| lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
|
Open Source and information security mailing list archives
| ||
|
Message-ID: <af6840d6-8ceb-abf4-bde2-be4f8befe94d@microchip.com>
Date: Wed, 14 Jun 2023 08:51:33 +0000
From: <Claudiu.Beznea@...rochip.com>
To: <pranavi.somisetty@....com>, <davem@...emloft.net>,
<edumazet@...gle.com>, <kuba@...nel.org>, <pabeni@...hat.com>,
<robh+dt@...nel.org>, <krzysztof.kozlowski+dt@...aro.org>,
<Nicolas.Ferre@...rochip.com>
CC: <git@....com>, <michal.simek@....com>, <harini.katakam@....com>,
<radhey.shyam.pandey@....com>, <netdev@...r.kernel.org>,
<linux-kernel@...r.kernel.org>, <devicetree@...r.kernel.org>
Subject: Re: [PATCH net-next v4 2/2] net: macb: Add support for partial store
and forward
On 13.06.2023 08:43, Pranavi Somisetty wrote:
> EXTERNAL EMAIL: Do not click links or open attachments unless you know the content is safe
>
> From: Maulik Jodhani <maulik.jodhani@...inx.com>
>
> When the receive partial store and forward mode is activated, the
> receiver will only begin to forward the packet to the external AHB
> or AXI slave when enough packet data is stored in the packet buffer.
> The amount of packet data required to activate the forwarding process
> is programmable via watermark registers which are located at the same
> address as the partial store and forward enable bits. Adding support to
> read this rx-watermark value from device-tree, to program the watermark
> registers and enable partial store and forwarding.
>
> Signed-off-by: Maulik Jodhani <maulik.jodhani@...inx.com>
> Signed-off-by: Pranavi Somisetty <pranavi.somisetty@....com>
Reviewed-by: Claudiu Beznea <claudiu.beznea@...rochip.com>
> ---
> Changes v2:
> 1. Removed all the changes related to validating FCS when Rx checksum offload is disabled.
> 2. Instead of using a platform dependent number (0xFFF) for the reset value of rx watermark,
> derive it from designcfg_debug2 register.
> 3. Added a check to see if partial s/f is supported, by reading the
> designcfg_debug6 register.
>
> Changes v3:
> 1. Followed reverse christmas tree pattern in declaring variables.
> 2. Return -EINVAL when an invalid watermark value is set.
> 3. Removed netdev_info when partial store and forward is not enabled.
> 4. Validating the rx-watermark value in probe itself and only write to the register
> in init.
> 5. Writing a reset value to the pbuf_cuthru register before disabing partial store
> and forward is redundant. So removing it.
> 6. Removed the platform caps flag.
> 7. Instead of reading rx-watermark from DT in macb_configure_caps,
> reading it in probe.
> 8. Changed Signed-Off-By and author names on this patch.
>
> Changes v4:
> 1. Removed redundant code and unused variables.
> 2. When the rx-watermark value is invalid, instead of returning EINVAL,
> do not enable partial store and forward.
> 3. Change rx-watermark variable's size to u32 instead of u16.
