[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]
Message-ID: <ZGN2FKSBkMREujgR@intel.com>
Date: Tue, 16 May 2023 15:24:52 +0300
From: Ville Syrjälä <ville.syrjala@...ux.intel.com>
To: Niklas Schnelle <schnelle@...ux.ibm.com>
Cc: Arnd Bergmann <arnd@...db.de>, Helge Deller <deller@....de>,
Greg Kroah-Hartman <gregkh@...uxfoundation.org>,
Bjorn Helgaas <bhelgaas@...gle.com>,
Uwe Kleine-König
<u.kleine-koenig@...gutronix.de>,
Mauro Carvalho Chehab <mchehab@...nel.org>,
Alan Stern <stern@...land.harvard.edu>,
"Rafael J. Wysocki" <rafael@...nel.org>,
Geert Uytterhoeven <geert@...ux-m68k.org>,
Paul Walmsley <paul.walmsley@...ive.com>,
Palmer Dabbelt <palmer@...belt.com>,
Albert Ou <aou@...s.berkeley.edu>,
linux-kernel@...r.kernel.org, linux-arch@...r.kernel.org,
linux-pci@...r.kernel.org, linux-fbdev@...r.kernel.org,
dri-devel@...ts.freedesktop.org
Subject: Re: [PATCH v4 37/41] fbdev: atyfb: Remove unused clock determination
On Tue, May 16, 2023 at 01:00:33PM +0200, Niklas Schnelle wrote:
> Just below the removed lines par->clk_wr_offset is hard coded to 3 so
> there is no use in determining a different clock just to then ignore it
> anyway. This also removes the only I/O port use remaining in the driver
> allowing it to be built without CONFIG_HAS_IOPORT.
>
> Link: https://lore.kernel.org/all/ZBx5aLo5h546BzBt@intel.com/
> Suggested-by: Ville Syrjälä <ville.syrjala@...ux.intel.com>
> Signed-off-by: Niklas Schnelle <schnelle@...ux.ibm.com>
Reviewed-by: Ville Syrjälä <ville.syrjala@...ux.intel.com>
> ---
> Note: The HAS_IOPORT Kconfig option was added in v6.4-rc1 so
> per-subsystem patches may be applied independently
>
> drivers/video/fbdev/aty/atyfb_base.c | 5 -----
> 1 file changed, 5 deletions(-)
>
> diff --git a/drivers/video/fbdev/aty/atyfb_base.c b/drivers/video/fbdev/aty/atyfb_base.c
> index b02e4e645035..cba2b113b28b 100644
> --- a/drivers/video/fbdev/aty/atyfb_base.c
> +++ b/drivers/video/fbdev/aty/atyfb_base.c
> @@ -3498,11 +3498,6 @@ static int atyfb_setup_generic(struct pci_dev *pdev, struct fb_info *info,
> if (ret)
> goto atyfb_setup_generic_fail;
> #endif
> - if (!(aty_ld_le32(CRTC_GEN_CNTL, par) & CRTC_EXT_DISP_EN))
> - par->clk_wr_offset = (inb(R_GENMO) & 0x0CU) >> 2;
> - else
> - par->clk_wr_offset = aty_ld_8(CLOCK_CNTL, par) & 0x03U;
> -
> /* according to ATI, we should use clock 3 for acelerated mode */
> par->clk_wr_offset = 3;
>
> --
> 2.39.2
--
Ville Syrjälä
Intel
Powered by blists - more mailing lists