linux-kernel - [PATCH v2 4/4] soundwire: qcom: set clk stop need reset flag at runtime

lists.openwall.net		lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC
Open Source and information security mailing list archives

Hash Suite: Windows password security audit tool. GUI, reports in PDF.

[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]

Message-Id: <20230525133812.30841-5-srinivas.kandagatla@linaro.org>
Date:   Thu, 25 May 2023 14:38:12 +0100
From:   Srinivas Kandagatla <srinivas.kandagatla@...aro.org>
To:     vkoul@...nel.org
Cc:     andersson@...nel.org, yung-chuan.liao@...ux.intel.com,
        pierre-louis.bossart@...ux.intel.com, sanyog.r.kale@...el.com,
        linux-arm-msm@...r.kernel.org, alsa-devel@...a-project.org,
        linux-kernel@...r.kernel.org,
        Srinivas Kandagatla <srinivas.kandagatla@...aro.org>
Subject: [PATCH v2 4/4] soundwire: qcom: set clk stop need reset flag at runtime

WSA Soundwire controller needs an full reset if clock stop support
is not available in slave devices. WSA881x does not support clock stop
however WSA883x supports clock stop.

Make setting this flag at runtime to address above issue.

Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@...aro.org>
---
 drivers/soundwire/qcom.c | 13 ++++---------
 1 file changed, 4 insertions(+), 9 deletions(-)

diff --git a/drivers/soundwire/qcom.c b/drivers/soundwire/qcom.c
index 1d2a105cb77f..b6c3fadc9090 100644
--- a/drivers/soundwire/qcom.c
+++ b/drivers/soundwire/qcom.c
@@ -617,10 +617,14 @@ static int qcom_swrm_enumerate(struct sdw_bus *bus)
 
 		sdw_extract_slave_id(bus, addr, &id);
 		found = false;
+		ctrl->clock_stop_not_supported = false;
 		/* Now compare with entries */
 		list_for_each_entry_safe(slave, _s, &bus->slaves, node) {
 			if (sdw_compare_devid(slave, id) == 0) {
 				qcom_swrm_set_slave_dev_num(bus, slave, i);
+				if (slave->prop.clk_stop_mode1)
+					ctrl->clock_stop_not_supported = true;
+
 				found = true;
 				break;
 			}
@@ -1623,15 +1627,6 @@ static int qcom_swrm_probe(struct platform_device *pdev)
 	pm_runtime_set_active(dev);
 	pm_runtime_enable(dev);
 
-	/* Clk stop is not supported on WSA Soundwire masters */
-	if (ctrl->version <= SWRM_VERSION_1_3_0) {
-		ctrl->clock_stop_not_supported = true;
-	} else {
-		ctrl->reg_read(ctrl, SWRM_COMP_MASTER_ID, &val);
-		if (val == MASTER_ID_WSA)
-			ctrl->clock_stop_not_supported = true;
-	}
-
 #ifdef CONFIG_DEBUG_FS
 	ctrl->debugfs = debugfs_create_dir("qualcomm-sdw", ctrl->bus.debugfs);
 	debugfs_create_file("qualcomm-registers", 0400, ctrl->debugfs, ctrl,
-- 
2.21.0