> ---
> drivers/net/ethernet/cadence/macb.h | 12 +++++++++++
> drivers/net/ethernet/cadence/macb_main.c | 27 ++++++++++++++++++++++++
> 2 files changed, 39 insertions(+)
>
> diff --git a/drivers/net/ethernet/cadence/macb.h b/drivers/net/ethernet/cadence/macb.h
> index 14dfec4db8f9..39d53117a8ce 100644
> --- a/drivers/net/ethernet/cadence/macb.h
> +++ b/drivers/net/ethernet/cadence/macb.h
> @@ -82,6 +82,7 @@
> #define GEM_NCFGR 0x0004 /* Network Config */
> #define GEM_USRIO 0x000c /* User IO */
> #define GEM_DMACFG 0x0010 /* DMA Configuration */
> +#define GEM_PBUFRXCUT 0x0044 /* RX Partial Store and Forward */
> #define GEM_JML 0x0048 /* Jumbo Max Length */
> #define GEM_HS_MAC_CONFIG 0x0050 /* GEM high speed config */
> #define GEM_HRB 0x0080 /* Hash Bottom */
> @@ -343,6 +344,10 @@
> #define GEM_ADDR64_SIZE 1
>
>
> +/* Bitfields in PBUFRXCUT */
> +#define GEM_ENCUTTHRU_OFFSET 31 /* Enable RX partial store and forward */
> +#define GEM_ENCUTTHRU_SIZE 1
> +
> /* Bitfields in NSR */
> #define MACB_NSR_LINK_OFFSET 0 /* pcs_link_state */
> #define MACB_NSR_LINK_SIZE 1
> @@ -509,6 +514,8 @@
> #define GEM_TX_PKT_BUFF_OFFSET 21
> #define GEM_TX_PKT_BUFF_SIZE 1
>
> +#define GEM_RX_PBUF_ADDR_OFFSET 22
> +#define GEM_RX_PBUF_ADDR_SIZE 4
>
> /* Bitfields in DCFG5. */
> #define GEM_TSU_OFFSET 8
> @@ -517,6 +524,8 @@
> /* Bitfields in DCFG6. */
> #define GEM_PBUF_LSO_OFFSET 27
> #define GEM_PBUF_LSO_SIZE 1
> +#define GEM_PBUF_CUTTHRU_OFFSET 25
> +#define GEM_PBUF_CUTTHRU_SIZE 1
> #define GEM_DAW64_OFFSET 23
> #define GEM_DAW64_SIZE 1
>
> @@ -1283,6 +1292,9 @@ struct macb {
>
> u32 wol;
>
> + /* holds value of rx watermark value for pbuf_rxcutthru register */
> + u32 rx_watermark;
> +
> struct macb_ptp_info *ptp_info; /* macb-ptp interface */
>
> struct phy *sgmii_phy; /* for ZynqMP SGMII mode */
> diff --git a/drivers/net/ethernet/cadence/macb_main.c b/drivers/net/ethernet/cadence/macb_main.c
> index 41964fd02452..7d023b92b169 100644
> --- a/drivers/net/ethernet/cadence/macb_main.c
> +++ b/drivers/net/ethernet/cadence/macb_main.c
> @@ -2617,6 +2617,9 @@ static void macb_reset_hw(struct macb *bp)
> macb_writel(bp, TSR, -1);
> macb_writel(bp, RSR, -1);
>
> + /* Disable RX partial store and forward and reset watermark value */
> + gem_writel(bp, PBUFRXCUT, 0);
> +
> /* Disable all interrupts */
> for (q = 0, queue = bp->queues; q < bp->num_queues; ++q, ++queue) {
> queue_writel(queue, IDR, -1);
> @@ -2770,6 +2773,10 @@ static void macb_init_hw(struct macb *bp)
> bp->rx_frm_len_mask = MACB_RX_JFRMLEN_MASK;
>
> macb_configure_dma(bp);
> +
> + /* Enable RX partial store and forward and set watermark */
> + if (bp->rx_watermark)
> + gem_writel(bp, PBUFRXCUT, (bp->rx_watermark | GEM_BIT(ENCUTTHRU)));
> }
>
> /* The hash address register is 64 bits long and takes up two
> @@ -4923,6 +4930,7 @@ static int macb_probe(struct platform_device *pdev)
> phy_interface_t interface;
> struct net_device *dev;
> struct resource *regs;
> + u32 wtrmrk_rst_val;
> void __iomem *mem;
> struct macb *bp;
> int err, val;
> @@ -4995,6 +5003,25 @@ static int macb_probe(struct platform_device *pdev)
>
> bp->usrio = macb_config->usrio;
>
> + /* By default we set to partial store and forward mode for zynqmp.
> + * Disable if not set in devicetree.
> + */
> + if (GEM_BFEXT(PBUF_CUTTHRU, gem_readl(bp, DCFG6))) {
> + err = of_property_read_u32(bp->pdev->dev.of_node,
> + "cdns,rx-watermark",
> + &bp->rx_watermark);
> +
> + if (!err) {
> + /* Disable partial store and forward in case of error or
> + * invalid watermark value
> + */
> + wtrmrk_rst_val = (1 << (GEM_BFEXT(RX_PBUF_ADDR, gem_readl(bp, DCFG2)))) - 1;
> + if (bp->rx_watermark > wtrmrk_rst_val || !bp->rx_watermark) {
> + dev_info(&bp->pdev->dev, "Invalid watermark value\n");
> + bp->rx_watermark = 0;
> + }
> + }
> + }
> spin_lock_init(&bp->lock);
>
> /* setup capabilities */
> --
> 2.36.1
>
Powered by blists - more mailing lists