIM_PHYTIMING2_HS_TRAIL(hs_trail);
+ } else {
+ reg = reg_values[PHYTIMING_HS_PREPARE] |
+ reg_values[PHYTIMING_HS_ZERO] |
+ reg_values[PHYTIMING_HS_TRAIL];
+ }
+
samsung_dsim_write(dsi, DSIM_PHYTIMING2_REG, reg);
}
@@ -1337,7 +1395,8 @@ static int samsung_dsim_init(struct samsung_dsim *dsi)
samsung_dsim_enable_clock(dsi);
if (driver_data->wait_for_reset)
samsung_dsim_wait_for_reset(dsi);
- samsung_dsim_set_phy_ctrl(dsi);
+ if (!driver_data->has_freqband)
+ samsung_dsim_set_phy_ctrl(dsi);
samsung_dsim_init_link(dsi);
dsi->state |= DSIM_STATE_INITIALIZED;
diff --git a/include/drm/bridge/samsung-dsim.h b/include/drm/bridge/samsung-dsim.h
index a1a5b2b89a7a..76ea8a1720cc 100644
--- a/include/drm/bridge/samsung-dsim.h
+++ b/include/drm/bridge/samsung-dsim.h
@@ -62,6 +62,7 @@ struct samsung_dsim_driver_data {
const unsigned int *reg_values;
u16 m_min;
u16 m_max;
+ bool dynamic_dphy;
};
struct samsung_dsim_host_ops {
--
2.39.2
Powered by blists - more mailing lists