[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]
Message-ID: <20230509161623.GA1765076@hu-bjorande-lv.qualcomm.com>
Date: Tue, 9 May 2023 09:16:23 -0700
From: Bjorn Andersson <quic_bjorande@...cinc.com>
To: Manivannan Sadhasivam <manivannan.sadhasivam@...aro.org>
CC: Bjorn Andersson <andersson@...nel.org>,
Konrad Dybcio <konrad.dybcio@...aro.org>,
Ulf Hansson <ulf.hansson@...aro.org>,
Rob Herring <robh+dt@...nel.org>,
Krzysztof Kozlowski <krzysztof.kozlowski+dt@...aro.org>,
Conor Dooley <conor+dt@...nel.org>,
Andy Gross <agross@...nel.org>, <linux-mmc@...r.kernel.org>,
<devicetree@...r.kernel.org>, <linux-kernel@...r.kernel.org>,
<linux-arm-msm@...r.kernel.org>
Subject: Re: [PATCH 2/2] arm64: dts: qcom: sc8280xp: Add SDC2 and enable on
CRD
On Tue, May 09, 2023 at 12:02:05PM +0530, Manivannan Sadhasivam wrote:
> On Mon, May 08, 2023 at 08:01:36PM -0700, Bjorn Andersson wrote:
> > diff --git a/arch/arm64/boot/dts/qcom/sc8280xp-crd.dts b/arch/arm64/boot/dts/qcom/sc8280xp-crd.dts
[..]
> > + sdc2_default_state: sdc2-default-state {
[..]
> > + card-detect-pins {
> > + pins = "gpio131";
> > + function = "gpio";
> > + drive-strength = <2>;
> > + bias-disable;
>
> Since the card detect is active low, shouldn't the pin be pulled high to avoid
> floating? Or is there an external pull up available on the board?
>
There's an external pull up resistor to vreg_s10b, so there shouldn't be
any reason to pull it internally as well.
Regards,
Bjorn
Powered by blists - more mailing lists